Question about Harley Davidson FXDL Dyna Low Rider Motorcycles

1 Answer

I had to load my bike last night in the bed of a pick up and as i was loading it i disconnected these wire and now my bike wont start and the battery is makeing this clicking noise.The wires are red,black and green and and were pulled out of a plug dont no much about this problem but my buddy said it has something to do with my fuel in take. What i need to no is where the wires go it is numbered 1,2 and three what order do the wires go such as red 1 green 2 and black 3 would love to solve this problem right now. Th e big is 1993 harley davidson low rider custom

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,689 Answers

Hi nicholas,

thanksyou for using fixya.

those wired are for your bikes starter relay and starter solenoid, not for the fuel, because if it is, you should here your bike trying to start when you make it do so.

As you can see, the wires are color coded, but this is a custom unit, you may have the operation manual but the service manual may say otherwise.

on page 80 or later part of the document below, you will see where to put those wires back and get your bike going without taking it to the repair shop that may cost you about 150$

http://www.originalanleitungen.de/shop/harleydavidson-evolution-9198-repair-manual-p-10756-1.html

here are some good stuff about wiring as well.

http://www.dumbassbiker.com/store/page4.html

hope this helps,

regards,

voodoo

Posted on Jun 14, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Xt660x 2005 moto


Did you just charge battery or did you have it load tested? I would bring battery in to a local parts store. They will most likely load test it for free. I would definetly start there. If battery is ok, then we can diagnose from there.

Feb 28, 2014 | Motorcycles

1 Answer

Zx6r 2004. Bike ran great for two months. Went out to dinner last night and came out to my bike not starting. Trailered it home, started when taking off trailer. Went for a 15 minute ride and parked it....


Hi, Matt it saddens me to inform you that you have to put on your Battery Priest Robe and prepare yourself for the Ceremonial "LOAD TEST" but before you begin, maintenance type batteries must be topped off with distilled Holy Water and all batteries must present their terminals to the battery charging altar to receive the electrical infusion of Holy Ions until they have reached a 100% full charge of 12.5 volts or better.
Below is a quick and easy test to see if your battery is in good condition or needs Last Rites and must be replaced.
1. Start by disconnecting the spark plug cables.
2. Adjust voltmeter to DC volts 20-volt range
3. Place the voltmeter leads to the battery terminals.
4. Turn the run/off switch to run.
5. Turn the ignition switch on and press the starter button.
6. Watch the voltmeter as your engine turns over for 15 seconds.
7. If the voltage drops below 9.5 volts, the battery is faulty and must be replaced.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
ZX6R 636 Bike won start
Kawasaki NINJA ZX6R My bike won start Starter problem or discharged battery
Kawasaki Ninja ZX6R Service Manual
OEM Parts for Kawasaki
Kawasaki Ninja ZX 6R Owner Manual
How to Tell if Your Battery is Bad in 3 Easy Steps

May 18, 2017 | 2007 kawasaki Ninja ZX6R

1 Answer

Starter clicks but wont turn over the battery is good though


Usually, the battery proves to be the culprit in most cases like this. I know you said it was good but did you run a "load test" on the battery? A battery, when checked with a regular volt meter, can show 12.3 volts and still not start the bike. Take the battery out and take it to an automotive parts store. Ask them to do a load test on the battery. If they say it's good, then we'll move on. With the battery back in the bike, disconnect the small single wire that plugs onto a spade connector on the back of the starter. Connect a voltmeter or a test light to the wire. Turn the ignition switch on and press the start button. If you show voltage, the starter relay is good. If not, replace the starter relay. If you show battery voltage, the large contacts inside the solenoid of the starter may need to be replaced. Disconnect the negative battery cable from the battery. Take the 5-sided plate off right where the single small wire plugged onto the starter. Once you get the plate off, pull the plunger and the long spring out of the solenoid. Look into the solenoid and you'll see two large contacts. If they look burned and uneven across the face, you may need to replace them. You can get replacement parts from either a dealer or on the aftermarket. Usually you can replace these contacts without having to remove the starter. The nuts holding the battery cables to the starter are 14mm.

Good Luck
Steve

Aug 04, 2011 | Harley Davidson XLH 1000 Sportster...

1 Answer

Laptop wont stay on


ok. first insert the power cable and remove the battery and try starting the computer. If it still goes off when windows is loading then its a virus and reinstalling the windows would be the solution but if it continues to windows then its from the battery.

Aug 02, 2010 | Averatec Sotec 3120X, 3120V hard drive...

1 Answer

FI lights stays on, popped on last night while


FI means fuel injection and your bikes computer is picking up a problem and letting you know that maintenance has to be performed for peak efficiency. you can go to the dealer and have them read the codes and you can decide whose going to do the repairs. or just try some Seafoam, buy it at Autozone pour 1/3 to 2 gallons fuel, it wont hurt it, and ride it around getting on every once in awhile, for about 10 to 15 miles, then you might have to disconnect the battery to reset the light...these are just the cheapest things to try. let me get some feedback on this thanks!

Apr 03, 2010 | 2001 Honda CBR 929 RR Fireblade

1 Answer

Replaced coils, will idle,but wont stay running under load, also have to keep charging battery


because the bike is so new i wouldnt suspect the stator i would invest in a battery, a good battery is crucial for bikes. once you get a good battery in it check the voltage at the terminals when the bike is running(you should see around 13 to 14 volts). you can have the battery load tested at a batteries plus or an auto part store so you dont waste your money, but once you kill a bike battery there pretty much junk. the stators in motorcycles barely put out enough power to run the bike and pretty much trickle charge the battery. they rely on the battery to pick up the slack. get a battery from walmart there cheap and ive had one in my bike for two years and its fine, stay away from the over priced ones they dont do anything but slim down your wallet.

Sep 28, 2009 | 2005 Suzuki GSX 600 F (Katana)

2 Answers

Electrical problem


Suzukis aren't the only bikes with this problem. Certain Hondas are notorious for stator shorting. If you can get the temperature down you will be able to get MANY more miles out of the stator. I'm referring to the stator temperature. If you have any heavy load accessories (extra lights, boom box, etc.) you will need to get rid of them. If the battery is ancient it will really load up the alternator. Check out the rectifier. My last BMW had a small daylight running headlight that drew about a third of the night time headlight wattage. If all is well electrically, install an aftermarket oil cooler on the engine.

Nov 10, 2008 | 1983 Suzuki Gs 550 L

1 Answer

Spin Option


The problems posted by kim875 and kirsty2 all seem to be the result of faulty signals from the electronic board. This seems to be a real problem with this model machine. I would try to get board replaced under warranty , if at all possible.

Dec 05, 2007 | Maytag Neptune FAV6800AW Top Load Washer

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Mike

Level 3 Expert

4341 Answers

yadayada
yadayada

Level 3 Expert

77186 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...