Question about Ducati Monster 696 Motorcycles

1 Answer

When try to start it fails

When try to leave it stops working

Posted by Anonymous on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Ducati Master
  • 43,120 Answers

Hi, Anonymous for more information about your question and valuable free downloads that you will need please visit the websites below. Good luck and have a nice day.
696 Stalling
Free Ducati Motorcycle Service Manuals for download
Ducati OEM Parts Fiche Lookup and Online Ordering
Ducati Maintenance

Posted on Feb 09, 2016


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 420 38 MTD, runs fine for a while then stops.

I suspect that you have a problem coil /ignition system that is failing when it gets hot
if it runs for a while , I would be leaving the carby last as it is working for a while and that is not a carby problem indication

Nov 21, 2016 | Cars & Trucks

1 Answer

Seat Leon poor starting, can you help?

Have you checked that throttle body blade is clean and closing all the way? Have you checked for dirty idle air control valve?

Mar 04, 2015 | Seat Leon Cars & Trucks

1 Answer

How can I fix my PC, Acer with NMD processor, whenever I try to power it on it fails. I have tried to check the power supply but it seems ok.

Sometimes the on board battery that keeps the BIOS going when the computer has no power can fail. This can stop the computer from starting.
Open it up and look for the battery,get the number, get a new one (should be a couple of bucks) and then change it. Leave power on otherwise it will reset BIOS. What I mean is leave it plugged in and power on to do it even though the computer is not starting.

Dec 29, 2014 | Acer Computers & Internet

1 Answer

Electrical stops when trying to start truck

Have a load test done on the battery as you have a failing cell in the battery.

May 23, 2013 | Toyota Tacoma Cars & Trucks

1 Answer

Engine doens't start

could be the fuel pump or plugged fuel filters.

May 15, 2013 | Cars & Trucks

1 Answer

Ac/heater not working radio stopped working 2004 saab 93

I've had this happen before too... TRY removing the battery cable (Negative Side only)... and leave it off for ~60seconds.. then reconnect.

Try starting the card and using the A/C and see if it's restored. I had similar issue when my battery was failing, and that fixed it. I hope it does for you.

FYI, IIRC 10 or 12mm wrench will do the job.

Oct 19, 2012 | 2004 Saab 9-3

1 Answer

2002 vue v6...starts and runs well however when I stop , shut off the engine, then try to start after half hour , it wont start

Lookfor a light on the dash that says SECURITY or ANTITHEFT. If you see this light, that is a sign of a failed or failing antitheft system, which will disable your vehicle. This link explains

Nov 06, 2011 | 2002 Saturn VUE

1 Answer

Lap top will not turn on

Hmm. I wouldn't say it was the solution to every acer aspire laptop problem but batteries fail and sometimes stop it from functioning properly. So try just powering it with the mains

Mar 20, 2009 | ASUS Computers & Internet

1 Answer

Installed new update to fix freezing problem - created new one

I had the same problem. Mine originally stopped at 23/92 files. Then after a cool night, I started it again in the morning and got 91/92 files loaded before it started to fail again. I left the disk in and after about 20 fails in a row, it finally loaded!!! Recommend you just leave it in there and it should work. good luck

Mar 03, 2009 | Pioneer AVIC-Z2 Car DVD Player

1 Answer

Leaving microwave on pause

Unless the control electronics fail, leaving the oven paused won't hurt anything but it will enable someone unfamiliar with to restart it with nothing in the cavity and this can damage the magnetron. Unless you are just checking the food for progress, I wouldn't recommend leaving it paused and 'armed.' 

Dec 28, 2008 | Kenmore 63252 Microwave Oven

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ducati Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers


Level 1 Expert

36 Answers


Level 3 Expert

76682 Answers

Are you a Ducati Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides