Question about 2003 Harley Davidson FLHTCUI Electra Glide Ultra Classic

1 Answer

Gas tank How do I remove two fuel lines from the gas tank?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Harley Davidson Master
  • 42,952 Answers

Hi Wayne, one has a quick release coupling thats probably going to be under some fuel pressure so be prepared for some spray back and the other is either worm or crimp clamp. Good luck

Posted on May 07, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 7 Answers

SOURCE: 87 sportster fuel line gets air locked

The gas tank breather vent is clogged. Check around your cap and make sure the vent hose under the tank is not pinched. Your getting a vapor lock.

Posted on Jan 21, 2009

landsend
  • 1066 Answers

SOURCE: Leaking fuel line

it may be the tank fitting...or the hose or the clamps.

Posted on Mar 13, 2009

tundrajet
  • 80 Answers

SOURCE: removing harley davidson ultra classic gas tank

Drain the fuel either by siphening or removing the cross over tube at the front of the tank and letting it drain that way or just block off those cross over lines and leave the fule in the tank for removal.

0) remove seat
1) drain fuel
2) undo cross over line (bottom front of gas tank.
3) shut off pet **** and remove fuel line from pet ****.
4)there should only be 2 bolts holding the tank on, one at the top front of the tank and one at the back of the tank.

All in all a pretty easy (but possibloy messy) job.

Posted on Jun 06, 2009

  • 269 Answers

SOURCE: removing gas tank on harley flhtci

remove seat, remove console on top of tank, disconnect wiring from console to tank, disconnect vent line if present, disconnect fuel line on tank, disconnect fuel gauge (up under tank on left side, 3 wires, 4 wire connector, wires are yellow, orange, and black), remove bolt at rear of tank, remove two side bolts up front under tank (coil bracket is there also, carefully cut clamp on cross over hose located up front under tank.
This works better with three hands remove one side of cross over hose, fuel will flow freely so the extra hands are good at "plugging" the hose and the tank. Gently remove tank tilting front of tank as much as you can till you get it clear of the frame, while still tilted at a steep angle put the cross over hose back on.
To make things easier drain all fuel out of tank before reversing the process to reinstall tank. Hope this helps.

JP

Posted on Aug 17, 2009

  • 109 Answers

SOURCE: 2001 Harley Davidson Road King

My guess. One hose is feed to fuel rail one hose is return from rail and one would be a vent of some kind.

Posted on Mar 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I disconnect gas tank from the line that fills the tank?


How to fix a leaking gas tank - YouTube

? 7:20
www.youtube.com/watch?v=Luj6qPuxIPM
Mar 10, 2013 - Uploaded by FastestIntegra How to clean and fix a leaking gas tank. ... i repair rusted gas tanks with fiberglass putty, works really well, i have a car that i fixed 7 years ago ...

Sep 27, 2015 | Cars & Trucks

2 Answers

How to remove gas tank on 2003 ultra classic electric glide


1. Drain fuel tank as follows:
Obtain a short section of hose with a 5/16 inch (7.9 mm) I.D.
Insert bolt in one end of hose and install hose clamp to
ensure that end is securely plugged. Using a side cutters, cut
clamp from one end of crossover hose beneath fuel tank.
Quickly replace crossover hose on fuel tank fitting with open
end of short hose while directing flow of gasoline from free
end of crossover hose into suitable container.
2. Remove seat.
3. Purge the fuel supply line of high pressure gas. Proceed
as follows:
a. Remove the 15 amp fuel pump fuse.
b. Start the engine and allow the vehicle to run.
c. When the engine stalls, operate starter for 3 seconds
to remove remaining fuel from fuel lines.
4. Unthread bolt and remove battery negative cable (black)
from battery negative (-) terminal.
5. Carefully cut anchored cable strap securing main harness
bundles, console pod conduit, fuel level sender/fuel pump conduit, and fuel vapor vent tube to left side of frame backbone.
6. Open fuel door on console. Remove two Allen head
screws inboard of rubber bumpers. These screws
secure console to clip nuts on the canopy bracket.
7. Remove Allen head screw to detach flange at rear of
console from clip nut on fuel tank weldment.
8. Lay a clean shop towel on forward part of rear fender.
9. Remove filler cap from neck of fuel tank. Remove console
and lay upside down on shop towel. Reinstall filler cap.
10. At top of canopy, depress button on socket side of 3-
place Mini-Deutsch connector to release fuel tank harness.
11. Gently pry fuel vapor vent tube from fitting on filler neck
of fuel tank. Exercise caution to avoid pulling fitting from
filler neck.
12. Locate quick-connect fitting on left side of fuel tank. Pull
up on chrome sleeve and pull down on fuel supply line
fitting to disconnect.
13. Remove two fuel tank front mounting bolts (with flat
washers) from left and right side of frame. Remove bolt
(with flat washer) to free rear of fuel tank from frame
backbone.
14. Remove fuel tank from vehicle.

Jun 29, 2014 | 2003 Harley Davidson FLHTCUI Electra Glide...

1 Answer

Need 2 know how 2 remove gas tank so i can replace fuel pump


TO REMOVE FUEL TANK FIRST YOU NEED TO MAKE SURE FUEL SYSTEM BEEN DEPRESSURIZE. YOU CAN REMOVE FUEL PUMP RELAY LET CAR RUN UNTIL DIES LACK OF GAS. THEN CRANK ENGINE OVER FEW TIMES MAKE SURE ALL GAS OUT OF FUEL LINES. THEN REMOVE FUEL CAP THEN DRAIN FUEL TANK.YOU CAN BUY A SIPHON AT ANY AUTO PARTS STORES, DONT SIPHON GAS WITH MOUTH CAN BE VERY FATAL.ONCE FUEL OUT OF TANK. SAFELY RAISE SUPPORT VECHICLE ON JACK STANDS, MAKE SURE VECHICLE SITTING ON LEVEL SOLID GROUND. LOOK UNDERNEATH VECHICLE REMOVE FUEL FILTER DISCONNECT FUEL PUMP ELECTRICAL WIRE CONNECTOR, THEN REMOVE EVAP CANISTER, VENT SOLENOID, AND VAPOR LINES DISCONNECT FUEL LINES, THEN REMOVE THE LOWER FILLERHOSE GOING INTO FUEL TANK. LOOK AROUND TANK YOU PROBABLY HAVE TO REMOVE HEAT SHIELD AROUND GAS TANK AND REMOVE EXHAUST PIPES IF IN THE WAY. GET A LARGE FLOOR JACK AND THE PLACE A PIECE WOOD ON FLOOR JACK SADDLE.THEN RAISE FLOOR JACK JUST ENOUGH SUPPORT FUEL TANK THEN REMOVE FUEL TANK SUPPORT STRAPS THEN SLOWLY LET DOWN THE FUEL TANK. TO FINISH DISCONNECTING FUEL LINES AND REMOVING FUEL PUMP. BE SURE AFTER YOU DEPRESSURIZE FUEL SYSTEM TURN OFF RADIO AND REMOVE THE NEGATIVE BATTERY CABLE.

Aug 04, 2011 | Chevrolet Cavalier Cars & Trucks

1 Answer

Installed new fuel pump because car had old gas in tank. removed tank and completly drained it. replaced tank and installed new fuel pump and fuel filter. put about 6 gallons of gas in car. have tried to...


Okay, you need to make sure the fuel pump is getting power and that you have the lines hooked up correctly. Also, when you replace fuel pumps you need to remove the air cleaner and use starter fluid to get the engine started.

Jul 09, 2011 | Nissan Z Cars & Trucks

1 Answer

Someone put sugar in my 1997 plymouth voyager gas tank. How do I remove the gas tank to clean it ?


TO REMOVE FUEL TANK YOU FIRST RELIEF FUEL PRESSURE.THEN YOU RAISE THE VECHICLE AND SUPPORT ON JACK STANDS.THEN YOU DRAIN FUEL OUT OF FUEL TANK.YOU CAN GO TO ANY AUTO PARTS STORE BUY A SIPHON.DONT SIPHON GASOLINE WITH YOUR MOUTH.SWALLOWING GAS AND FUMES COULD BE FATAL.WHEN ALL FUEL OUT THE FUEL TANK.REMOVE THE FUEL FILLER.DISCONNECT THE ELECTRICAL WIRING TO FUEL TANK.THEN DISCONNECT ALL THE HOSES FROM THE FUEL TANK.PLACE A LARGE FLOOR JACK CENTER OF THE FUEL TANK.PLACE A PIECE PLY WOOD OVER FLOOR JACK LIFTING SADDLE TO KEEP FROM PUTTING A HOLE IN FUEL TANK.START RAISING FLOOR JACK UNTIL SADDLE TOUCH GAS TANK JUST ENOUGH TO HOLD TANK IN PLACE.THEN YOU REMOVE FUEL PUMP SUPPORT STRAP BOLTS DROP FUEL TANK DISCONNECT FUEL SUPPLY AND RETURN HOSES AND DISCONNECT FUEL VAPOR LINES FROM PRESSURE RELIEF ROLLOVER VALVE.THEN REMOVE TANK.IF HAVE TROUBLE REMOVING FILLER TUBE AT GAS TANK SPRAY WD40 AROUND WHERE FILLER TUBE GOES TO GAS TANK LOOSEN THE CLAMPS AND USE LARGE VISE GRIPS WORK FILLER TUBE HOSE AWAY FROM FUEL TANK SPRAY WD40 INTO IT SLIDE ON OFF.WHEN YOU GET FUEL TANK OFF USE A FUEL PUMP MODULE LOCK RING TOOL TURN LOCK RING COUNTERCLOCK WISE.IF YOU DONT HAVE THE FUEL PUMP LOCK RING TOOL.YOU CAN USE A HAMMER AND BRASS DRIFT OR A PLASTIC DRIFT DONT USE NO METAL DRIFTS OR PUNCH YOU WILL MAKE A SPARK AND HAVE EXPLOSION FROM GAS FUMES BE EXTRA CAREFUL.REPLACE FUEL PUMP SOCK AND FUEL SUPPLY LINES IF STOPPED UP AND REPLACE FUEL FILTER.PUT EVERY THING BACK IN VISA VERSA.IF ALL GOES WELL. GO TO AUTO PARTS STORE BUY A GAS CAP WITH A LOCK SO WHO EVER PUT SUGAR IN YOUR GAS WONT BE ABLE TO TRY IT AGAIN GOOD LUCK.

Oct 23, 2010 | 1997 Plymouth Grand Voyager

1 Answer

Have a weedeater gt1 15 trimmer how do u get the gas tank apart to repair the gas tubing


You will not need to remove the gas tank or take the gas tank apart. Follow these instructions:
1. Disconnect the fuel line from the carburetor. You may need to cut the line pull it off.
2. Push the fuel line back through the gas tank. At the end of the fuel line is the fuel filter/weight that should be moving around within the gas tank.
3. You should be able to pull the filter/weight out of the fuel tank through the neck using a needle nose pliers. Insure the fuel filter is cleaned out before you re-assemble.

Note: The fuel line that you use as a replacement must be the same diameter of the fuel line you are removing. If you cannot find the fuel line at your local mower shop, try Lowes Hardware as they do stock it in the lawnmower section.

To reassemble: Take about 7 inches of correct fuel line and cut a 45 degree angle cut at one end. That end is threaded back through the tank through the small hole. Push as far as you can and then reach in and pull it to the neck. Cut the straight, attach the filter/weight and pull the line back through.

Sep 28, 2010 | Poulan Garden

1 Answer

Leaking gas tank


remove fuel filler hoses, support tank, remove fuel tank straps. lower tank to access fuel lines. disconnect lines and connectors.remove tank dump fuel in suitable container and dispose of properly

Nov 15, 2009 | 1990 Dodge Ram

1 Answer

Stihl chainsaw


Hi

First remove the cover,air filter and the carburator.Then remove the gas tank cap and the fuel filter from inside of gas tank,at the end of fuel line.Take off the fuel line from the hole of the gas tank(at the top),replace the fuel line,put all back together and start the engine.

best regards savumihai71

Feb 13, 2009 | Husqvarna Chain Saw 20" Bar

1 Answer

Fuel Pump


its in the gas tank disconnect the fuel line try to empty the gas tank because its easyer to handle disconnect the gas line and strap put the gas tank down on top of gas tank remove the lock and there it is good luck pierre

Sep 01, 2008 | 2000 Dodge Grand Caravan

3 Answers

I've got bad gas and need to know the easiest way to drain the tank or otherwise fix the problem.


The tank will have to be removed from the vehicle and completely dried out.Gas tanks no longer have drain plugs as they did 50 years ago.Remove the fuel pump from the top of the tank,and thoroughly clean the tank with brake cleaner and compressed air and let air dry for awhile.The fuel pump and filter will need to be replaced with new,and after all the reinstallation,the fuel line must be disconnected at the engine,and the line flushed with new,clean gasoline as well as the return fuel line.Spark plugs will have to be replaced also.

Aug 12, 2008 | 2003 Toyota Matrix

Not finding what you are looking for?
2003 Harley Davidson FLHTCUI Electra Glide Ultra Classic Logo

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4535 Answers

Mike

Level 3 Expert

4340 Answers

yadayada
yadayada

Level 3 Expert

76630 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...