Question about 1992 Yamaha FZR 600

1 Answer

Digital ignitor I need a new digital ignitor, I don't wanna buy a new one and I'm morebof a Honda car builder and know tons of parts are innerchangeable and was wondering if I could do that with my c.d.I, ecu, ecm?

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

As the ecu is designed to have the correct power curve and rev limiter for each motor. unless you can find ecu from similar engine take into account rev range or you may risk serious damage, but it is possible.

Posted on Mar 21, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Is an 81 and a98 honda civic motor innerchangable

Part wise for the two engines, no. As for an engine swap, yes a 98 will fit in an 81 and other way around. But this will always include slight modifications to engine and transmission mounts. You will need to take the ECU and fuel system from the 98 . it's not an easy task.

Sep 21, 2015 | Honda Cars & Trucks

1 Answer

Driving my honda 2001 crv and it just lost power and now wont start

I would check the Ignitor. This is a common problem, they often become heat saturated which causes a failure to deliver spark. Do not pull a plug and ground it unless you have a resistive spark tester. If you do you may end up with a fried ignitor if you don't already have one

Aug 23, 2012 | Honda Accord Cars & Trucks

1 Answer

Ignitor wont glow

It might be cracked or broken. I would carefully remove it (don't drop it), and put an ohmmeter across the contacts. You should get a reading of 500 ohms or less, but not 0 (meter leads shorted to each other).

If the reading is higher, either you don't have the meter leads actually touching the terminals, or the part faulty.

But if it's not faulty, then the ignitor's power source is not feeding it electricity. In this case, the heat sensing circuit may be bad, usually caused by a faulty thermostatic device.

There also may be a loose wire connection inside the unit.

You can test all of the above with a voltmeter. Put the leads, one in each terminal on the ignitor socket, and have someone else start the dryer.

It probably won't work with the ignitor removed, but there should be a slight jump on the volt meter if the circuit is working properly.

I usually don't bother with all that. There's far fewer different ignitor elements than there are appliances that use them, so you can almost always find the one you need in stock, in town.

Take the old one along. Some parts distributors will test the one you bring in, because if they didn't, they wouldn't know what's going on.

If the ignitor is good, they usually know which part failed, because parts guys know which parts fail most on any appliance.

Jul 22, 2012 | LG DLG5988 Gas Dryer

1 Answer

How to install a Xenon Ignitor for BMW 325CI convertible

don't buy headlight ignition alone It is hard to install,so you should buy headlight unit

Mar 30, 2012 | 2003 BMW 325

1 Answer

Had new kitchen worktops fitted day later got badly scratched with builder sliding tool box across it now he has scribed the scratches with half a bottle of cream jif now not sure how to fix

Don't accept it. It is the builders responsibility. Just don't pay until you get a new benchtop or a payment reduction equal to that.

Slight scratches in laminate can sometimes be fixed (almost) with mild cut car polish, but I can't see you even need to accept that, it was pure carelessness.

Dec 06, 2011 | Home

1 Answer

Broiler w/new igniter does not work, gas feed ok

WB13K21 is the ignitor that goes in your stove,i looked up part number RGB 745 and it doesn't come up as a good part number,if the bake ignitor works you can try that up in the broil,they are the same,if it lites then you know the ignitor they put in is no's the sears site so you can see the ignitor yourself.

Nov 04, 2011 | Hotpoint RGB745 Gas Kitchen Range

1 Answer

I bought an 1995 Eagle Talon , the dude took off the air conditionar unit and hoses how and where do I get them put on and replaced . I wanna do it my self but don't know where to start . Don't...

i would get a get the oem service manual their better than chiltons , you can find them on ebay , a couple websites might help out is in case u wanna save money and go used for parts and if you wanna go new is a good place ..... just make sure u have a shop pull a vacuum after its all together u can charge it youself after the system is evacuated out cause theyll charge u $200 to what u can do for like $50 from auto parts store, some parts stores use to loan vacuum pumps, good luck btw might still have diagrams on your car

Jun 12, 2011 | 1995 Eagle Talon

1 Answer

1983 Honda Shadow 750 how to test ignitors and coil

Hi, Leafcup75 for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Honda, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
83 VT750 Ignition Coils Spark Units
Testing Honda Coils and CDI boxes
Honda Shadow VT700C Manual
Honda VT750C Owner Manual

Btw, I’m available to help over the phone in case u need at

Sep 09, 2010 | Honda VT 750 Shadow Aero Motorcycles

1 Answer

1991 Honda Civic just died as I was driving it sputtered a little like it was going to stall out and I turned a corner and the "check engine" light came on and it was dead. It will turn over but it seems...

Very common problem on Civics of this age. The distributor has failed. Take the dizzy cap off and if the ignitor module is fried inside, or there is black plastic shards then it's time for a new one. You can buy the ignitor separately but it's almost easier to buy a whole unit.

Don't buy one from Honda, they will take all of your money and you'll still owe them. Get one from eBay with a warranty. If the new one comes with a plastic screw to hold the rotor arm down, change it for a metal one as it will smash itself to pieces. In the UK there is a company called Probe who still haven't worked out why they get so many returned parts.

Hope this helps and please vote for me if you think I've helped. Thanks

Jun 24, 2010 | 1991 Honda Civic

1 Answer

I wanna buy a digital camera. but i don`t know how to design which one is good. would you please suggest me please?

If you want a great point and shoot, you can't beat the Panasonic Lumix DMC-ZS3. If you're interested in an SLR, then I highly recommend the Pentax K7.

Nov 18, 2009 | Cameras

Not finding what you are looking for?
1992 Yamaha FZR 600 Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts


Level 2 Expert

314 Answers


Level 3 Expert

1216 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1165 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides