Question about 2011 Hyosung GT125R

1 Answer

Electric start doesn't work

Engine doesn't start with push button, but does bump start

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Hyosung Expert
  • 391 Answers

Check for a dead battery or a bad connection at the battery. These battery connections get corroded fast and need attention frequently. After they are clean and re connected they should be coated with grease to prevent corrosion.

Posted on Apr 13, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi I had honda CM125 for 30 years now there is a problem that bike is doesn't start, the kik is falling down freely and it doesn't moveing eny cilinder


im asumeing its a older model with no electric start have you tryed bumping it ( push it down road clik in to gear engine starts up ? if not try it will it start like that ? if so its proberbly something to do with the kick start shaft / gear teeth i would expect to have to go in the right hand engine caseing to find the issue and repair hopefully something just poped out of place

Oct 29, 2012 | Honda CM 125 C Motorcycles

1 Answer

Bad switch on Electric Started


hello,if it is the one i think it is to where the push button is a closed unit with no screws as far as i know there is no repair for the push button switch,how ever there is a good how to on u tube repairing snowblower electric starters,from what i have seen the push button doesn't go bad,now if the push button comea apart you can repair it which useally the black box or circut thing that cost around $40.00 found on most s 200 blowers,hope this helps,,

Jan 23, 2012 | Garden

2 Answers

When I try to start it (2000 Pontiac Sunfire), it turns over but just stops - as if it's out of gas but the garage said it's all tied in with the electrical. Four times in 8 months this has...


Try resetting the fuel cut-off switch. This cuts fuel supply to the engine in an accident (if the car was bumped it sometimes sets off). From the trunk, find a hole just bigger than your finger on the side of the car that the fuel filler door is on. Put your finger in there and there should be a button that you can push. Hold it for a second or two should be fine. If that doesn't work, try it again with the key turned in the ignition (not with the engine running but enough to turn on the heater fan). If that doesn't work, it will be something else that i cannot diagnose from here. Good luck.

Sep 15, 2011 | 2000 Pontiac Sunfire

2 Answers

My honda xr125 will not electric start but will bump start straight away,i had it from new so i know its not been in accident or breakdown before,when i press starter the solonoid clicks but doesnt turn...


check the battery , even new they will discharge,, if you can jump start it, or at least try, if it works, its going to be low amps in the battery itself, if that doesn't work, your going to have to pull the starter and bench check it,, if you need help with that just reply to this feed and I'll help you with that

Sep 09, 2011 | 2008 Honda XR 125 L

1 Answer

I change the battery of my BMW F650GS 2001, because I can't start the engine, besides all the electrical parts were working good. Even though it was changed, I can't start the engine. When I push...


Check the connectors on the end of the battery cables,especially the one going to the starter motor.

If all is ok, you possibly need a new starter.

May 08, 2011 | 2001 BMW F 650 GS

1 Answer

I have just purchase a Sears 22 Lawm mower, with a Briggs and Stratton 158cc engine. I prime the motor it act like it wants to start but then dies. I pull it and try to strat it several more times and it...


The procedure for starting an engine is as follows:
  • Check that you have the throttle in the start position and/or on high revs with choke on
  • Prime the engine by pushing the button about 5 times
  • Pull out the cord until you meet resistance. Then let the cord go fully back into the engine and then pull the cord out sharply. Repeat this until the engine starts but not more than a few times.
  • If the engine doesn't start, try pressing the primer button another few times then try to pull start the engine
  • If the engine doesn't start after a few pulls it may have flooded so leave it for a few minutes before pulling the starter rope

Apr 30, 2011 | Briggs & Stratton Briggs Stratton Intek V...

1 Answer

Engine light on after bump starting my Triumph Speed Triple


You'll need to go to the dealer and have them reset that light......Good luck....Tim

May 03, 2009 | Triumph 955i Speed triple Motorcycles

Not finding what you are looking for?
2011 Hyosung GT125R Logo

Related Topics:

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyosung Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Hyosung Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...