Need to know what needs to be done at 100,000 on the maintnance its not in the manuel.
SOURCE: need location of fuel pump relay
This relay will be in the Power Distribution Center under the hood in the engine bay. Thanks for using fixya!
Sincerely,
jC
SOURCE: i need a fuse panel diagram for a 1987 bmw 325i
your car has double squirrel cage fan. Odds are it is not the fuse. The brushes wear out in motor and it does not make contact causing it not to work. Try this. Open hood on firewall behind intake(aluminum part where it says bmw) the fire wall has bolts in it. The fan access is behind there. First i would try hitting that area a hammer to try to bounce the contacts of the blower motor. Do this while the fan is in the on position. If that does not work remove the screws and the fan is behind there. There is a resistor and a motor behind there. A giant clip holds it in. You have to be inclined to change it
SOURCE: need to install belt
i made this with paint. hope it helps. typically on a bmw the belt goes between the water pump and crank pulley to the tensioner; if this is a 99 to 06 ish 3 series and some 5 s you will be good
SOURCE: need serpentine belt diagram for 1994 bmw 325i
Below are diagrams for both the M44 and the M50 engines. On the M44, you may need to hold the tensioner in the retracted position with a drill bit or hex tool through the hole in the front of the tensioner. The belt tensioner is automatic so no tightening is necessary. Best of luck!
Greg
M44
M50
144 views
Usually answered in minutes!
×