Question about Motorcycles

Open Question

Honda xr 125L vibration from engine felt all through the frame an seat

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 86 Answers

SOURCE: engine noise

sounds like it could be 2 things. the valve tappets, meaning valves need adjusting and or loose cam chain which may need adjusting.

Posted on May 27, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you remove the seat of an xr 125?


Just looked online if you Google Honda xr 125 seat removal you will find a pdf copy of the user manual it shows in great detail how the seat is removed. FYI you remove the side panels first, then the 2 bolts that hold the seat to the frame, then slide the seat backwards this detaches the seat lugs from under the tank and the back of the sub frame.

Jul 15, 2014 | 2004 Honda XR 125 L

1 Answer

Honda xr125 L blowing 15amp fuse while i was riding no lights or starter or horn


Sounds like a short like the insulation on wire rubbed off. Could also be a loose connection on either the hot or ground side of light circuit. This would blow a fuse.

Feb 27, 2013 | 2003 Honda XR 125 L

1 Answer

Honda xr 125 blowing 15amp fuse


me id start by looking real close at the wires to and from the head and tail lamps and handle switches , then id go farther at looking inside the head and tail lamp housings for say water or a rusty or damaged wire , finnaly arriving at looking at the battery voltage with a voltmeter when im reving engine this shouldn't go over say 12.8 volts if it does your voltage regulator is defective and is damaging all your bulbs

May 26, 2017 | Honda XR 125 L Motorcycles

1 Answer

How to change oil on a 2008 honda xr 125L


Undo the 17mm bolt in the middle of the engine on the underside, catch the old oil in a clean container, check the condition of the crush washer on the drain plug, replace if ness, when all the oil has been drained replace the drain plug and tighten adequatly, refill the engine using the correct oil.To the rite level
.start up the engine allow it to run for a few mins, then turn the ignition
To the off position, allow to settle hold bike in uprite postion and. Recheck the level as per handbook

Sep 05, 2011 | 2008 Honda XR 125 L

1 Answer

I have a honda xr 125l 2003 which i bought in june only to find out the cylinderhead was damaged by the valve head which broke and hit the piston head. now i bought the cylinder head of cg 125 with the...


Hello epsom...you really should purchase the shop manual so you could see the illustrations and the step by step procedures on how to align timing marks and properly gap your piston rings. Plus so much more info that you are going to need to do the job right. Plus the manual has the torque specs. and the sequence---There is not enough room here to give you all the info u will need. Here is a link for the manual online, you might can find it a bit cheaper on Amazon. i hope this helps.

http://cgi.ebay.com/ebaymotors/Honda-XL-XR-125-200-Motorcycle-Service-Repair-Manual-/260718595181

Jul 17, 2011 | 2003 Honda XR 125 L

1 Answer

Where do you check the oil on 2001 honda xr 650


To get an accurate reading on your oil level , you have to start the motorcycle engine and run it for a at least 5 minutes longer if it is cold outside . A short drive works good. Then unscrew the dipstick on the frame above the tank , wipe it off , make sure the bike is level (upright) and put the dipstick back in till it seats(but do not screw it in). Now take it out and read the level. Top up as necessary but do not over fill. Use only JASO MA certified motorcycle oil. 10w-40 for cooler climates. 20w-50 for warmer conditions. Any oil that says Energy conserving on the label will shorten the life of your wet clutch and transmission gears. Synthetic oil help your bike run cooler and shift easier. 0w40 Amzoil runs great in my 1996 XR 400 Honda.

Oct 06, 2010 | 2001 Honda XR 650 R

1 Answer

Can i turn my 1986 honda 600 kick start into a electric start


Not unless you change engines to one that already has an electric starter. A 1986 bike is not worth what it would cost. The frame would need to be altered for the new engine to fit. Please rate my answer. Thanks.

Aug 15, 2010 | 1986 Honda XR 600 R

1 Answer

Engine noise


sounds like it could be 2 things. the valve tappets, meaning valves need adjusting and or loose cam chain which may need adjusting.

May 27, 2009 | 2004 Honda XR 125 L

1 Answer

Noise from gearbox near front sprocket.


Your bike may need the harmonic balancer chain adjusted. Th will notice is noise is very prominent at engine idle and low RPM's. When this chain get lose you will feel the vibration even in the handlebars if it is loose enough.

Dec 03, 2008 | 2005 Honda XR 650 R

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...