Question about Motorcycles

Open Question

Suzuki eiger 400 4x4 won't go into reverse , it stays in neutral but does go to high and low gear.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: suzuki burgman 650 won,t change gear

I had the same problem until I found out that when you put the Burgman on it's center stand, it pushes a small round metal pin (spring loaded or something similar) that limits the Burgman to 1st gear only. Some kind of safety feature, I guess. You can see the little switch if you put the bike on it's side-stand, get down on the right hand of the bike and look where the centre stand meets with the body of the bike. My switch was stuck in permanent "on" so I just pulled the pin to it's full extention with a pair of pliars, then cut it with a junior hacksaw.

Posted on Jun 03, 2009

Ad
  • 149 Answers

SOURCE: '06 Suzuki Eiger ATV will not start. When pushing the

Try shorting out the 2 10mm nuts on the starter relay (has the lead from the battery and starter going to it) if the the engine turns over chech the relay or safety switches. It will flash so make sure the is no open fuel. If nothing happens try tapping the starter motor l(lightly) then try it. If this works the brushes in the starter are worn out..Dont keep on doing it as you will burn the comutator in the starter..Brushes are cheap.

Posted on Jul 03, 2010

  • 8909 Answers

SOURCE: My 2005 Suzuki Eiger 4x4

There is a slip ring type of switch within the gearbox housing that lets the ignition produce a spark.
Not the easiest thing to fix but a broken wire maybe the problem if you have no gear indication either.
Hope this helps.

Posted on Nov 15, 2010

19ken55
  • 426 Answers

SOURCE: Just had the motor rebuilt

Adjust the idle to correct RPM say 900 or so.

Posted on Jan 27, 2011

  • 1702 Answers

SOURCE: My Harley davidson ultra classic has a zodiac products reverse gear fitted. I can't put the bike into reverse from neutral because it grinds the gears badly. I have to put the bike into first gear

It could be the clutch needs adjustment or the reverse syncro is not there or needs to be replaced. good luck.

Posted on Mar 09, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I've got a 2006 Suzuki eiger 400 4wd. I've been rideing it all day, and now it will not start. Even pull start.what could be the issue?


Repair and Maintenance [Archive] - Page 4 - Suzuki ATV Forum

www.suzukiatvforums.com/forums/archive/index.php/f-23-p-4.html
1992 King Quad High Idle Issue · kill switch · quad master 500 wont run · Spark ...2006 suzuki vinson fuel gauge shows empty · 87 LT-4WD L.H cover removal: ... 07 Kingquad 700 Starting and electrical issues · 2002 Eiger 400 won't go into ...

Nov 23, 2015 | Suzuki Motorcycles

2 Answers

Suzuki eiger


is that a semi-auto or manual clutch?

Nov 02, 2013 | Motorcycles

2 Answers

My 2007 suzuki Eiger 400 4X4 will not move when shifted into gear forward or reverse


if its a CVT the belt might be broke or worn. If a manual then it could be the centrifugal clutches

Apr 14, 2013 | Suzuki 2007 Eiger 400 4X4 Semi-Automatic...

1 Answer

96 ROVER DISC. Has strong reverse - won't engage any forward gears. Fluid seems full even when warm.


Make sure the 4wd shifter is in correct position and hasn't slipped out of correct spot to get you moving forward.

Mar 27, 2013 | 1995 Land Rover Discovery

1 Answer

My 2006 holden viva won't go in to reverse? The warning light is staying on as we'll


which light?
just reverse,
and not stuck in park/neutral.? (called park lock out) in USA.

Feb 05, 2013 | Suzuki Reno Cars & Trucks

1 Answer

Car only starts in reverse and only drives in neutral


Sounds like a cable to the transmission is not adjusted up right, and/or the neutral safety switch is not adjusted right, if this applies to your Toyota Corolla.

Nov 04, 2011 | 1997 Toyota Corolla

3 Answers

My 2005 Suzuki Eiger 4x4 ATV will shift into neutral, but it does not detect that it is in neutral, and will not start. The neutral light is not on, and I cannot start it with the electric start or manual...


There is a slip ring type of switch within the gearbox housing that lets the ignition produce a spark.
Not the easiest thing to fix but a broken wire maybe the problem if you have no gear indication either.
Hope this helps.

Nov 14, 2010 | Suzuki Rg 400 Motorcycles

2 Answers

ATV Polaris 330 (I think trailblazer) wont shift into gears


I have one of these and it always throws my friends for a loop. You have to push the foot brake to get the bike in park or high. It should shift very easy with the brake down, if not check if the spring didn't come off of your brake pedal. I hope this helped.

Apr 04, 2009 | Polaris ATV

1 Answer

1990 Suzuki Escudo 4 wheel drive


As far as I know the procedure should go something like this...

Stop the vehicle, engage the parking brake and if applicable, get out and turn the hubs on the front wheels from Free, to Lock.(You may not have these on a Suzuki, they may be auto-lockers)

Get back in the vehicle and put the transmission shift selector into Neutral.

If you have a manual transfer case, move the selector-shaft to 4x4-High, or 4x4-Low -- whichever is desired. Now, putting the vehicle in gear with the transfer case is sometimes somewhat difficult. As long as the vehicle's transmission is in neutral, don't worry, the gears inside the transfer case are big and beefy -- Don't be afraid to be rough -- Again as long as the transmission is in neutral. You may also have to disengage the parking brake and slightly let the vehicle roll forward or back with your foot-brake to get the Transfer case to lock into place.

Once 4x4 of the selected High, Or Low range is selected, usually indicated by the vehicle jerking slightly with a slightly loud clank/thud. Move the Transmission selector out of neutral into your desired gear (Drive if Automatic, if Manual, whichever gear you pull out from). and voila! You should now be in 4-Wheel-Drive.

To disengage 4-Wheel-Drive. Just reverse the steps.

May 16, 2008 | 1990 Suzuki Sidekick

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

76673 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...