Question about kawasaki Motorcycles

1 Answer

Wont idle properly - kawasaki Motorcycles

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 18 Answers

Clean carbs and air filter

Posted on Feb 11, 2014


1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1995 subaru legacy wont idle after changeing timeing belt


If the vehicle was idling proper before timing belt replacement, it is possible the valve timing is not correct due to belt not being installed/lined up properly. If belt was changed because it was broken, chances are there is valve damage internal to the engine causing this issue

Jan 27, 2016 | Subaru Cars & Trucks

1 Answer

Chainsaw wont idle properly


Most carburetor problems now days are caused by using gasoline with alcohol in it. It is very caustic and causes the idle (smallest) jets in the carburetor to plug up so the engine will not idle properly. The only fix that I have been successful with was to take the carb apart and run a small wire through the jet to open it up and then used only gasoline without alcohol in it. There are typically a few stations in towns which still sell that type of gasoline.

Feb 11, 2015 | Poulan Garden

2 Answers

1994 ford ranger 2.3 runs fine wont stay idling


Try TPS. Throttle positioning Sensor. This sets base idle. (Unless this model is too old for that sensor)

Sep 21, 2014 | 1994 Ford Ranger Supercab

1 Answer

3.0 loaps and wont idle replaced intaken gaskets and now it wont idle


If you just replaced intake gaskets and it wont idle properly its because the gasket you installed is leaking

Jul 05, 2014 | 1993 Plymouth Voyager

1 Answer

Gs400 idling rough


The reason for traction light to come up is due to high idle. Set the idling screw to proper amount and the check light may go off.

Jun 23, 2013 | Toyota Cars & Trucks

1 Answer

Wont idle


Make sure your spark plug is not fouled and the gap is correct, also air filter is properly cleaned. If it still wont idle, locate the idle adjustment on the carb. There are 2 screw type adjustments there, one is the idle/air screw and the other is idle adjustment which is the one you want. Start the bike and warm.it up, slowly turn the idle adj. Inward like tightening a bolt, periodically give the engine a slight rev and let it idle.down. Do this until you reach the desired rpm you want to idle at and your finished

Mar 24, 2012 | 2002 Yamaha TT-R 125

1 Answer

It wont idle down to the proper rpms


The most common causes for this is either a stuck idle air control or a vacuum leak. The idle air control is in the throttle body and adjusts the amount of air that the engine gets at idle.

May 09, 2011 | Isuzu Pickup Cars & Trucks

1 Answer

Engine hunts and wont idle properly


If the RPM's fluxuates at an idle at all times you have a bad spark plug or a bad spark plug wire

May 29, 2009 | 1990 Isuzu Trooper

1 Answer

The engine will not idle properly and then it will and then wont again


oh yes the beutifull old granade as i call it just a little humor. but i am willing to bet that you need your carburator rebuilt. because after all the years of patroleum going threw it. will cause some of the seals and gaskets just to rott. and sometimes they will let air in through them wich will not allow it to function right but the next time it could have a tiny little bit of dirt that seals that tiny crack and you will idle just fine.
i hope this helped you out. and please leave an appropriat rating for me
Thank you

Apr 21, 2009 | Ford Granada Cars & Trucks

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75077 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...