Question about Yamaha Motorcycles

1 Answer

My yamaha sr 125 1992 won't start

I have put a new battery into my bike and it turned over but didn't start so I tried to bump start it and after the 4th try it went as normal later on that night I turned the ignition key the neutral light came on the fuel switch was on and all it done was turn over but didn't start can someone help me please

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Yamaha Master
  • 43,881 Answers

Hi, Anonymous and the usual suspects are:
1. Fuel tank empty.
2. Fuel supply valve/petcock turned off.
3. Fouled spark plugs.
4. Engine flooded as a result of overuse of the enricher.
5. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
6. Fuel valve/petcock or filter clogged.
7. Fuel line to carburetor or throttle body pinched or kinked.
8. Carburetor float stuck.
9. Fuel injectors clogged.
10. Severely discharged or damaged battery, you need 12.5 volts or better and be able to pass a load test if necessary.
11. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
12. Loose or corroded wire connection at the coil, battery or plug between ignition sensor and CDI box.
Spark plug cables in bad condition and shorting check for leakage in the dark, cable connections loose, or connected to the wrong cylinders.
13. Ignition timing incorrect due to a faulty MAP, CKP, O2, TPS, sensors.
14. Faulty neutral, clutch lever, or kickstand safety switch.
15. Faulty fuel pump or fuse or relay.
16. Faulty CDI box.
17. A stuck bent or burnt valve.
18. Tip over sensor needs a reset.
19. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
YAMAHA SR125 Owner Manual
OEM parts for Yamaha
http://service.tanga-moteurs.ro/data/Yamaha%20SR%20125%20'97%20-%20Service%20Manual.pdf
Total Beginer Yamaha SR125 wont start Help Please
https://yamahaclub.com/forums/topic/27641-yamaha-sr125-wont-start

Posted on Dec 06, 2016

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
fastboyz
  • 674 Answers

SOURCE: tiger triumph 2008 brand new wont start... help

ok
you have a problem with the starter not turning the engine. so we probily not sending a signal to the starter.
you realy confused me when you started talking about gas and choke?
if the engine doesnt turn over none of this even matters.

these new bikes have many safety features .
you have a sensor for netural and you have a sensor for your kickstand and a sensor for your clutch
and all of these have to be workinf right for your engine to turn over.
so with your kickstand up and the bike in netural and the clutch lever pulled in
it should turn over and start.
when it doesnt you need to check your wiring to the switches one might have come loose.
or could be a bad switch.
let us know what you find

paul

Posted on Nov 23, 2008

  • 66 Answers

SOURCE: wont start

check yor fuses in your fuse box.also check main fuse.

Posted on Feb 16, 2009

  • 1810 Answers

SOURCE: DT125 no electrics! non starter

how about replacing the fuse by the battery it is a master fuse and thats what it sounds like
since all lights and bike runs after a bump it sounds like a master fuse problem
if not check your batterie ground it might be cut or loose

Posted on Aug 04, 2009

davesoucy
  • 148 Answers

SOURCE: ducati monster 620 went dead

Sounds like a detached connector or a blow fuse. First open your user manual, locate the fuse holder and dbl check the fuse... You have two circuits, the On circuits, and the accessoiry (wich are not essential) seems that you lose the accessory...

Posted on Aug 05, 2009

  • 2 Answers

SOURCE: yamaha sr125 ignition problem "click"

I am having exactly same problem. re starting, battery and fizzz. At the bottom of the carb on bikes left side is s screw. get a glass or old clean jam jar, place the thin tube in jar that comes off the bottom of carb, turn screw. petrol should start flowing into jar. let out about two egg cups full into jar. re tighten screw. hold jar up to light. what you have done is remove any water from the carb. you should see any water floating below the petrol. NEED I SAY DONT SMOKE WHEN DOING THIS . The fizz i cleaned all the contacts of any white deposits around bulb holders in the indicator arms.tightened the wiring conectors. Removed and dcleaned the indicator switch.

Posted on Oct 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Yamaha sr250k 1992


be a little more specific , is your battery dead and not enough to turn the starter if the battery is good test your wiring to the ignition and starter when you put the key to start ck to see if you are getting power to the solenoid if so , then your solenoid is bad , you can change it or get a new one , jump it out and see if it starts that way to ck your wiring too,

May 30, 2014 | 2001 Yamaha SR 125

1 Answer

Bike won't start after I put a new battery in it after a while it turns over but dies after a minute


batt must always read 12.6volts cause its a coil ign-test it-----alternator may be bad or a connector makin it not charge rite--getta clymer manual for complete repair

Feb 10, 2014 | Yamaha SR 125 Motorcycles

1 Answer

1986 yamaha xj700 won't start just makes click


sounds like a bad earth if you have jump leads go direct of earth to engine to see if this cures it if so you no where problem is clean replace earth

Jul 12, 2013 | Motorcycles

1 Answer

Can't Start 1981 Yamaha SR250


find a running sr 250 and swop his cdi unit with yours if the bike runs, fine. if not put his cdi back in and try again. if the good bike now starts it will indicate that your cdi is faulty. the cdi is located under the tank inside the frame. don't buy a second hand cdi unless you can test it on a working bike. they are very expensive and you don't want to buy a dud

Jun 09, 2012 | 1981 Yamaha Sr250 Sr 250 Exciter Y213 Air...

1 Answer

My dt 125 RE won't start sometimes but i have replaced the battery, spark plug and cap


not energy in the battery to run both the starter and the ignition system
have the battery load tested and have the circuit checked for excessive resistance readings in the ignition system

Aug 01, 2017 | Yamaha DT 125 RE Motorcycles

3 Answers

Yamaha sr125 ignition problem "click"


check voltage at battery, then check voltage at solonoid, then check voltage at starter. were does it stop? also check batt cables,fuse cons. any corosion? water damage?

May 02, 2009 | 2001 Yamaha SR 125

1 Answer

I have a yamaha xvs 650 dragstar converted to a trike it has been stood for 3 months. when i try to start it there is a fast clicking but the the engine does not turn over but will start easy with a bump...


bike needs a new battery. battery is no longer capable of holding a full charge no matter what a trickle charger says. batteries wear out over time. expect 2-3 years from a motorcycle battery.

the clicking sound you hear is the relay flipping between open and close as it tries to get the right amount of amperage to turn the starter.

Mar 04, 2009 | 2001 Yamaha V Star 1100 Classic

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1147 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...