Wiring diagram To place new wiring ...

http://www.fordaustraliaforums.com/forum/showthread.php?50606-Need-wiring-diagram-for-au-11-ford-2002-for-stereo-please-help

there are two links on the second post.

1) Turn the power off.
2) Remove the printer cover.
3) Remove the ink roller by turning it counterclockwise and
pulling it upward.
4) Install the new ink roller and press it in the correct position.
Make sure that the ink roller is securely in place.
5) Put back the printer cover

Which switch do you have? Why do you need a diagram. Would you not just change over the wired the way you found them in the first place. Take a photo before you begin to work.

1) you do not need any wiring diagram for to this.

2) Since you will not find any wiring diagram for your treadmills, only if you pay for service manual at your company dealer.

3) I can recommend you very easy: the following.a)buy the switch to radio schack.

b) Put in your machine c) desolder one wire and put in the same place in the new one swithc and go on, and ready.

Anyway see the block diagram for your information.

sincerely.

ernesto cuadra

Are we talking a new deck/stereo or new speakers/subs?
A new deck will require a wiring harness (cheap at walmart or local auto place) and this will come with a set of directions and wiring diagram for your make/model vehicle.
Subs/Speakers can be wired into a stock AM/FM radio (though I have no idea why anyone would want to do this) fairly simply, The wiring diagram will be printed on one side of your stock radio letting you know where to attach the 12v constant, the remote wire, and the speaker wires.

You do not need a wiring diagram to replace the fan. TURN OFF POWER.
The fan will have two wires coming from it to two places. Make a little map of that location. There is usually a quick disconnect, you unplug and swap.

The best place is from a Factory Service Manual. They are what the dealer uses. You can normally purchase a new one from the dealer. They are expensive and you may want to try your local public library Amazon or eBay to find a copy. Haynes manuals also have the wiring diagrams and there is one for your car. They are smaller and harder to read but it can be done. Check all of the above sources for a new or used one.

place give me a wiring diagram of bajaj pulsar 150

Ok from the manual. please rate this info

Dave,

You will need to go buy a wiring harness adapter from your local Walmart (usually cheapest there) or Local Electronics place (ie Best Buy). The wire harness that goes out from the radio goes into the Adapter and the adapter plugs into the car harnesses. Also these Adapters come with the wiring diagrams for your vehicle. They typically run 10 - 15 bucks depending on where you get them. Thanks for using FixYa!

Sincerely,

JC