Question about Aprilia Motorcycles

1 Answer

High revs idle

Rsv 1000 r idles at 3000 revs, was fine, then i lifted both wheels onto stands and when started the idle won't fall below 3000rpm

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

  • Contributor
  • 22 Answers

Air intake leak. too much air getting past the carb.

Posted on Feb 10, 2014

Testimonial: "Carb? rsv 1000 r and carb? Anyway, it was the datatool alarm, found that many users have had the same problem with it. I was told to disalarm it, turn on ignition and press the disalarm button until you hear a "beep", then repeat and repeat again, turn off ignition and turn back on and then start the bike. It works fine now. If your alarm is somehow connected to injection system in your bike its best to get rid of it anyway."

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
MakisRC51
  • 408 Answers

SOURCE: yamaha dt 200 won't rev off idle

You should measure the combustion ratio.Maybe piston rings failed.

Posted on Jun 03, 2009

boddd
  • 3 Answers

SOURCE: My R1 can not idling at 1000-3000rpm ??? Why ????

Adjust the throttle stop screw located behind the lover left tank embelisher, run the engine until it is warm then turn the screw to set the idle speed to 11000rpm

Posted on Jun 04, 2009

Benimur
  • 6966 Answers

SOURCE: have a 250cc yamaha virago its been standing for a

Hi and welcome to FixYa,

Almost always, your described problem indicates clogged idling jets. Stale fuel causes varnish like coating which must be removed. This then calls for a carb pulldown, disassembly and soaking non-rubber parts in carb cleaner. In the exploded carb diagram below, the idle (pilot) jet would be # 20.

467dae4.jpg

Good luck and thank you for asking FixYa.

Posted on Nov 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1989 Suzuki GSX 750 F that won't idle below 3000 rpm


Hi, Suzuki #5 is jumping up and down waving the Suzuki flag screaming "pick me pick me" and the usual suspects are:
1. Throttle cables improperly adjusted, pinched or need lubrication.
2. Idle adjusting screw needs to be backed off.
4. Air fuel mixture adjusted too lean start with 2 full turns.
5. Intake system air leak, check intake boots with propane
6. Fast idle choke ramp is not releasing.
7. Broken throttle return spring.
8. Damaged diaphragm or slide.
9. Faulty MAP, TPS, ATS, O2, sensors or wiring/connector.
10. Multiple carburetors not in sync.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Can not get my idle below 3000rpm Suzuki GSX Motorcycle Forums Gixxer com
89 Suzuki Katana 600 High Idle Issue Sportbikes net
Suzuki 85 GSX R750 Service Repair Manual
OEM parts for Suzuki
http://mybikemanuals.com/suzuki/suzuki-gsx-owners-manuals

Jun 07, 2017 | 1989 Suzuki GSX 750 F (Katana)

1 Answer

2011 Laro that is lucky to do 60-65 km. I've had the carby fully serviced, new plugs, new ODI switch, coils and it still doesn't go any faster than 60 km flat out revs at 3000 rpm and that's it.


Hi, Bungi if it's not electrical, ignition or cam timing, or a compression issue then all that's left is fuel and the usual suspects are:
1. Idle speed improperly adjusted.
2. Inlet system air leak.
3. Damaged or restricted fuel tank venting system.
4. Dirty or damaged air cleaner element.
5. The accelerator pump is inoperative.
6. Vacuum piston assembly malfunction.
7. Enrichener valve is not seated or leaking.
8. Restricted fuel supply tract.
9. Plugged bowl vent.
10. Loose or plugged fuel and air jets or passages.
11. Improper float level.
12. Worn or damaged needle or needle jet.
13. Loose or plugged main jets or passages.
For more information about your issue please click on the blue links below. Good luck and have a wonderful day.
Help diagnose my bike Won rev past 3000rpm motorcycles
Wouldn rev above 3k rpm now won start
Bike doesnt rev past 4 5k rpm
Life On 2 Wheels
http://www.cycletorque.com.au/laro-cruiser

Mar 15, 2017 | Motorcycles

2 Answers

Holden rodeo 2003, wont rev over 3000rpm


run a scanner on the system to determine codes to diagnos problem

Apr 13, 2014 | 2003 Isuzu Rodeo

1 Answer

Indicator comes on with high revs when riding


Hi, Anonymous sounds you have a short in the dash and I am sorry you can't find the first and best tool you ever bought for your Aprilia but despair not for a mere $10 you can download another one. For more information about your issue, please visit the websites below. Good luck and have a nice day.
DOWNLOAD 2008 Aprilia Rsv 1000

Jan 17, 2013 | 2008 Aprilia RSV 1000 R

1 Answer

My aprila rs50 starts fine and runs fine cold but if it heats up abit you pull the throttle and it sounds like its dieng


Instructions
    • 1 Park your RSV 1000R on a well-ventilated, level area, using its kickstand.
    • 2 Start the engine and let it idle in place until the temperature gauge built into the instrument cluster indicates a minimum internal temperature of 180 degrees Fahrenheit. This is the motorcycle's ideal operating temperature.
    • 3 Take note of the engine idle speed, using the tachometer needle, while the engine is running. Ideally, the engine should idle steadily at 1,250 rpm.
    • 4 Adjust the engine idle speed to 1,250 rpm, using the idle adjuster screw hidden between the lower right edge of the fuel tank and the upper edge of the right middle fairing panel. Turn the idle adjuster screw clockwise to increase the engine idle speed, or counterclockwise to decrease the engine idle speed, using a small flat screwdriver if your RSV 1000R's frame (VIN number) precedes ZD4MEE009YS000292. A plastic knob allows the engine idle speed to adjusted by hand on RSV 1000R models with a frame (VIN) numbers starting from ZD4MEE009YS000293.
    • 5 Rev the engine two to three times and observe the tachometer. The engine should return to a 1,250 rpm idle. Adjust the engine idle speed as needed, using the method described, then rev the engine again. Problems may exist within the throttle control, fuel-injection system or engine, if the engine idle speed will not hold steady at 1,250 rpm. Contact your local Aprilia service facility for assistance.
    • 6 Stop the engine, once you have obtained a steady 1,250 rpm idle speed.

Jan 17, 2013 | Aprilia Motorcycles

1 Answer

Water is not getting into the head


Instructions
    • 1 Park your RSV 1000R on a well-ventilated, level area, using its kickstand.
    • 2 Start the engine and let it idle in place until the temperature gauge built into the instrument cluster indicates a minimum internal temperature of 180 degrees Fahrenheit. This is the motorcycle's ideal operating temperature.
    • 3 Take note of the engine idle speed, using the tachometer needle, while the engine is running. Ideally, the engine should idle steadily at 1,250 rpm.
    • 4 Adjust the engine idle speed to 1,250 rpm, using the idle adjuster screw hidden between the lower right edge of the fuel tank and the upper edge of the right middle fairing panel. Turn the idle adjuster screw clockwise to increase the engine idle speed, or counterclockwise to decrease the engine idle speed, using a small flat screwdriver if your RSV 1000R's frame (VIN number) precedes ZD4MEE009YS000292. A plastic knob allows the engine idle speed to adjusted by hand on RSV 1000R models with a frame (VIN) numbers starting from ZD4MEE009YS000293.
    • 5 Rev the engine two to three times and observe the tachometer. The engine should return to a 1,250 rpm idle. Adjust the engine idle speed as needed, using the method described, then rev the engine again. Problems may exist within the throttle control, fuel-injection system or engine, if the engine idle speed will not hold steady at 1,250 rpm. Contact your local Aprilia service facility for assistance.
    • 6 Stop the engine, once you have obtained a steady 1,250 rpm idle speed.

Jan 17, 2013 | 2002 Aprilia RS 125

1 Answer

High idle.


try clean idle speed control.

Jul 02, 2009 | 1986 Mercedes-Benz 190

1 Answer

Yamaha dt 200 won't rev off idle


You should measure the combustion ratio.Maybe piston rings failed.

Jun 01, 2009 | 2005 Yamaha Xv 250 Virago S

2 Answers

My R1 can not idling at 1000-3000rpm ??? Why ????


do othe rr1,s idle this low? the r1 is a highly tuned engined and as such do not likelow tickovers

Feb 15, 2009 | 2001 Yamaha YZF-R1

2 Answers

87 RX 7


rx7`s should rev to 3000 when started cold then it should settle to 750 to 1000 after about 30 to 60 seconds.
mine suffers a similar problem. so far I have been told various answers, mostly involving the bac valve, lambda sensor, air flow meter, etc. try starting of by adjusting the idle adjust screw (on top of the throttle body under plastic cover) this may be all it is. I have not had time to do mine. Its been fine otherwise and idles fine after a few minutes. mine is non turbo 87.

Jun 04, 2008 | 1987 Mazda RX-7

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Aprilia Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4535 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Are you an Aprilia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...