Question about Show Chrome Accessories Led Chrome Volt Meter For Gl1800 Go-Motorcycle

Open Question

Removal of real wheel gomoto citti 125cc - Show Chrome Accessories Led Chrome Volt Meter For Gl1800 Go-Motorcycle

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I change the rear wheel of a 125cc 2004 Honda pantheon


CENTRE STAND IT AND SEE IF THERE IS A BIG NUT ON THE HUB, MAY NEED TO REMOVE EXHAUST, BUT NOTHING HARD ABOUT IT

Apr 10, 2017 | Honda Motorcycles

1 Answer

Gomoto c5 scooter drive belt size


Hi, Anonymous for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry. If necessary, transport your bike to the dealer or shop and have a professional technician take it for a test drive, if it is in running condition, and give you a written estimate of repairs and answer any specific questions you may have about your problem. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Buy 2 or more belts and standard shipping within the US is FREE
Simplest Way To Replace GY6 Scooter CV Belt
Go Moto MN THE place to GO for your MOTO
Motorcycle Workshop Gomoto C5

Apr 16, 2016 | Motorcycles

1 Answer

Hi My gomoto nippi 125cc gy6 engine dont have enough spark to start the motor, i have replaced the stator, pickup, cdi, startor coil and the regulator. Why cant i get enough spark?


Hi, Willem if you have a CKP sensor it needs compression to send the correct signal to the ICM/ECM, make sure both spark plugs are in heads and use a grounded third plug to check for spark or hold spark plug cable close to spark plug in the head. If still not getting spark the usual suspects are:
1. Fouled spark plugs.
2. Discharged battery, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
3. Loose connection at ignition coil or plug between ignition sensor and module.
4. Spark plug cables in bad condition, shorting / leaking, spark plug cable connections loose.
5. Faulty ignition coil or ignition / electronic module
6. Failed CKP, CMP, or BAS sensor.
7. Faulty ignition switch.
8. Security alarm failing to disarm needs reset
For more information about your issue, please visit the websites below. Good luck and have a nice day.
http://www.49ccscoot.com/manuals/Tank_GY650-150_Service_Manual.pdf

Sep 16, 2015 | Motorcycles

1 Answer

125cc pit pro, pit bike Kick start lever jammed


remove the cover that houses the kick starter and look for a failed return spring or some other reason that keeps the kick start dog engaged.

Jun 03, 2013 | Pit Bike 125cc 4 Stroke Dirt Bike

1 Answer

Rear wheel removal on yamaha cygnus


Everywhere I read is wrong. For Yamaha Cygnus-X 125cc rear wheel removal
It is removed from the right hand side. Do not start dismantling the gear box side !
Remove 5 bolts of exhaust. Careful don't loose exhaust seal where it connects to engine. You may need friend to lean the bike over to access bolts underneath.
2. Remove main 24mm bolt on axle
No need to loosen brake !
3. Remove 3 bolts holding swing arm. That's the big triangular bit.
4. Pull off the swinging arm and on axle is special shaped washer. Note which way it comes off.
5. Pull off the wheel leaving brake shows behind.
4_8_2013_12_39_33_pm.jpg

Jul 13, 2011 | Yamaha PowerMax 150 GP1 Motorcycles

1 Answer

I want to know how big i can bore out my 125cc 4 stroke motorbike


I believe the pistons only range from stock to 1st oversize. Boring to first oversize will not make a noticeable change in performance. If you want a real change what you need is a race cam. You will be able to wax any other 125cc and many 150cc bikes. Below is a source.
www.webcamshafts.com

Sep 03, 2010 | 2002 Honda CR 125 R

2 Answers

My Piaggio Vespa 125cc rear wheel has slight play. What could this be?


no panic - this is typical for the old 2stroke Vespas as their gearbox is on the rear axle....(needs no belt like the newer ones)
-but then there is a certain amount of play needed...
piaggio-vespa-125cc-rear-wheel-slight-wq3avpzkaaw4sd2xavwlekgs-3-0.jpg

Jan 14, 2010 | Peg Perego Vespa Scooter

Not finding what you are looking for?
Show Chrome Accessories Led Chrome Volt Meter For Gl1800 Go-Motorcycle Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Show Chrome Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75817 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Show Chrome Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...