Question about Kymco Hipster 125 Motorcycles

Open Question

Slugish engine feels slugish and seems to have a wobble at about 30mph

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 69 Answers

SOURCE: front end slow speed wobble

First off - Did you take the whole front end off to install the lowers? If you did - did you tighten the Main locking washer on the uppper triple tree to the correct specs? You might want to raisee the bike off the ground with a scissor jack under the frame and then with someone holding the bike steady see if you can move the front tire sideways or up and down. This is will tell you if that locking washer is loose or maybe a bad bearing in the front end triple tree

Posted on Aug 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I identify the cause of an ABS Fault?


First thought is that if you have a judder from the brakes you may have a warped front disc. The ABS system sensor may be picking this judder up and converting it to a fault.
A warped disc would spin and catch then spin and catch again rather like the rapid on/off braking that ABS does. This 'could' be the judder you feel and should be especially noticeable when braking and barely noticeable when driving with the brakes completely off.

Jul 15, 2014 | 2005 Peugeot 307 1.6

1 Answer

1998 s70 wobbles front end at low speeds


Go to an Alignment Only Shop & have them road test
while you ride along

Then have them inspect for worn parts

Nov 29, 2012 | 1998 Volvo S70

1 Answer

1999 pontiac grand prix gtp running hard


The balancer should not "wobble" at all, period. Start by replacing that.

Jul 08, 2012 | 1999 Pontiac Grand Prix

1 Answer

Seems like the left tire is wabbling at about 30mph. i slow and it's ok. i looked underneath and saw nothing loose jeep cherokee


After confirming the lugs are tight, either take the wheel down and have it balanced or rotate that wheel with the one on the other side to see if the wobbling follows it.

Hope this helps.

Feb 18, 2011 | 1997 Jeep Grand Cherokee

1 Answer

Kia spectra 2002. open the engine cap and saw thick layer of slugish dark engine oil. B4 start engine check the engine oil seem to at very low side. Worry engine condem?


POSSIBLE LEAKING WATER INTO ENG OIL CAUSING OIL TO BE SLUGISH DARK OR WHITE FILM COLOR, HEAD GASKETS OR WARPED HEADS

Dec 19, 2010 | 2002 Kia Spectra

1 Answer

Wobbly steering wheel , started yesterday, no big hits or potholes , or no bigger than normal. tires haves some tread but all 4 need to be replaced. is it an alignment issue or something more costly?


If it wobbles at higher speeds like 55-60 mph or so probabley just worn and out of balance tires,If it wobbles at like 25-30mph or so at a lower speed it probabley mean you have a tire seperating and it could blow out at anytime and you would definitely need new tires,at least more than likely the front two.

Apr 20, 2010 | 1998 Chevrolet Blazer

1 Answer

Wobble when accelerating


U NEED TO HAVE THE CV JOINTS CHECKED FOR EXCESSIVE WEAR, ALSO ROTATE THE TIRES AND SEE IF THAT HELPS, A SEPERATED TIRE CORD CAN CAUSE THIS WALLOW.

Nov 10, 2009 | 2002 Saturn VUE

1 Answer

Front end slow speed wobble very noticable at 30mph feels ok at higher speeds but sometimes feel at rear end push hitting a bend hard bike bought new and has 53000 miles installed chrome lowers about three...


First off - Did you take the whole front end off to install the lowers? If you did - did you tighten the Main locking washer on the uppper triple tree to the correct specs? You might want to raisee the bike off the ground with a scissor jack under the frame and then with someone holding the bike steady see if you can move the front tire sideways or up and down. This is will tell you if that locking washer is loose or maybe a bad bearing in the front end triple tree

Aug 30, 2009 | 2001 Harley Davidson FLHTCUI Electra Glide...

1 Answer

Wobble in the front of the car when its going 0-30mph only


you may have a broken belt in one of the tires. to ck this out have someone look at each tire while moving very slowly - the tire will look "egg" shaped if a belt is broken

Jul 21, 2009 | 1993 Honda Accord

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kymco Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Kymco Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...