a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need. goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hi, Harold it's really tough to answer any of your questions because you didn't ask any, the batteries in my crystal ball are dead and my mental telepathy headset is broken so here is my best shot the following applies to carbureted also fuel injected models and the usual suspects are:
1. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Air/fuel mixture screw improperly adjusted.
10. Water or dirt in the fuel system, carburetor or filter.
11. Restricted, blocked or kinked fuel line.
12. Fuel tank empty.
13. The gas cap is not venting properly or fuel tank venting system blocked.
14. A failed fuel pump, pressure regulator and or fuel injectors.
15. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
16. Needle and seat stuck closed in the float bowl.
For more information about your issue and valuable "FREE" downloads that you need please click on the links below. Good luck and have a nice day. 1995 cbr 600 F3 problem PLEASE HELP CBR Forum Enthusiast forums for Honda... cbr600f3 will only start choke gas givin Honda Motorcycles FireBlades org HONDA CBR WONT START TRY THESE TIPS 1996 1998 Honda CBR600F3 Service Manual Moto Data Project
put a volt meter across the battery, engine stopped must be over 12v. rev the engine to 3-4000 should rise to about 14v, this will show the charge system is working Some batteries only last 12 months or so. if it is a couple of years old buy a new one, the gel ones seem to last longer
Sounds like a wire or plug got disconnected while changing the headlight out, the harness that connects to the clutch safety switch, the one that lets the ignition fire when cranking only when the clutch is pulled in. A safety feature so you don't dump the bike if you crank it while in gear.
Doing a search I saw your question come up, hopefully this is not an old question. ANyways, under the front edge of your fairing there is a small black rectangular plastic piece held on with 2 screws and two clips. Remove the clips by pulling on the centers, they should come right out, this will give you access to the back of the headlight. There you will need to unplug the headlight and the give the light a turn and it should come out of there. Make sure not to touch the new bulb with your bare fingures as this will shorten the life of the bulb, clean with alcohol if you do, hope this helped.