Question about 2005 Honda CRF 250 X

1 Answer

I cleaned my 07 crfx with a jet wash now it wont start. I have a spark, I have drained the carb, it still wont fire. Any Ideas?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 909 Answers

Spray with WD40 or similar water expressant. Then try to start again, could be water in the air filter so remove and see if you get anything then.

Posted on Jun 03, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 2011 husqvarna 345 xtorq only done 2 hours work .i got spark , cleaned out carb new plug still wont start or even fire any ideas plz


did you check for spark? you need air fuel and spark for engine to operate. check all of these then if it still wont start check the ground wire from coil to switch

Aug 14, 2014 | Garden

1 Answer

Generator back firing from inlet manafold


Your symptoms are from running lean. Foam air filters put debris in carb jets. Check all the carb passageways and jets. Always start with a new plug.

Nov 29, 2013 | Electrical Supplies

1 Answer

No gas to spark plug on atv


carb float/needle sticking opening the carb drain will provide evidence if fuel is reaching fuel bowl, if fuel is present then i would suspect the carb is gummed up and it will need to be cleaned ( all jets/passages ) another area could be that the gas cap vent/line is plugged not allowing fuel to flow by gravity feed.

Jan 08, 2012 | Polaris ATV

1 Answer

DR 200 Dual Sport 07 model. Been sittin in garage for 2 yrs . FIRING BUT WONT START. Carb problem? where do I start ?


Replace all fluids including any hydraulic fluids.
Fit new spark plugs and strip down carburettor cleaning the jets especially the main jet. If corroded at all, replace the corroded jets.

Jan 05, 2011 | 2001 Suzuki DR 200 SE

1 Answer

Have a honda crf100f 4cycle got spark wont start,


CLEAN THE CARB AGAIN IF IT RUNS ON STARTING FLUID ITS NOT GETTING FUEL YOU WILL NEED TO REMOVE THE JETS AND MAKE SURE THEY ARE CLEAR

Jan 23, 2010 | 2002 Honda CR 125 R

1 Answer

CRAFTMAN LEAF BLOWER WONT START


Fuel starvation - 'lean fuel' condition
Basic things to check:
1) spark plug
2) spark arrestor in muffler
3) fuel lines and tank filter
4) turn adjustment needles out (counterclockwise) 1/4 to 1/2 turn
Chain Saws:
5) check impulse tube and intake boot for cracks or leaks
*if all of the above are OK and/or do not improve performance then:
Remove Carburetor
6) replace gaskets/diaphragms
a) use a spray carb cleaner to clean jets, holes, and body of carb
b) fuel pump diaphragm goes against the carb body,
then the gasket towards the outside
c) metering gasket goes against the carb body,
and the diaphragm goes towards the outside

Nov 19, 2009 | Craftsman 4 Cycle Blower/Vac

2 Answers

My Yamaha yz250F 07 starts first kick but back


I see: you changed the plug because it was backfiring.

Does it back fire when you let OFF the throttle after revving it, or does it back fire while being revved?

If it does it when you let off then Ollie's suggeston might do it. If that doesn't do it then check for dirt in your pilot jet.

If it back fires when revved up high could be dirt in your main jet.

Oct 31, 2009 | 2004 Yamaha YZ 250 F

1 Answer

07 KTM250exc 2 stroke wont start


Fuel becomes like a gel substance if the bike was not used for some time. There may be some gel blocking the main jet of your carburetor. If the gel formed in the tank, it may take a while to reach the carburetor. That may be why it operated without a problem for a while.

Oct 17, 2009 | 2005 KTM EXC 250

2 Answers

Scooter wont start


The ignition timing may have been disturbed,or if it is equipped with a carburettor,the mixture setting may have been disturbed,or the carb.jet may be blocked by dirt in the fuel or the spark plug may be faulty .get all these checked first .

Aug 14, 2009 | Qianjiang QJ150-C Motorcycles

1 Answer

I have a 98 honda foutrax 300 4 wheeler it started acting up and now it wont start took the carb. off and cleaned the jets and everything up and pulled the spark plug out and put my fire over the hole and...


remove all of the old fuel using a siphon bulb and hose. Put in brand new fuel and make sure the line from the tank to the carb. is flowing gas. if not clean or replace the fuel line

Jun 17, 2009 | Honda NS 250 R Motorcycles

Not finding what you are looking for?
2005 Honda CRF 250 X Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4535 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...