Question about 1995 kawasaki ZX-6R Ninja

Open Question

I have a problem starting up my bike. kawasaki zx6r 1995

I have a problem starting up my bike. it starts okay mostly but sometimes it doesnt start at all or it runs very unsmooth. could it be because one of the pistons isnt firing up properly? it feels like one might not be igniting at low revs.
thanks

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emjem74
  • 162 Answers

SOURCE: zx6r 1999 G2 starts fine when up to temp throttle

i would try to map the fuel system as it sounds like its totally out? ive never heard of it affecting it that much? also try replacing air filters.

Posted on Mar 05, 2009

ginocussen
  • 216 Answers

SOURCE: Misfiring on one cylinder at low revs on Kawasaki

Faulty plug? Bad plug cap?

Posted on Mar 17, 2009

  • 3567 Answers

SOURCE: kawasaki 300 bayou won't rev up.

No guarantees but try this. Pull the slide from the throat of the carb. Now move the clip on the jet needle down one notch. This will richen the low end mix. Two notches may be needed but do one notch at the start.

Posted on Apr 30, 2009

MakisRC51
  • 408 Answers

SOURCE: Does anyone have a Vaccum hose diagram for a 1995 Kawasaki ZX6R?

One of these pipes is for overflow gas.You just route it downwards.For the other one I need more info.Some bikes have a second overflow tube tha collects the water near the gas cap on the gas tank and goes the same way like the other one.Blow in them from the loose end having them attached to the tank and see what happens.

Posted on May 26, 2009

  • 60 Answers

SOURCE: Poor throttle response below 4,000 revs.

The carbs need to be re-tuned for the exhaust. It doesn't seem like like it needs to be rejetted just idle mixtures adjusted. this would be something that a mechanic should do because there are four carbs and they need to be syncronized with each other

Posted on Jun 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Kawasaki zx6r 2009 keeps displaying f1 and with a flashing red light. The bike runs fine. Sometimes shuts off while warming up. how do I fix it?


it actually means fault indicator and doesn't deal solely with the fuel injection.

put the key in the ignition and turn it on, but don't start the bike. use the mode button to go to the odometer display, then hold the mode button down for 2 seconds. the code should be displayed.

come back when you have the code

Apr 18, 2015 | kawasaki Motorcycles

1 Answer

Zx6r 2004. Bike ran great for two months. Went out to dinner last night and came out to my bike not starting. Trailered it home, started when taking off trailer. Went for a 15 minute ride and parked it....


Hi, Matt it saddens me to inform you that you have to put on your Battery Priest Robe and prepare yourself for the Ceremonial "LOAD TEST" but before you begin, maintenance type batteries must be topped off with distilled Holy Water and all batteries must present their terminals to the battery charging altar to receive the electrical infusion of Holy Ions until they have reached a 100% full charge of 12.5 volts or better.
Below is a quick and easy test to see if your battery is in good condition or needs Last Rites and must be replaced.
1. Start by disconnecting the spark plug cables.
2. Adjust voltmeter to DC volts 20-volt range
3. Place the voltmeter leads to the battery terminals.
4. Turn the run/off switch to run.
5. Turn the ignition switch on and press the starter button.
6. Watch the voltmeter as your engine turns over for 15 seconds.
7. If the voltage drops below 9.5 volts, the battery is faulty and must be replaced.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
ZX6R 636 Bike won start
Kawasaki NINJA ZX6R My bike won start Starter problem or discharged battery
Kawasaki Ninja ZX6R Service Manual
OEM Parts for Kawasaki
Kawasaki Ninja ZX 6R Owner Manual
How to Tell if Your Battery is Bad in 3 Easy Steps

May 18, 2017 | 2007 kawasaki Ninja ZX6R

1 Answer

I have a 1995 zx6r running great starting wise but not shifting. The bike run strong in first gears but when shifting to second it only work for about 2 sec then nothing so i shift to third gear to...


sounds like fuel starvation check for blockages in petrol tap, does it only do it reserve?? the 600s are known for crappy reserve internal filter, check the petrol tank breather

Feb 17, 2013 | 1995 kawasaki ZX-6R Ninja

1 Answer

Hi!!!!! i have an kawasaki zx6r 1998 and it dosent want to start , i started it 2 days ago, but today it dosent want i charged battery, and when i push start button it dosent do nothing, i checked coil...


Check the clutch, neutral and side stand safety interlocks.
Double check that the bike is in neutral, and the clutch is pulled in when trying to start the bike.
If the bike is in gear with the side stand down, the bike cuts off all ignition.
If the clutch isn't pulled in, the starter won't engage.
Check all these safety interlock switches, and make sure you are in neutral with the clutch in when trying to start the bike.

Jun 27, 2011 | kawasaki ZX-6R Motorcycles

1 Answer

My kawasaki ninja zx6r year 2002 won't start


Start at the battery, then make sure he wires and cables are all good, try to bump start the bike to make sure the motor is not siezed,

May 03, 2011 | kawasaki ZX-6R Ninja Motorcycles

2 Answers

Wiring diagram 2001 zx6r


Try this manual, it should cover all your needs. Are you sure you have the correct rating fuse in the box, the manual will solve the problem any way. Good luck:

http://vitek.vellum.cz/manualy/Kawasaki%20Ninja%20ZX-6R%2000-02%20Service%20manual.pdf

Jan 29, 2010 | 2001 kawasaki ZX-6R Ninja

1 Answer

Blowing ignitor [cdi]


Hi, Gemmaj_p123 what is your ignition fuse doing, if your blowing CDI's then I would look for a short coming from the CDI on it's way to the coils, cracked or worn or chafed wiring for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Kawasaki, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Help fuse blows bike dies bad CDI
ignition fuse keeps blowing
Kawasaki Ninja ZX 6R Service Manual
OEM Parts for Kawasaki
Kawasaki Ninja ZX 6R Owner Manual

Apr 11, 2017 | 1999 kawasaki ZX-6R Ninja

1 Answer

Charging problem/no start 95 ninja zx6r


If lights dim when trying to start,Battery is to weak(may have 12 volts but not enough amps)
Bike dieing when removing power from jumper says the lighting coil on the stator plate is bad and this could also have killed the voltage regulator,Which would kill the battery by over charging it.
Hesitation and carbon smell could be from a non firing cylinder.

So,Take the battery and have it load tested (free at most auto part stores)
Check for power from the lighting coil on the stator
Replace the voltage regulator.


Please rate this fixya

May 15, 2009 | 1995 kawasaki ZX-6R Ninja

Not finding what you are looking for?
1995 kawasaki ZX-6R Ninja Logo

Related Topics:

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...