Question about 1993 Suzuki GSX-R 600

1 Answer

Gsx 1989 600 cuting out after 30 mins of running need to wait ten mins to cool before starting had carb stripped and rebuilt

Drive my gsx 600 for an hour then starts to splutter and cuts out then have to leave to cool down to start up again other wise it will not idle at all and even when tryng to rev it after trying to start it it runs well under 1000 revs thats with full throttle, carbs and injectors cleaned and rebuilt last week any help problem ongoing for two months

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,392 Answers

Sounds like your CDI box is going bad.

Posted on May 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car shuts off when it gets hot


your ignition coil are going bad, they need to be replaced. once the car gets hot the circuit shut down the car when hot. once they cool your riding again until they get hot. thats your problem. Good Luck

Jul 31, 2010 | 1988 Buick Electra

2 Answers

My Polaris freedom(jet ski) starts and runs good


Tools(1) A compression gauge (2) a spark gap tester.(3) A Clymer service manual for your engine. (you can purchase from your local dealer. I know all these are expensive but if your going to be a polaris tech you will always need them. Troubleshooting (1) check compression. Look at your Clymer manual for specific psi.all cylinders need to be over 100 lbs and equal each other within 5 lbs.(2) check spark. use a spark gap tester all cylinders should jump a half inch gap. if you have good compression and good spark, fuel is the problem nine
times out of ten.Ethanol gas is proven to stay stable in fuel systems for only 30 days in 90 + degree heat. Drain gas tank,clean fuel lines replace and replace all fuel filters. Polaris has a gravity filter under seat, clean it. Finally replace spark plugs, I know spark plugs probably don't look bad but this is a C.D.ignition. Fresh spark plugs means less resistance for the ignition system. The ignition system is week compared to automotive. Test drive polaris, if the problem is still there then there is further steps to take. If your polaris is fuel injected. Pull out your clymer manual. what is great about the Clymer Manual for Novice techs is it gives detailed info on your polaris. Troubleshooting tips and teaches you how your polaris works. If its carburetor then you should clean carburetors. Inside the carbs is another filter that needs to be cleaned. Its not difficult you just make sure you put everything back in proper order. take pictures if you need to.

Sep 18, 2009 | Boating

2 Answers

I just purchased a 94 Katana 750cc -- sort of a project bike. The bike has just under 13K miles and the previous owner stated that he had only put about 500 miles on it, in the last 2 years. When I first...


Sounds like it sat allot.. That causes problems with the carbs.. I would say it runs pretty good for sitting so much.. I would suspect the carbs need cleaning.. or maybe rebuilt,, jetted and synced.. Try some carb cleaner and work you way up from there..

Rate well ;o)

Jul 24, 2009 | 1994 Suzuki GSX-R 750 WR

1 Answer

94 750 begins running half thottle after 30 min


Fuel system has to hold 3 to 7 psi for ten minutes. fix any leaks. Check to make sure that your water temp sender is working right and or that the water system is not clogged.
If it thinkd that it is over heating the rev limiter will drop to a lower rpm. hope that helps

Jul 22, 2009 | Sport & Outdoor - Others

1 Answer

How do i reset antitheft?


30 min learn procedure turn on key wait 10 turn off attemp to start leave key on wait anouther ten key off attempt to start leave key on anouther ten turn key off attempt to start should be fine.

Jul 17, 2009 | 1996 Pontiac Grand Am

2 Answers

Neerly cuting out


Please have a look at your fuel pump.

May 22, 2009 | 1990 Ford Escort

1 Answer

When start bike up,it runs on 4 then onto 3 then 2 then cuts out.have stripped carbs rebuilt,balanced them.new plugs.runs fine till warm,think may be fuel problem. changed fuel tap.ballenced carbs with 2...


Are the cabies flooding or runing out of fuel? pull the choke on dose it help if it does low fuel.

Drain the bowls and see if there is plenty of fuel.....If its flooding turn the fuel off or block it when the engine starts to drop clys if it starts to pick up after 10secs or so the carbies are flooding

Feb 23, 2009 | 1988 Suzuki GSX-R 750 J

Not finding what you are looking for?
1993 Suzuki GSX-R 600 Logo

Related Topics:

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...