Question about 2005 Honda XL 125 V Varadero

1 Answer

Rear brake rubbing on disc

Rear brake rubbing on disk

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Honda Master
  • 767 Answers

You will have to replace the brake pads.

Posted on May 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

I have a 2003 toyota corolla S edition. I need to get the rear brakes replaced, but when I went to the parts store for rotors and pads, they told me I might need drums and shoes. How can I find out what...


The best way would be to remove the wheel and see if you have drums or discs. Disc brakes on the rear will look like the front brakes, as discs are required on the front of 1970 vehicles and newer. You will see the rotor which will be shiny where the pads have rubbed it. On a drum, it will look like a rusty metal bowl facing away from you. If you have custom wheels you may be able to see through the spokes, but dust guards will not let you tell from the back.

Mar 03, 2011 | 2003 Toyota Corolla

1 Answer

Hi just brought a pit bike in pieces,cant stop the rear brake calipar rubbin on the disk, what to do


take of the caliper push the pistons back with a vice grips clean them up a bit make sure they go in and out freely although they should stay out when pushed but shouldnt be rubbing also just thinking if only rubbing at a certain time when wheel is spinning could the disc be warped just a thought

Jan 29, 2011 | Motorcycles

2 Answers

Rear driver wheel has light reubbing noise when car in motion goes away when brakes are engaged. Is this brakes or barrings problem? Cost of repair?


hi this sounds like your brake pads have worn, or the brake shoes as well, if you have drum brakes on the back it will be shoes, if disk brakes will be pads+shoes (inside the disk) if it was the wheel bearing you would hear a loud humming noise not rubbing noise, is it a metallic rubbing noise or a rubber squeaking rubbing noise? just check condition of tyre on back if it is the squeaking rubber noise cost will depend on where you take it and if you do it yourself, possibly $40 to $50 at a garage/auto shop or possibly $20 to $30 if you do it yourself, this just depends ...hope this helps

Jun 05, 2010 | 1999 Toyota RAV4

1 Answer

Avid juicy ultimate, rear disc brake vibration and noise


It is a lose bolt somewhere, OR somebody has touched your rotor with their hands OR there is oil in the pads.

Check ALL your bolts for correct torque, buy new pads and Rubbing Alcohol and install them AFTER you clean off the rotor and your hands with the Rubbing Alcohol. TRY not to touch the rotor or the pads with your hands.

Dec 30, 2009 | Avid Juicy Ultimate Hydraulic Disc Brake ,...

1 Answer

Rear Disc brake is rubbingke


I had the same problem with my Hope mono-mini.
I took it into a shop and the guy showed my ruffly what to do.

On the side that the disk is rubbing you need to put a spacer on the bolt between the brake mount and the bike's mount.
If done correctly (or understood what i meant) it will pull the pad away from the disk a little bit and it will stop rubbing.

Hope it helps
Ed

Feb 01, 2009 | RTO Hope Tech X2 Mtb Mountain Bike Disc...

1 Answer

When parked on slope hand brake screeches on my 2yr old Dicovery


no problem ,its only a bit of noise so dont panic.its caused by either dust or **** in the rear drums underneath the rear brake disks. The rear brakes use disks on the rear but in the middle is brake shoes as its a combined disk and drum set up.Just need a good clean out and rub face of shoes with coarse sand paper.

Jan 31, 2009 | 1996 Land Rover Discovery

1 Answer

1100 Sport i rear disc


topped-up the fluid and put in new pads. The wheel spins OK when up on the stand and the brakes don't jam or even seem sticky when you try them with the back wheel off the ground —ie: calipers grip and open again as they should. But on the open road the pads still seem to rub just enough to generate a warm to hot disc. (And the pedal has the right amount of play before the brakes come on.) Since working over the caliper and re-bleeding the brakes etc it seems a bit better (no fading) but it still runs a little warm to hot. I'm wondering about a complete service for the rear Brembo popping the pistons out and changing the seals etc but before I do (and I have to say it all looks absolutely fine as it is), is there anything else I should be looking at / thinking of? The disc seems true and unwarped. I know there's some anxiety about getting the right type of Brembo pad for the rear brakes on these particular bikes. Some are too thick? The parts book says Frendo FD 72 GG 222, (Guzzi part no: 27 65 46 10) and the caliper itself is marked 204531.03 if that means anything. (Is this the P32 type?) The pads I have are supposed to be the proper Brembo ones with the code 98.5031.50. Is there something I don’t know about this? ,FWIW this was a problem with some Sportis when they were new, to the extent that I saw a couple with completely smoked rear brakes, overheated due to brake drag. Mine never did it, so I don't know the root cause. In at least one of the instances I saw, the dealer replaced the entire brake system under warranty. There was a separate and likely unrelated issue with rear brake disks that were machined with a step in the middle of the pad's foorprint on one side. At the time, I heard people attributing the brake drag problem to the disk problem, but I can't see a correlation. ,,,

Nov 10, 2008 | 1997 Moto Guzzi Sport 1100 i

3 Answers

Breaks


Your 89 Corolla has drum brakes at the rear.
The graciousness of a FIxYa rating would be greatly appreciated.

Nov 10, 2008 | 1989 Toyota Corolla 2 Door

Not finding what you are looking for?
2005 Honda XL 125 V Varadero Logo

357 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...