Question about 2000 Honda X- Eleven

3 Answers

No spark 110cc engine wont start

Changed coil spark plug cdi box relay and still dosent spark

Posted by on

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,567 Answers

Check the fuses. Next, check for spark but with a new spark plug. How good is the battery? If needed, add water to the battery cells enough to cover the top of the cell plates.Try a jump start from your car battery. Is the kill switch on? Check the operation of the ignition switch with a volt ohmmeter. You should be getting power into and out of the ignition switch.

If the bike doesn't start and run properly check the side stand kill switch. It kills the engine so that you don’t start out with the side stand down. Broken or out of adjustment, it would kill the spark. Check for a broken wire at the switch or coupler. Get a service manual and check out the electrical section. Some bikes have a diode integrated into the turn signal relay. Try moving the kill switch by hand. If that doesn’t work then wire a jumper around the switch to bypass it. If that doesn’t work, check out the relay.

Check the wiring harness. Did a wire come unplugged? Are all wires clean and with solid connections? Any abraded or pinched wires? Is the bike in neutral and the neutral light is lit up? If no neutral light, check the neutral switch and neutral switch wire on center casing.

Please rate this answer. Thanks

Posted on May 28, 2009

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 26 Answers

! i would check the ground as on a ohm meter it will show it has connection but under load it will not have proper connection. 2 check the voltage regulator and that it dose not short and let a over voltage or over current happen as it will burn out the CDI when you first try to start it.

Posted on Aug 01, 2015

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Ok i have a solution this happened on my dads 200cc roketa its a chinese bike but any way there is a thing on your bike called a cdi ignition which is like a second spark plug check and make sure that it is clicked all the way in if it helps cause we were dinking around with the carb and stuff but it can be just as simple as checking your wires.

Posted on Oct 07, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No spark on 110cc chopper four stroke what wire is for the spark


The blue with white stripe will go from stator to cdi box. Then black with yellow stripe goes from cdi box to coil will give you spark. If u have no spark and u u haven't changed cdi box or checked coil I'm going to bet that's ur problem. Hope this helps.

Apr 13, 2014 | Golden Technologies Companion II Travel...

1 Answer

No spark


check supp lie electricity to coil, if ok. but no spark. check ur ignite r in ur cdi box

Jul 01, 2013 | Yamaha 2006 Rhino 660 Auto 4x4

1 Answer

I have a 2010 Oliver City CPI, motor scooter. The engine wont start. The starter seems to work and theres gas in it. Tried the kickstarter and wont start. bad spark plug maybe?


My problem started like this,I found No spark so changed coil,cdi,voltage reg,eventualy found stator at fault,check pick up strip on flywheel and pick up pin on black pick up coil,this is fixed to stator and sends spark signal to cdi,mine were both rusty/dirty,I fitted a new stator,but now have light problems..stator seems to be to strong.

Jul 14, 2011 | 2011 Cpi Oliver City

1 Answer

I have a 1999 R1 it wont start at all. The motor turns but wont start. I have checked all the switches- clutchm stand, gear, engine, & fuses etc, I have tested the coil resistancem pickup resistance...


Hi, Tom and the usual suspects are:
1. Fuel tank empty.
2. Fuel supply valve/petcock turned off.
3. Fouled spark plugs.
4. Engine flooded as a result of overuse of the enricher.
5. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
6. Fuel valve/petcock or filter clogged.
7. Fuel line to carburetor or throttle body pinched or kinked.
8. Carburetor float stuck.
9. Fuel injectors clogged.
10. Severely discharged or damaged battery, you need 12.5 volts or better and be able to pass a load test if necessary.
11. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
12. Loose or corroded wire connection at the coil, battery or plug between ignition sensor and CDI box.
Spark plug cables in bad condition and shorting check for leakage in the dark, cable connections loose, or connected to the wrong cylinders.
13. Ignition timing incorrect due to a faulty MAP, CKP, O2, TPS, sensors.
14. Faulty neutral, clutch lever, or kickstand safety switch.
15. Faulty fuel pump or fuse or relay.
16. Faulty CDI box.
17. Tip over sensor needs a reset.
18. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://www.r1-forum.com/forums/103-02-03-r1-mechanical-help/318333-02-03-r1-cranks-strong-but-wont-start.html
http://www.r6messagenet.com/forums/r6-maintenance-technical/26969-bike-turning-over-but-not-starting.html
1998 1999 Yamaha YZF R1 Service Manual R1 Moto Data Project
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals

Apr 20, 2011 | 1999 Yamaha YZF-R1

1 Answer

I have no spark on a ducar 110cc quad


test all connections,for strength by bending them

Sep 22, 2009 | Quad 47 cc / 49 cc Pocket Mini Bike...

2 Answers

Wont start


Check your rotor, distributor cap, coil wire.did you change the module inside the distributor cap.

Jul 20, 2009 | 1996 Ford Explorer

2 Answers

1996 zx11 getting sprk to one bank only


Hi and welcome to FixYa,

The voltage on the green wire must be pulsating when cranking/starting the bike, not steady. Confirm by similarly testing the voltage on the black wire on the left ignition coil. If the green still reads a constant voltage, then the CDI is faulty; to be more specific, most likely that the switching tansistor inside the CDI that drives the right ignition coil has shorted.

Good luck and thank you for asking FixYa.

Jul 09, 2009 | 1996 kawasaki GPZ 1100

1 Answer

Wont spark


i think its the coil

May 21, 2009 | Pit SSR 110CC Pro Beginner Bike

2 Answers

Bike wont fire. has no spark


Sounds like you have all the right new parts. I would double check the wiring. Sounds like that is where the problem is at unless the new coil is bad.

May 10, 2009 | Pit SSR 110CC Pro Beginner Bike

Not finding what you are looking for?
2000 Honda X- Eleven Logo

827 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...