1995 Honda CB 750 Nighthawk how to bypass or delete the side stand switch?

SOURCE: 92 honda cb 750, oil light will not go out, bike won't start

Look around the engine oil drain plug and fill area and see if there is an electric sending unit( small plug with a prong for a wire) that is screwed into the engine if so check to see if its unplugged / could be a low oil cut off switch that kills all power to the ignition if the oil is to low ( or the wire is unplugged)

SOURCE: where is the idle screw for cb nighthawk 750

follow your accel cable to the carb. move the throttle till you see where the linkage moves. look around the linkage to see what it hits on at no throttle. that will be your idle screw

SOURCE: 1995 Honda Nighthawk 750 Neutral Light Problem

Hi and welcome to FixYa,

Your decribed problem could either be a neutral switch about to fail (least likely) or a loose grounding issue (most likely).  This switch must read 0 ohms to ground when in neutral and infinity (no reading) when in any gear.

Good luck and thank you for asking FixYa.

SOURCE: 93 Honda Nighthawk 750, when I pull in the clutch

Hi and welcome to FixYa,

Check / replace the diode that connects the clutch switch and neutral switch. The diode normally would have green/red and light green/red wires.

Good luck and thank you for asking FixYa.

SOURCE: 1993 honda nighthawk 750 tach. not working

i have found in the past its the cable not the tacho