Question about 2011 Bajaj Pulsar 150

1 Answer

Engine cutoff as accelerate

My pulsar 150 2003 model starts normally in a single kick bt as soon i accelerate the speed engine cut off...pls help..

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Bajaj Master
  • 42,915 Answers

Hi, Anonymous and the usual suspects are:
1. Throttle cables misaligned or misrouted.
2. Damaged or restricted fuel tank venting system.
3. Inlet system air leak.
4. Vacuum piston malfunction.
5. Accelerator pump leaking or no output.
6. Plugged bowl vent.
7. Fuel level in bowl too low.
8. Restricted fuel supply passages.
9. Plugged jets or passages.
10. Worn or damaged needle or needle jet.
12. The enricher valve not seated or leaking.
For more information about your issue please visit the websites below. Good luck and have a nice day.
http://88.198.249.35/d/Pulsar-150-Workshop-Manual.pdf

Posted on Nov 18, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 12 Answers

SOURCE: rate of pulsar 150 engine

8000 rpm is the rate of pulsar 150cc

Posted on Jul 02, 2009

dtci80
  • 125 Answers

SOURCE: In pulsar200 2009 model, How to increase the pickup,power,Speed?

Hi,

Check your gasoline filter if there's one, check the air filter, also check or just replace your spark plug(s)...

Most other things that should be done by a mecanic are like maybe cleaning the carburator(s), checking the ignition, see wether there is damage inside the cilinder...

I hope this is helpful, and greetings,

Olivier.

Posted on Oct 22, 2009

Testimonial: "thank you sir"

  • 1 Answer

SOURCE: My Bajaj Pulsar 150 starts normally, but when i

it may be Engine jam problem,check the OIL,
secondly it may be air chocking up in between ur engine.open up ur tank gve a hard air blow into it & close immediately
3rd water in tank,contact mechanic to clean up ur tank

Posted on Jun 01, 2010

  • 3567 Answers

SOURCE: i like pulsar and i

If at all possible, buy a Honda, Yamaha, Kawasaki or Suzuki and away away from Bajaj. The Japanese bikes are MUCH better. Bajaj bikes are not dependable and repair parts are hard to find.

Posted on Sep 11, 2010

  • 3 Answers

SOURCE: I have pulsar 220 dts fi.My bike stops when

it just your carb bud had same probem with my engine as soon as i put revs into it it would cut out so i fiddled with the carb and adjusted it and now it works like a beauty

Posted on Apr 21, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuel cutoff switch in a 2004 nissan quest? The car is not transferring the gas through the plump. It did yesterday. And now you cannot hear the plump. I just want to turn off the fuel cutoff...


i know that the previous gen quest had the fuel inertia RESET switch on the driver side kick panel...

fuel is cutting off via the ECM for your generation though

"If the engine speed is above 1,800 rpm with no load (for example, in neutral and engine speed over 1,800 rpm) fuel will be cut off after some time. The exact time when the fuel is cut off varies based on engine speed. Fuel cut will operate until the engine speed reaches 1,500 rpm, then fuel cut is cancelled."

http://www.nicoclub.com/FSM/Quest/2004_Quest/ec.pdf

EC 33

do you have trouble codes ?

Mar 03, 2015 | 2004 Nissan Quest

1 Answer

My pulsar 150 dtsi does not self start , when i press the self start switch only relay sound comes but there is no sound of starter motor ,, bike starts with first kick only , so engine is ok ,, bt i have...


Check the connection of wires onto the battery terminals are not lose, wiggle them, they should not move. Check the large wire from the negative side of the battery to the bike frame, check its got a clean connection at the end that bolts to the frame.

Dec 12, 2013 | 2005 Bajaj Pulsar 180

1 Answer

The pink coloured hose from carburettor of pulsar 150 connected to where what area? and actually the problem in my bike the hose open to amosphere now. while the starting of engine it starts but rpm g


Hi, Uthaman the pink tube is an overflow tube from the carburetor and vents to the atmosphere and the usual suspects are:
1. Idle speed improperly adjusted.
2. Inlet system air leak.
3. Leaking accelerator pump.
4. Loose low-speed jet.
5. Plugged low-speed jet.
6. Contaminated or plugged low-speed circuit.
7. Enrichner valve is not seated or leaking.
For more information about your issue please visit the websites below. Good luck and have nice a day.
http://88.198.249.35/d/Pulsar-150-Workshop-Manual.pdf

Nov 30, 2013 | 2011 Bajaj Pulsar 150

2 Answers

I have pulsar 220 dts fi.My bike stops when accelerated.It starts but as soon as i accelerate it stops...I am facing this problem since month.Can you please suggest a solution for this.


air got filled in your bike...check the pipe of the petrol on the left side and see if anything stops the fuel from reaching the engine...

Jun 29, 2011 | 2008 Bajaj Pulsar 220 DTSFI

2 Answers

I have pulser 150 ,but suddenly it has stopped and an engine is not working and kick road has also got strucked.so what is the problem exactly pls give me suggestion...


if the kick start is stuck too i think you may have a seized engine, when was the last time you changed oil, etc. you will need a full top end rebuild and a inspection of bottom end to see if that is damaged too



Jan 13, 2010 | 2005 Bajaj Pulsar 150

1 Answer

Starting problem after 2-3 days pls what may be


whenever u shutdown the engin put petrol to off... sure it'll get starts in one kick try once....

Oct 14, 2009 | 2007 Bajaj Pulsar 150

2 Answers

No acceleration at high RPM's


It's probally the fuel cutoff.If it's in Park Or Nuetral this is a normal condition to protect the engine from overevving.If it doesn't do it in gear that's what it most likely is.hope this helps

May 16, 2009 | 1999 Pontiac Grand Am GT

1 Answer

Momentarily Sluggish Acceleration


Are you loosing power to the ecu when the car is shut down? most cars with an ECU that controls timing, fuel, or boost can be forced to relearn the car if the ECU looses power (called a "limp" mode). I'd look into this. Also are you getting any check engine lights? considering the description of the problem, this would help to diagnose. Try getting the car started and running normally, then turn the car off but do not kill the power to the car, just stop the motor from running...Fire the engine back up and try to give the car a good stomp on the gas and see if you get the same sluggish problems...my 2 cents... Good luck future auto DIY's

Apr 16, 2009 | 2003 Volkswagen Jetta TDI

Not finding what you are looking for?
2011 Bajaj Pulsar 150 Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bajaj Experts

sachin sharma
sachin sharma

Level 2 Expert

171 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4535 Answers

Are you a Bajaj Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...