Question about 2003 Yamaha YZ 450 F

1 Answer

Blinking Reverse light

Reverse light blinks off and on while running. Plenty of gas and is not on reserve.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Renaissance:

    An user who is expert in 3 categories / brands.

  • Yamaha Master
  • 1,190 Answers

Bad connection or bulb !

Posted on Jan 03, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why isn't it igniting?


Is the engine turning, do you know there is plenty of gas in the tank or do you smell it? If you smell it & the motor is turning it's already flooded. STOP, you oil is now 50/50 gas & oil if you have no spark. That's what it sounds like. It's a long shot without looking but you may need a coil pack, wiring to coil NG, ignition relay NG, wires, plugs ? You need to get it ckd out. Don't keep turning it if it's not starting. PS get an oil chg when all is well. Good luck

Oct 24, 2015 | Heating & Cooling

1 Answer

Furnace problems


On - OK
1 Blink - Ignition failure. Check Gas flow, gas pressure, gas valve, flame sensor.
2 Blinks - Closed pressure switch. Check pressure switch (stuck in closed position).
3 Blinks - Pressure switch - failre to close. Check venter, pressure switch, vent blockage.
4 Blinks - Open limit switch. Main limit or aux limit are open. (My comment - Means overheating in chamber. Often result of blocked intake air. Bad filter. In my case, plastic wrap had been sucked into the intake. )
6 Blinks - False flame sensed. Check sticking gas valve.
Rapid continuous blinking - Incorrect twinning, incorrect primary polarity. Reverse transformer secondary leads, reverse primary wires.

Closed pressure switch can be from dirty combustion vents, bad chamber pressure - like missing screws, maladjusted gas pressure, failing pressure switch, loose hoses, moisture in the hoses or fan blades The switch need to be closed to ge the unit to work

Jan 23, 2008 | Goodman GMS90703BXA Heater

1 Answer

1985 chevy s-10 2.5L no gas to injecter. replaced injector, ignition control module, rented a noid light system and there was no blinking from the noid light. Truck has plenty of pressure from the throttle...


SOUNDS RIGHT THE PICK UP COIL CONTROLLS PULS SIGNAL FOR THE ECM TO FIRE INJECTORS , BEST MOVE WOULD BE TO REPLACE THE DISTBUTOR AS A UNIT.MAKE SURE YOU MARK EVERY THING SO YOU PUT IT BACK RIGHT

Oct 16, 2013 | 1985 Chevrolet S-10

1 Answer

My chrysler town and country reverse light blinks when the car is running


does it do it when its in gear or just in nuterall its probably a dodge reverse switch when its ticking over the vibration will be making the switch jump about causing the lights to come on also could be the wiring comming loose wiggle the gear stick about with the cars ignition on so all the light work and get some one to stand at the rear of the car to see if they are comming on while your wigaling if they still come on its the reverse switch hope this helps ivan

Oct 03, 2012 | 2001 Chrysler Town & Country

1 Answer

The clean light is blinking and beeping. There is less than 2 cups of Vingegar still in the water reserve.


Sounds likea serious PIECE. Try running it on the regular mode with vinegar, or you could even use hot water.

Jan 22, 2011 | Mr. Coffee 072179228578 12 Cup Coffee...

1 Answer

Engine light is blinking. Car is running rough and sucking gas!


Light blinking means a malfuction in computer system, need to run a diagnostic on computer and retrieve codes to futher repair

Feb 06, 2010 | 1999 Volkswagen Passat

1 Answer

Blinking Oil light. Despite plenty of oil.


It may mean you have any of the following:
A faulty sensor
A leak (sensor is picking up a reduction in pressure)
A faulty oil pump

Oct 02, 2009 | 1990 Honda Accord

6 Answers

My gas gaueg on my cbr 600 f4i is not on


I am having the same problem, the electric gas gauge turns on while pressing the ignition switch. once the bike is idling the screen is blank where the fuel level should be displayed.

Sep 24, 2009 | 2002 Honda CBR 600 F(4)i

2 Answers

Is there a fuel reserve on a 99 victory


If it has a fuel petcock under the tank to shut the gas off, then when you turn it straight down it should be in reserve.

Sirwriter

May 24, 2009 | 2002 Victory V 92 C

3 Answers

Car problem


rover vitesse has shut down all ignition lights no power to starter

Dec 10, 2007 | XRS-757 Radar Detector

Not finding what you are looking for?
2003 Yamaha YZ 450 F Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1147 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...