Question about 2007 Harley Davidson FLHTCU Ultra Classic Electra Gilde

1 Answer

2007 flhtcu rev's high when motor is running

I changed the tps and the aic but my bike still revs high occasionaly,up to around 2000 rpms

Posted by Anonymous on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Harley Davidson Master
  • 43,096 Answers

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 150 Answers

SOURCE: I have a 1997 FLHRI The bike wants to rev and runs hot

I guess the guy above does not know that FLHR-I means injected no carb anyway..You problem is a heat sensor. Its reading cold when the bike is heated up an should be kicking down. Its on the back of the front jug left side. Unscrew it and replace it. Easy fix.

Posted on Jun 14, 2009

finish line
  • 207 Answers

SOURCE: 2002 heritage softail classic revs during shifts

is the throtle cable free it my be hung up under the tank or somewhere in the routing

Posted on Jun 23, 2009

  • 371 Answers

SOURCE: The bike only runs with the choke out and cuts off

My guess is you either have a dirty carburator or you have a plugged jet that is limiting your gas flow. If you have a gas filter, try and replace that or see if there is something in the fuel tank that would plug up the gas flow to the carb.

Posted on Oct 06, 2009

Testimonial: "Thanks, that gives me a place to start."

  • 4565 Answers

SOURCE: setting hot idle for 2000 harley davidson

Idle speed on a fuel injected bike must me set by the dealer if it's still stock. I think you can set it yourself in you have a Power Commander on the bike but I don't know how to work with that unit.

Posted on Oct 07, 2009

  • 4565 Answers

SOURCE: Hi. I have the 2007 sportster xl 883 and I find

If you Sportster is fuel injected, the dealer will have to service that problem.

Posted on Oct 18, 2009

Testimonial: "Many thanks"

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

RPM revs high and changes while in neutral

Check the air intake sensors, called MAF or MASS air flow. They have temp and baro devices in them.

Feb 05, 2014 | 2007 Toyota Corolla S

1 Answer

My 96 ford taurus revs high when starting then works it way from 1500 or more down to 800 but fluctuates from 800 to a little over 1000. When putting car in rverse or drive from park engine revs up to...

You need to clean the IAC again and also the throttle valve and bore, use only CRC brand Throttle body cleaner. After they are thoroughly cleaned disconnect the battery for 5 min's and then drive the car in varying condition for a few days. If that doesn't cure the issue you have more serious problems and will need a scan tool to look into the readings from the MAF, TPS and ECT sensors. High idle cold start is normal then slowly dropping after a few minutes. I assume you never had a check engine light. Correct?

Mar 24, 2017 | 1996 Ford Taurus

2 Answers

In cold weather thecar starts`ok but the rpms go to 2000 and slowly returns to around 1200 and stays there

idle air control valve is suppose to let the rpms go high to warm the motor to normal temp,and then drop it to 1200 rpms

Jan 07, 2013 | 2000 Saturn SL

1 Answer

My 1998 Explorer on startup idiling to high, it occasionally revs up and down while idiling. Is there a trottle position sensor that controls the idiling rpm?

there is a tps located on the intake where the inlet tube for air intake connects, it would be on the left side of the throttle body. does the trk run rough on idle? up/down sputter sometimes stall? Is check engine light on? if no light,check all vacuum lines for cracks/splits loose fit. do this by spraying carb choke cleaner on connections motor rpms will change if leak is present. also spray around perimeter of intake housing where mates with lower intake if engine revs you have bad intake gasket.I Just replaced upper and lower intake on my 98 and shazaam, runs like it should. but do your checks first,unessasary fixes are costly and **** you off.

Jan 03, 2011 | 1998 Ford Explorer

1 Answer

Integra revs RPMs when idling

idle air control motor or just a plain old vacuum leak

Jul 21, 2009 | 1992 Acura Integra Hatchback

1 Answer

Engine revving problem

Sounds like your idle speed is way too high, should be somewhere around 800-1200 rpms. I would check for vacuum leaks.

May 18, 2009 | 1991 Toyota MR2

Not finding what you are looking for?
2007 Harley Davidson FLHTCU Ultra Classic Electra Gilde Logo

184 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers


Level 3 Expert

4340 Answers


Level 3 Expert

76673 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides