Question about 2000 Harley Davidson FXDL Dyna Low Rider

1 Answer

Wiring diagram ok have fxdl harley lowrider 2000 model pulled alarm system out now its not fireing when i try to start it put a cheap ignition switch on it aftermarket and it ran fine for weeks until it just died one day so then i pulled alarm system out still no fire starter sticks also sometimes its a wire somewhere but why wont it get fire to start fuses are good also

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Harley Davidson Master
  • 39,997 Answers

Hi Mitch, you have done what alot of Harley owners only dream about. That being said the usual suspects are:
1. Severely discharged or damaged battery.
2. Loose, corroded or broken battery cable.
3. Alternator not charging or below normal rates.
4. Failed ignition coil, ignition/electronic module.
5. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor.
6. Faulty ignition switch.
7. Water or dirt in fuel system, carburetor or filter.
8. Fuel tank vent system plugged or gas cap not venting.
9. Fuel tank empty.
10. Fuel valve vacuum line broken or carburator vent line closed off.
11. Restricted, blocked or kinked fuel line.
12. Failed fuel pump, pressure regulator and or fuel injectors.
For a prime suspect please visit website below:
Good luck
Big Twin Carb EFI DTC Intructions codes Harley Davidson Forums Harley...

Posted on May 09, 2015

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

rselvy
  • 83 Answers

SOURCE: Rear cylinder not firing

The first thing I would do is replace the spark plugs again. You can foul a plug and it will cause you more problems than you can ever imagine. I see you have done all the logical things that I would recommend but I did not see you have replaced the plugs after the 200 miles. You would be surprised at how many times a $2.00 part can cause fits beyond belief.

Posted on Dec 08, 2008

v2iper
  • 150 Answers

SOURCE: 1999 road king wont start

Its your fuel pump if you can't hear it. And its inside your tank. Not a hard fix if you have a book that tells you how to remove it. Alot of procedures to follow to get it right. And yes it does work off a relay.

Posted on Jun 14, 2009

wd4ity
  • 4565 Answers

SOURCE: I have a 1979 harley

The original wires, one blue and one white, were with the points ignition. The white wire should be the "Hot" wire. Now, look at your wiring diagram. The two white wires should go together to one side of the coil and the blue to the other. There is no positive or negative side of the coil, just two small primary winding terminals. Make sure the white wire from the ignition system is the "hot" or power wire for 12 volts. If you connect the ignition unit up backwards, it will damage it. To make sure the white wire on the bike is the hot wire, simply turn the ignition switch on and check this wire with a test light or volt meter. It should show battery voltage on it. That should be your setup, two white wires on one end of the coil and a blue wire on the other.

Good Luck
Steve

Posted on Nov 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is the wiring different on a 2001 fxdl from a fxdw


Sorry I cannot help at this time but if you go to an H-D dealership a shop foreman may be able to help OR it may be a fairly cheap solution to just but a service manual.

May 20, 2014 | 2002 Harley Davidson FXDL Dyna Low Rider

1 Answer

My 2000 dyna lowrider want idle and skips and pops when riding


Hi Anonymous, and the usual suspects are:
1. Spark plugs in bad condition or partially fouled.
2. Spark plug cables in bad condition or leaking.
3. Spark plug gap to close or to wide.
4. Faulty ignition coil, module and or sensor.
5. Battery nearly discharged.
6. Damaged wire or loose connections at battery terminals,
ignition coil, or plug between ignition sensor and module.
7. Intermittent short circuit due to damaged wire insulation.
8. Water or dirt in fuel system, carburetor or filter.
9. Fuel tank vent system plugged or carburetor vent line closed off.
10. Carburetor controls misadjusted.
11. Damaged carburetor.
12. Loose or dirty ignition module connector at crankcase.
13. Faulty MAP, CKP, and or CMP sensors.
14. Incorrect valve timing.
15. Weak or broken valve springs.
16. Damage intake or exhaust vale.
For a prime suspect please visit website below:
Big Twin Carb EFI DTC Intructions codes Harley Davidson Forums Harley... Good luck

Feb 04, 2014 | 2000 Harley Davidson FXDL Dyna Low Rider

1 Answer

No turn signals no brake lights no horn no speedo on a 2000 dyna fxdl


Hi Anonmous, get out your test light and start at the ignition switch and work your way to switch housings and beyound. If you disconnected the battery for any reason you might have a TSM/TSSM issue. For a free wiring diagram please visit the website below:
Harley Davidson Wiring Diagrams and Schematics
Good luck

Feb 04, 2014 | Harley Davidson FXDL Dyna Low Rider...

1 Answer

Marker lights


Hi Anonmous, get out your test light and start at the ignition switch and work your way to switch housings and beyound. If you disconnected the battery for any reason you might have a TSM/TSSM issue. For a free wiring diagram please visit the website below:
Harley Davidson Wiring Diagrams and Schematics
Good luck have nice day and keep on smiling

Feb 03, 2014 | Harley Davidson FXDL Dyna Low Rider...

1 Answer

No turn signals no brake lights no speedo lights no horn on a 2000 dyna fxdl


Hi Anonmous, get out your test light and start at the ignition switch and work your way to switch housings and beyound. If you disconnected the battery for any reason you might have a TSM/TSSM issue. For a free wiring diagram please visit the website below:
Harley Davidson Wiring Diagrams and Schematics
Good luck and enjoy the rest of your day.

Feb 03, 2014 | Harley Davidson FXDL Dyna Low Rider...

1 Answer

No turn signals no brake lights no horn no speedo light on a 2000 dyna fxdl


Hi Anonmous, get out your test light and start at the ignition switch and work your way to switch housings and beyound. If you disconnected the battery for any reason you might have a TSM/TSSM issue. For a free wiring diagram please visit the website below: Harley Davidson Wiring Diagrams and Schematics
Good luck

Feb 03, 2014 | Harley Davidson FXDL Dyna Low Rider...

1 Answer

Wiring diagram


Hi Mitch, for a free wiring diagram please visit the website below and good luck. Harley Davidson Wiring Diagrams and SchematicsHave a nice day.

Jan 02, 2014 | 2000 Harley Davidson FXDL Dyna Low Rider

1 Answer

2000 harley lowrider fxdl turns over but wont start


Hi Anonymous, when checking for spark the CKP needs to measure the compression bump in order to send the correct signal to the ICM/ECM so always check for spark with either a third plug grounded or lift the end of the plug boot 1/2 " off one of spark plugs that are in the head. and the usual suspects are:
1. Fuel tank empty
2. Fuel supply valve turned off.
3. Fouled spark plugs.
4. Engine flooded with gasoline as a result of over use of enrichner.
5. Fuel valve or filter clogged.
6. Vacuum hose to automatic fuel supply valve disconnected, leaking, or pinched.
7. Discharged battery, loose or broken battery connections.
8. Loose wire connection at coil, battery or plug between ignition sensor and module.
9. Spark plug cables in bad condition and shorting, spark plug cable connections loose,
or cables connected to wrong cylinders.
10. Ignition timing incorrect due to faulty ignition coil, ignition module, or sensors " Manifold Absolute Pressure" "Camshaft Position Sensor" "Crank Position Sensor" "Brake Apply Sensor
11. Engine lubricant to heavy ( winter operation )
12. Sticking or damaged valves or push rod wrong length.
13. Primary cam sproket spline sheared or missing spacer.
14. Security alarm system not disarming.
For a primary suspect please visit the website below: Good luck
Big Twin Carb EFI DTC Intructions codes Harley Davidson Forums Harley...

Oct 10, 2013 | Harley Davidson Motorcycles

1 Answer

Where can i find a wire diagram for a lowrider 04


what is it that you trying to do i can help you if you help me understand what it is that you need done.
most harley wiring and parts diagrams you need to buy the book for.
Mark
(361)947-3200

Jun 04, 2010 | 2003 Harley Davidson FXDL Dyna Low Rider

Not finding what you are looking for?
2000 Harley Davidson FXDL Dyna Low Rider Logo

131 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gills Lango

Level 2 Expert

195 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...