Question about 2011 Harley Davidson FLTRUSE CVO Road Glide Ultra

1 Answer

How to remove the battery from a 2012 Roadglide

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

  • Harley Davidson Master
  • 44,792 Answers

Hi Anonymous, remove seat, remove battery. Good luck

Posted on May 16, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Change battery in 2012 silverado 2500


take positive and negative cables off of battery. now take battery hold down bolt out from back side of battery nearest to the cab. now lift battery out.

Nov 25, 2013 | 2012 Chevrolet Silverado 2500HD Work Truck...

1 Answer

Harley davidson 2005 roadglide headlight fuse replace it. where is it.


Hi Anonymous, 1992 and later Touring Models, fuel pump fuses and relays will be behind the right side panel, starter and ignition relays will be under the seat behind the battery, everything else will be behind the left side panel to access fuses pull back on the front two locking tabs and slide the cover up. Good luck and have nice day.

Jan 27, 2013 | Harley Davidson Motorcycles

1 Answer

2011 roadglide how to install a new heel toe shifter


Hi Anonymous, remove pinch bolt and old heel/toe shifter, then install new one and torque bolt to 10 ft lbs. Have nice day.

Dec 26, 2012 | 2006 Harley Davidson FXDBI Street Bob

1 Answer

04 roadglide want start. Replaced battery, now i here a clicking noise by the starter when i press start button.


Hi Anonymous, first when checking anything in the starter circuit you must make sure the battery connections are clean and tight especially the negative cable at both ends and has a 12.5 volt or better charge. It must not fall below 9 volts during the cranking procedure with a volt meter hooked up. If it does fall below 9 volts do a proper load test on the battery and replace if necessary. Second replace the starter relay cheap $6 and make sure it's well grounded and getting 11.5 volts or better to activate. Third remove the back cover of the starter solenoid and de-arc/refurbish the contact plate and shoes making sure they are tight. If it still chatters replace the solenoid. Good luck and have nice day.

Nov 10, 2012 | 2004 Harley Davidson FLTRI Road Glide

1 Answer

Roadglide stutters when warm at 2500 rpms


Hi Anonymous, and the usual suspects are:
1. Spark plugs in bad condition or partially fouled.
2. Spark plug cables in bad condition or leaking.
3. Spark plug gap to close or to wide.
4. Faulty ignition coil, module and or sensor.
5. Battery nearly discharged.
6. Damaged wire or loose connections at battery terminals especially the negative cable at "BOTH" ends, ignition coil, or plug between ignition sensor and module.
7. Intermittent short circuit due to damaged wire insulation.
8. Water or dirt in fuel system, carburetor or filter.
9. Fuel tank vent system plugged or carburetor vent line closed off.
10. Carburetor controls misadjusted.
11. Damaged carburetor or intake seals.
12. Loose or dirty ignition module connector at crankcase.
13. Faulty MAP, CKP, and or CMP sensors.
14. Incorrect valve timing.
15. Weak or broken valve springs.
16. Damage intake or exhaust valve.
For a prime suspect please visit website below.
Good luck and have nice day.
Harley Davidson Wiring Diagrams and Schematics

Aug 18, 2012 | Harley Davidson Motorcycles

1 Answer

Need to remove rocker switchs on my roadglide so i can paint inter fairing parts


Rocker switches usually just pop in and out. gently try to raise the metal frame around the switch top or bottom first

Oct 27, 2009 | 2000 Harley Davidson FLTR-FLTRI Road Glide

Not finding what you are looking for?
2011 Harley Davidson FLTRUSE CVO Road Glide Ultra Logo

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Mike

Level 3 Expert

4341 Answers

yadayada
yadayada

Level 3 Expert

77202 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...