Question about 2002 Harley Davidson FLHR - FLHRCI Road king

1 Answer

Oil leaking from crank case

1995 softail crank case leaking on the back side of case above the drain plug. just started it today. while warming up I noticed it dripping. cannot feel or see a crack, but it's leaking. again only when running.

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Harley Davidson Master
  • 40,627 Answers

Hi Anonymous, I would take it over to your local dealer or reputable shop and let them evaluate the leak. Good luck

Posted on May 15, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2712 Answers

SOURCE: oil drain plug

oil tank

Posted on Nov 20, 2008

  • 91 Answers

SOURCE: oil drain plug

its not a plug its a hose look under the tank on the pipe side, look for the hose thats goes to the bottom frame rail (tube) thats the drain hopes this helps

Posted on Jan 01, 2009

rylee_smith
  • 8619 Answers

SOURCE: oil drain plug

Hi
It is located on the right side just under the oil tank ; if you follow the rudder hose that exits the rear right side of your oil tank it leads to the bottom of the frame under this is the oil plug. This hose has a plug clamped to the end of it or stuck into a prug that is welded to the frame.
After this unclamp and pull the plug to make sure that you have the dipstick out before pulling it loose.

Please do rate the solution as "FixYa" if found useful and revert for further assistance.
Thanks Rylee

Posted on Mar 27, 2009

OneRide
  • 379 Answers

SOURCE: have devolped a small leak on 2005 road king.

Spray it off at the car wash to remove all the oil , then spray Right Guard (Yes, that Right Guard) on the area of the leak. It will show up, but you may not be able to see exactly where. There are a couple spots where it can leak. The jackshaft oil seal, as you said, transmission output shaft (clutch shaft) on the trans itself, the inner primary seal where the trans shaft runs thru, the engine sprocket shaft oil seal, inner primary O-ring, the bolts that hold the inner primary to the engine/trans, the primary chaincase gasket and the drain plug. Hopefully when you get it apart, you will see which seal is leaking. If not, replace them all. Still want to fix the leak? LOL

Posted on Jun 30, 2009

  • 5 Answers

SOURCE: oil drain plug

Its at the back of crank box right hand side of bike attached to bottom of frame in a sprung clamp just before the softtail swingarm- black hose with a plug and hose clip

Posted on Jul 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Harley leaking oil


Change the defective oil filter

Apr 19, 2014 | 2000 Harley Davidson FLSTC Heritage...

1 Answer

Changing the gear oil ?


see this instruction. God bless you
    • 1
      Park the Honda Foreman on flat ground and leave the engine running for 5 minutes to allow the engine to warm up. Place the oil drain pan under the crank case drain plug. Turn the engine off.

    • 2
      Remove the drain plug from the under side of the crank case using the ratchet set. Allow the engine oil to drain into the oil pan. Replace the plug to the bottom of the crank case and tighten the plug using the ratchet set.


    • Sponsored Links

    • 3
      Remove the small screw from the side of the crank case using the Allen wrench. Remove the cap labeled "OIL" from the top of the crank case. Insert the funnel into the hole where the oil cap was.

    • 4
      Pour Honda 4-stroke engine oil into the funnel until the oil starts to come out of the hole where the small screw was on the side of the crank case. Once the oil starts to come out of the hole, stop pouring and replace the screw. Remove the funnel and replace the oil cap to the top of the crank case.


Read more: http://www.ehow.com/how_6512146_change-oil-honda-foreman.html#ixzz2ZPlA2Cu0

Jul 18, 2013 | 2004 Honda VT 750 Shadow Aero

1 Answer

Oil change 1994 Cadillac Eldorado


well let me see you have 4.6L engine you need 7.5 quarts of oil with new oil filter.to do the oil change you need large drain pan and oil filter wrench and a metric wrench to remove oil drain plug you need a funnel also.you need first start engine let it run for 5 minutes to warm up thin out the oil so it will flow better.once engine warm up.turn off the engine.open you hood.now safely raise support vechicle on jack stands make sure vechicle parked on solid level ground.place large drain pan under oil pan remove oil drain plug you need a 15m wrench remove drain plug let all old oil drain out until you see slow drip then reinstall oil drain plug dont over tighten drain bolt.then place drain pan under the oil filter then remove oil filter using oil filter wrench or large channel lock pliers.once you remove oil filter wipe oil filter seal surface with clean paper towel.take new oil filter add oil to new filter then install new oil filter hand tight take filter wrench turn oil filter one half more turn dont over tighten will damage oil filter seal.make sure oil pan drain plug is in place. then lower vechicle. remove oil filler cap on the valve cover add new oil to the engine using a funnel to keep from spilling oil all over the valve cover and exhaust manifold.add all 7.5 quarts to oil crank case wait until oil settle down in crank case check oil dip stick oil level should be at the full mark on oil dip stick.dont over fill crank case.once you finished oil level correct crank engine check for oil leaks at oil filter and oil drain plug. if engine running okay you see no oil warning lights you ready wheel and deal.

Nov 20, 2011 | 1994 Cadillac Eldorado

3 Answers

2002 FATBOY, AFTER SITTING A WEEK, CHANGED OIL AND FILTER,VERY LITTLE OIL CAME OUT, ASSUMED ENG. OIL LEVEL WAS LOW, BUT NO OIL LEAKS DETECTED. ADDED 3 QTS , ROAD BIKE ABOUT 20 MILES. NOW ENG. IS LEAKING...


The Oil Capacity is 3.5 qts. (3.3 L) are you sure you pulled the right drain plug, and drained the ENGINE oil? The engine oil drain hex bolt is located on the right side of the motorcycle and is removed/installed horizontally.
Transmission oil drain hex bolt is located on the left side of the motorcycle and is removed/installed vertically.

Jul 25, 2011 | 2002 Harley Davidson FXST Softail Standard

1 Answer

2003 Fatboy while winterizing drained the oil very little came out however there was oil in filter..New filter,filled with oil started sounds like usual then the oil shot out of the cap where you insert...


On the softail model Harley Davidson's the oil tank is external and sits up higher than the engine crank case and oil pump. when these bikes sit for an amount of time the oil gravitates from the tank to the crank case. starting may seem sightly harder and seem like the battery is going dead. the bike should be started in knowing that you had oil in it to start with and no giant leak puddle underneath of it. warm up the engine and then drain the oil out of the tank. the reason why your filler cap popped off is because you had probably 2 1/2 to 3 quarts to much engine oil in the bike. so drain the oil from the tank at the drain pug at the bottom of the hose on the high (right side ) of the bike where the swing arm meets the frame (it is a 5/8 socket) put the drain plug back in run the bike for about 5 minutes inspecting with a flashlight continuously that oil is circulating back into the tank. then dran it again and replace with new oil.

Dec 10, 2010 | Harley Davidson Harley-Davidson Motorcycle...

1 Answer

The oil in my heritage softail has drained in to the crank case.why did this happen? is safe to start it up or do i have drain the crank case first. jake


there is a check valve that prevents oil from flowing back into the crankcase, i would not trystarting it with the oil in the crankcase, could damage seals etc,

Nov 11, 2010 | Harley Davidson FLSTC Heritage Softail...

1 Answer

I have a 2009 Harley Davidson Nighttrain which I am changing oil in and I found what seems to be at least 2 drain plugs for the oil. Is this right? One was on the frame back towards the rear tire under the...


There are indeed two drains under the bike. One is for the engine oil and one is for the transmission lubricant. Since your bike is basically a Softail, the one your looking for is the one on the frame back towards the rear tire under the pipes. Follow the pipe upwards and see if it goes to the oil tank. This will verify that you have the correct drain. Just loosen the drain plug and let a drop or two of oil come out. It should be black. If it's clear and clean looking, it may be your transmission lube but I'm sure if your bike is a Softail model, this is the drain you're looking for.

Good Luck
steve

Aug 05, 2010 | 2001 Harley Davidson FXSTB Night Train

2 Answers

2004 dyna Where is the oil drain plug? THANKS


Look on bottom of crankca
.A thumbs up would be greatly appreciated if this answer is helpful to you. 2004-dyna-oil-drain-plug-thanks-4d5i0utctl2htkxwobhufr12-1-0.jpg

Jul 29, 2009 | 2000 Harley Davidson FLSTC Heritage...

1 Answer

Harley davidson flstc heritage softail 1997


The fork oil is a very specific job needing a manual and a special tool, I don't want to insult anyones mechanical knowledge but if you have never done it before, best to take somewhere else. Engine oil on the other hand is easy, the drain tube to any softail is on the right side by where the frame meets the swing arm, has somekind of plug in it. Start and run bike for a little while, long enough to get it warm but not hot. Remove fill plug and then remove plug in drain line. Using a peice of cardboard or something put in between filter and frame , directing the oil to your drain pan instead of where ever it goes. Put 1 qt oil back in (after everything is reinstalled) start the bike and make sure the oil light goes out, when it does shut bike off and fill to the point that when it is standing upright you get a little oil on the tip of your finger, over filling may result in loss of oil cap from pressure (been there)

Jun 15, 2009 | Harley Davidson FLSTC Heritage Classic...

2 Answers

Oil drain plug


Its at the back of crank box right hand side of bike attached to bottom of frame in a sprung clamp just before the softtail swingarm- black hose with a plug and hose clip

Nov 10, 2008 | 2005 Harley Davidson FLSTC - FLSTCI...

Not finding what you are looking for?
2002 Harley Davidson FLHR - FLHRCI Road king Logo

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gills Lango

Level 2 Expert

195 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...