Question about Motorcycles

Open Question

Wiring diagram yamaha rxz

Problem with left and right: front and rare singals, front light, and break light.

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
cape cod bob
  • 292 Answers

SOURCE: rear break will not make break light come on

adjust the rear brake light switch. you will find it on the right connected to the brake pedal by a rod and spring

Posted on Apr 04, 2009

Ad
cape cod bob
  • 292 Answers

SOURCE: need wire diagram for the turn signal switch.

your wires are crossed/shorting somewhere, probably in the headlight. remove the light to get to all the wires. you should be able to see which colors go to which side, also look at the wires coming from the turn signals both front and rear lefts will be same color and the rights will be another color. you should be able to tell by looking inside the switch which side is which color and which one is the feed to the switch

Posted on Apr 10, 2009

  • 278 Answers

SOURCE: looking for front mud gaurd for yamaha xt125x 2006 model

Go on line to E-bay, mc parts and you will find most of your parts.
Also try your nearest mc salvage. I get most of my parts from them.
Good luck

Posted on Oct 15, 2009

sisadsl
  • 1508 Answers

SOURCE: I have a 1980 Yamaha

It could be the switch.( i assume you have tried new bulbs)
check the wires coming from the switch are all connected in the headlight. The indicator wires are color coded, the same color wire should be coming from the switch block, as what goes to the indicators.
You can check with a automotive test light to see you have a live wire when it is switched left.

Posted on Aug 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When I hit my right singal the arrow stays green instead of blinking. But my left one works fine.whats my problem?


Check the Light bulbs both front and back with it turned on if one is not lit up then change the bulb, if both bulbs are on then the relay is the most likely cause. Also some cars have marker lights that may be part of the cause.

Dec 07, 2016 | Cars & Trucks

1 Answer

Break lights on a 1984 chevy dump truck its a d 6500 i have turn singals but no break lights


Check the brake light switch at the brake pedal. It may be defective or mis-adjusted.

Dec 30, 2014 | Cars & Trucks

2 Answers

Left turn singal work right dont


This is one of two possible things, either the bulb is burnt out, or the fuse is fried.

Apr 02, 2014 | 2004 Buick Rainier

1 Answer

Right rear break light doesnt come on


check the ground wire that is most likely the problem. also on some there is a fuse rare but sometimes there is one .

Jan 13, 2014 | 2005 Volkswagen Sharan 1.9

1 Answer

Why is my abs and trac off light still on after replaceing wheel bearings on the front


The wheel bearing are not a cause of these lights to come on. You must have the system scanned with a special tool to see what fault code or codes exist that have triggered the light.

Apr 08, 2012 | Cars & Trucks

1 Answer

After changing breaks pads (front and rare) light on the panel-check the breaks!!! How to reset? Thank you


Refill the brake fluid as some has leaded out, leaving the indicator light to flash.

Apr 17, 2009 | Computers & Internet

1 Answer

When I switch the left direction singal, a loud noise came out and no light and no flash for the front and the rear singal on the left side. Right side is ok.


Sounds like a blown turn signal bulb. Park the car with the engine running and the left signal activated, and see if either of the bulbs are flashing. If only one of them is, then change the other. If neither is flashing, you may have a blown fuse. If that isn't it, I'd suspect that the switch itself, inside the column, is bad.

Jul 21, 2008 | Isuzu Trooper Cars & Trucks

1 Answer

Soundcard problem on D530 SFF


Sounds like the audio return wires aren't connected. On the motherboard, there is a sound jack on the back left side of the mobo. The jacks from the front audio panel connects to it. Both the Left and Right channel have an out and an in connector. These send the signal to the headphone jack on the front panel and return the signal to the rear output jack if a headphone is not connected. Look for looe or broken wires. The other spot to check is the front headphone jack. If a headphone plug was pulled out or pulled sideways, it could break the solder joint on the PCB panel or break the shunt feeding the singal to the rear jacks. Hope this helps.
Ron

Apr 13, 2008 | HP Compaq Business d530 PC Desktop

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4825 Answers

yadayada
yadayada

Level 3 Expert

79186 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...