Question about Yamaha G5 Motorcycles

1 Answer

Timing chain I have a 92 Yamahal Timberwolf.I was needing to know the best way to replace it.I have the case off, but can not get the magint off.What is the best way to remove this to get to the timing chain? Thank you Michael Hofmann

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Easiest way is to break the chain( with the proper tool) connect the new chain and wind it thru from the the top, when the new chain is right around reconnect it and install the cam wheel and time it. You don't have to go anywhere near the magy.

Posted on May 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 Yamaha Timberwolf 250 will not turn over. Took it to someone they said it was stator. Replaced stator and spark plug still wont turn. There's no noise anywhere.


Hi, Anonymous and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Tip over sensor needs a reset.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand or clutch pull in switch/sensor.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
1994 Yamaha Timberwolf 4x4 Electric Start Problems
no fire 96 timberwolf
http://www.mikekekich.com/92-98%20Timberwolf%202WD%20Service%20Manual.pdf
OEM parts for Yamaha
Yamaha YFB250K Timberwolf Owner Manual

Jan 13, 2017 | Yamaha Motorcycles

1 Answer

Engine number 4BD-211821 need to verify size and year


Hi, Gary this was a tough one I had to dig really deep in my bag of tricks for the answer I am pleased to announce that you are the proud owner of a1996 Yamaha YFB 250cc engine that came out of a 4 wheel off-road vehicle called a Timberwolf for more information about your question and valuable free downloads that you will need please visit the websites below. Good luck and have a nice day.
http://www.mikekekich.com/92-98%20Timberwolf%202WD%20Service%20Manual.pdf
YAMAHA MANUAL STORE
Yamaha Yfb 250fwh 1996 parts lists
Yamaha Timberwolf 2x4 Specifications Off Road com

Feb 11, 2016 | Motorcycles

1 Answer

Need to find model number to order parts


92-2000 Timberwolf YFB250 all use the same air box, this site gives you all the details you should need

http://www.cmsnl.com/search/index.php?spbmbrand=YA&spbmmodel=Timberwolf++250&spbmvin=

Dec 29, 2015 | Yamaha Timberwolf 250 2wd 97 Airbox Air...

1 Answer

Yamaha Timberwolf. How do I find model number to order parts?


I apologize - my answer to the previous question didn't really clarify your actual question - Your VIN can be found along the frame rail - left hand side - about a foot or so ahead of your left foot guard -

26028714-jbdqfs5232kzbw0rj532ox50-2-0.png

If it's still there - your model number is here:26028714-jbdqfs5232kzbw0rj532ox50-2-2.png

If you can read your VIN - and here's a tip to know you're getting the whole number and it's not rusted away a digit; your second digit should be a (Y) - if you write down your VIN, second digit is Y so you know the placement is right - the 10th digit is the year. And here are the breakdowns for that 10th Digit:

(For all Yamahas - not just the Timberwolf):
88 - J, 89 - K, 90 - L, 91 - M, 92 - N, 93 - P, 94 - R, 95 - S, 96 - T, 97 - V, 98 - W, 99 - X, 2000 - Y, 01 - 1, 02 - 2, 03 - 3

From 1992 - 1998 the Yamaha 250 4-stroke, shaft drive, trail bike was the Timberwolf.

From 1999 - 2004 the Yamaha 250 4-stroke, shaft drive, trail bike was the Bear Tracker.

*****SAME ENGINE, SAME TRANSMISSION, SAME REAR END, TIRE SIZE, PULL START - THINGS THEY DEFINITELY CHANGED IN 1999 WHEN THEY STARTED CALLING THEM THE BEAR TRACKER: - PLASTICS BECAME A LITTLE LONGER I BELIEVE; AND THE SEAT WITHOUT A DOUBT BECAME LONGER. THE CARB WENT TO A CONSTANT VACUUM - INSTEAD OF THE SLIDE CARB WHERE THE THROTTLE CABLE WENT THROUGH THE CAP LIKE THE TIMBERWOLF. HARD TO REMEMBER - BUT I THINK THE TIMING CHAIN TENSIONER BECAME UNADJUSTABLE - AND NOT MUCH ELSE CHANGED. IN 99 THEY EVEN KEPT THE BRAKING SYSTEM THE SAME. SOMETIME AROUND 2000, 01 OR SO THE BRAKE SYSTEM CHANGED FOR THE FRONT WHEN YAMAHA WENT TO DISC BRAKES. HOPE THIS HELPS. ANYTHING ELSE YOU NEED TO KNOW ABOUT YOUR TIMBERWOLF JUST LET ME KNOW - I'VE OWNED, REBUILT, BOUGHT, SOLD, TRADED A TON - I'VE CURRENTLY GOT A 99 BEAR TRACKER THAT IS THE MOST DEPENDABLE 250 4 STROKE I'VE EVER OWNED AND A 1996 YAMAHA WOLVERINE 350 4X4 - I'VE REBUILT THEM FROM THE BOTTOM TO THE TOP. THOSE BIKES ARE GOLDEN IF YOU TAKE CARE OF THEM AND DO A LITTLE ROUTINE MAINTENANCE. ALL THE BEST - JUSTIN MCCARTNEY

THE 99 I MENTIONED THAT I STILL HAVE:
26028714-jbdqfs5232kzbw0rj532ox50-2-5.jpg

A 98 I BOUGHT WITH THE ENGINE IN A MILK CRATE THAT I BOUGHT, REBUILT & SOLD:
26028714-jbdqfs5232kzbw0rj532ox50-2-9.png

A 2004 I BOUGHT, REBUILT AND SOLD:
26028714-jbdqfs5232kzbw0rj532ox50-2-14.jpg
All the best - let me know if you're ever in a jam with yours; not too much I haven't seen, fixed or had to deal with.

Dec 29, 2015 | ATVs

1 Answer

92 timberwolf dosn't have good spark


Being a 92, you only ahve a few things to look at. The coil, making sure it is good and also making sure you have full voltage and a good ground. spark plug wires are good, and the spark plugs are good and set at the proper gap. I use original equipment(OE) parts on my vehicles. Most people vehicles I work on want the cheapest parts. Some times this is a problem in itself.

Nov 13, 2014 | Cars & Trucks

1 Answer

'92 yamaha timberwolf valve adjustment


Here's the info you're looking for.

1992-1998 Yamaha Timberwolf 2WD and 4WD
Intake: 0.05 - 0.09 mm (0.002 ~ 0.004 in)
Exhaust: 0.11 - 0.15 mm (0.004 ~ 0.006 in)

Jun 20, 2014 | RTO 200cc Full Size Four Wheeler ATV

2 Answers

Just redone the top end of my 91 250 timberwolf atv 4x2


try to google for a manual for the timberwolf, with patience you'll find it. I do know that the piston must be at top dead center and both (intake and exaughst) valves must be closed.

Aug 24, 2009 | 2003 Yamaha YZ 250

1 Answer

98 Timberwolf will not idle and has a rolling rattle sound in crank case sound dose not change when you throttle it up


It needs a doctor - it's a '98 two stroke - when was the last time the seals and bearings were replaced?

Jun 28, 2009 | 2003 Yamaha YZ 250

2 Answers

Year? Parts?


The frame number (VIN #) is what will tell you the information needed. Call a dealer with the VIN number ant they can tell you exactly what you have got. Chances are the dealer can tell you. The Timberwolf came in 2x4 and 4x4 models. You can look up the part numbers for both and see if the casings have the same part numbers. If so, you should be able to do a swap out. Check out the part numbers on the frames.

Go to the site below where you can see a parts diagram for your specific bike. You will select the actual brand, year, model, etc., once you go to the site. Part numbers and prices are also shown. You can order parts from this site. In the event no price is shown on a particular part, the part is not in stock. www.babbittsonline.com/pages/parts/viewbybrandand/parts.aspx

Please top rate this answer. Thanks!

Jun 07, 2009 | 1990 Yamaha TZR 250

6 Answers

What is valve clearance for a 250 yamaha timberwolf


what an *******. If I had a manual or my library had one I wouldnt be asking the question. If I need help fixing something dont tell me to go jump in a lake just dont answer

Apr 05, 2009 | 2003 Yamaha YZ 250

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

500 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1147 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...