I have too *** almost alot but only a few drop are coming out and it is agervating me and i am drinking crandberry jucie but it aint helping it was but now it just stoped and i am sixteen and i need h

fixya site doen't supply anything
get the right web page

Dunno if you still need this answered but, I own a few of these and can relate. This model does not come with positive vend sensors. The issue your describing happens when the incorrect shim is used for a drink column. If your vending 3 drinks per row in a drink(D) column, it is recommended you use one of the middle columns as they are stock set to have 3 rotations per full 360 degree column rotation as the motor is setup that way. You can manually change the other columns to handle this and vend small cans but the far left and far right are default set to tall cans and bottles with 2 turns per full rotation so 2 drinks per row etc.

Dropping them all at the same time also typically indicates your using the wrong shims for that drink type. You should be able to find more info in the manual or order the correct shims from healthy you direct

If you can visually see the rod, use a few drops of cooking oil. If it leaks into any drink, you wont get sick. Don't use mineral oils.

it could be your cam sensor

Long and short of it...if the photos are close to "decent", dont worry bout it :) It aint no L Lens but can still throw out a good pic every now n then. Tip it from one end to the other whilst holding it...if you hear something go \'ring-a-chicka-chink-chink-clunk\', then youve got problems, otherwise grin and bear the looseness - mine lasted 6 years of hard yacker before i dropped it in the drink!

This is similar to my Saeco. i only drink black coffee so the steam function is very rarely used. When i went to use it recently got same as your description. this then set a 'blocked' code on computer which meant NO COFFEE! EEEKKK.
I used an old soft drink bottle as a resevoir to operate the machine with covers off so i could see an issues. I started at the filter , blew that out with compressed air. then hoses...do 1 at a time ...tank to filter, filter to pump, pump to heat exchanger, heat exchanger to spout (watch this one as it is steam!)
after a thorough strip and assemble i descaled and was good to go. now i make sure to use steam at least once a month.

Yes. If you are planning a camping trip, having a way to drink water is essential. If bleach is the method you prefer, buy some chlorine bleach. All you need to do is add two drops of bleach per quart of water and shake. Wait at least 30 minutes before drinking.

unplug and turn motor by hand a few times then plug back in and try it again.if it don't work sounds like the motor is bad.if it comes on after turning by hand then the motor is going out

might be in the alternator with the heater and ac on it is drawing alot of extra jucie from the battery in which is putting a strain on the alternator in which is causing the engine to not get enough power to the coil to fire properly

Hey, its kinda tricky if you aint done it before, go onto google and search for your laptop model dc jack, they usually cost about £5 including postage, then you need to dismantle the entire laptop, remembering where each part goes back into, once you get the motherboard removed you need to unsoldier the old dc jack, and put in new one and resoldier it.
will take you about 1-2hrs in total, or should cost you about £55 for a shop to do it.

we do alot of them, but if you aint done this before it can be very tricky..

Hope this helps

John