1998zz250 lags when ur cruseing and then when u try give it sum gas it sounds like it wants to die4 a sec then gos normal i think its the carbs or the leads

Alga Sects
Gala Sects
Galas Sect
Cage Slats
Cage Lasts
Cage Salts
Glaces Sat
Cages Last
Cages Salt
Cages Slat
Lace Stags
Scale Stag
Scale Tags
Laces Stag
Laces Tags
Scales Tag
Eclats Sag
Eclats Gas
Cleats Sag
Cleats Gas
Castle Sag
Castle Gas
Eclat Sags
Cleat Sags
Castes Gal
Castes Lag
Caste Slag
Caste Gals
Caste Lags
Lac Sagest
Lac Stages
Lacs Stage
Lacs Gates
Class Gate
Talcs Sage
Talcs Ages
Talc Gases
Talc Sages
Casts Gale
Scats Gale
Acts Gales
Scat Gales
Cast Gales
Cats Gales
A Lacs Gets
A Class Get
A Sacs Gelt
A Casts Leg
A Casts Gel
A Scats Leg
A Scats Gel
A Acts Legs
A Acts Gels
A Scat Legs
A Scat Gels
A Cast Legs
A Cast Gels
A Cats Legs
A Cats Gels
A Gal Sects
A Lag Sects
A Slag Sect
A Gals Sect
A Lags Sect
Lac Sag Set
Lac Gas Set
Lac As Gets
Lacs As Get
Sac Gal Set
Sac Lag Set
Sac Sag Let
Sac Gas Let
Sac Stag El
Sac Tags El
Sac La Gets
Sac Las Get
Sac As Gelt
Sac Sat Leg
Sac Sat Gel
Sac At Legs
Sac At Gels
Sacs Tag El
Sacs La Get
Sacs At Leg
Sacs At Gel
Acts Sag El
Acts Gas El
Acts As Leg
Acts As Gel
Scat Sag El
Scat Gas El
Scat As Leg
Scat As Gel
Cast Sag El
Cast Gas El
Cast As Leg
Cast As Gel
Cats Sag El
Cats Gas El
Cats As Leg
Cats As Gel
Cat Sags El
Cat As Legs
Cat As Gels
Act Sags El
Act As Legs
Act As Gels
Gal As Sect
Gal Sat Sec
Gal At Secs
Lag As Sect
Lag Sat Sec
Lag At Secs
Slag At Sec
Gals At Sec
Lags At Sec
Sag La Sect
Gas La Sect
Stag La Sec
Tags La Sec
Tag La Secs
Tag Las Sec

Hi Lennard:
Cars and trucks section but CR80 sounds like a motorcycle. right?
You need two basic things:
1) Spark - pull the spark plug, connect the lead, hold against the head, and spin it over. Spark shoulld be hot and blue.
2) Fuel - Drain tank and fill with fresh gas
Drain and flush carb
If it has a filter, make sure that fuel is flowing through it.
Try a "normal" start........... choke, kick over 5 times. If no start, remove plug and check for fuel in cylinder. Wet plug means no spark. Dry plug means no fuel.
If dry plug try priming the carb (give it a squirt of gas with choke off)
It should try to start.
To let me know how you're doing, reply as a comment on this post.
Cheers.

Sound like the float in the carb is getting stuck the way to tell is loosen the screw at the very bottom or carb and see how much gas comes out it should run forever if only runs for a few secs the clean out carb

sounds like old gas, n carb can use cleanin put wire through were ur gas line gos on ull will have take carb apart wire should come out were jets r wen apart make sure clean carb good with old cloth n gas if looks clean ennuff try it out

Bad Gas? Plugged Carbs overhaul Carbs adjust air/fuel mixture?

It sounds as though the slow speed jets are partially stopped up. When you give it more throttle the high speed jets take over. Try using a good carb cleaner in it for a few tanks. If that doesn't work than you may have to go through the carbs.

Ride safely, Ed

just take off the AIR filter and thar is a Big Hole thar spray sum starte fluid in the bigger hole and spray it for three sec then try an start it

Dump ALL old fuel out of tank, you might have got a clog in the fuel line, carburator, fuel valve. Remove carb bottom Sediment bowl then spray Carb cleaner thru the gas inlet AT the carb 3-4 secs CAUTION: KEEP YOUR HEAD BACK.. that cleaner hurts if you get it in your eyes... and NEVER SPRAY A HOT ENGINE (np with yours tho no start) Refill tank with NEW fuel (or strained at least if emergency remote repair) Place a suitable catch container over gas inlet line to carb (at carb) open fuel valve chk for fuel FLOWING (no dripping) into container. replace fuel line to carb start as normal
if not firing still chk that spark plug, might need cleaning now that rest is ok.

sounds like it is in the throttle sensor or idle control valve causing problem not responding fast enough to take over also try the fuel filter could be clogged.

Drain and replace the gas with fresh.
Remove the air cleaner and spray carb cleaner into the inlet. Work your throttle a little then put everything back together and try to start it.