Question about 1994 Honda GL 1500 SE Gold Wing
Hi! I have a 1994 Honda Goldwing SE. when I turn the key on I don't get a neutral light.I have a fully charged brand new battery I just installed.It wouldn't start with the old one either.I have worked the sidestand up and down a few times but still don't get the neutral light.When I pull the cluth in and try to start the bike Without the green light all I hear is a click coming from a relay switch on the left side fuse panel.I also ordered and got a new neutral switch but can't find the location to install it. I was told it was around the left cylinder bank. But I had no luck in finding it.I would really hope that you can help.
The click u hear means your neutral isn't the problem, it means your new battery is trying to start the engine, however the power isn't making it to the starter. check the battery cables for good connection in the ends of the wires and at the start relay (the positive wire from the battery goes to the start relay that may need replacing) also from the start relay that you hear clicking down to the starter.make sure cable and nuts that hold them are clean in good shape. to get the neutral lite to come on the side stand doesn't do it, the shift lever does. you can be sure you are in neutral when the bike can roll without the clutch being pulled.If the bike is in neutral and the lite doesn't come on then replacing the bulb or sensor might be necessary.
Posted on Apr 21, 2010
I got the same thing i was riding my bike and then i turn it off i want to go home to get something and back again i try to turn the bike on wont turn like nutting shows no light or anything i got new battery and nutting light up is it the fuses that i have to change . is it the fuses problem ply help me plz reply to firstname.lastname@example.org and help plz thxs guys
Posted on Aug 27, 2010
I have a foreman 400 4*4 it don't show the light on when I put it in neutral, so I thought it was the bettery, nope. I tryd to pull start over and over again and theyre was nothin. So I just tryd starting on the cilonnod with a
Wire it sits they're and cranks but just won't run please help guys
Posted on May 22, 2012
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Hi it sounds like the starter solinoid or starter relay is not working or there could be a loose wire or the starter motor is faulty
Posted on Nov 24, 2008
Sort of sounds like a Twilight Zone kind of problem doesn't it. I would have the battery checked for an internal dead short. This is something that happens on odd occasions and can happen even to a new battery. Yea, the little lights will work ( they do not draw much juice ), but the starter motor draws a lot of juice and a shorted battery just ain't got it. Also check the wiring harness connections. One loose connection can cause bunches of trouble.
Posted on Mar 14, 2009
O.K. guys! for those of you having problems with your NEUTRAL SAFETY SWITCH . I had this problem on my 1994 goldwing se and after calling dealers that had all kinds of replies that I didn't like I decided to see if I could find a solution and I did find the problem and fixed it without having to even buy parts. The bad part is that you have many parts to remove to get at the problem but it's possible for anybody to fix the switch.
Here is what I did:I took out my manual and decided to remove the top part of the gas tank cover.By following my manual I removed the 2 pockets on each side of the handle bars then I followed the instruction on removing thecover that holds your radio all the way to the cover where you fill the gas tank.When that cover is released you will see wiring that plugs into your radio follow instruction and remove the plugs and get that whole cover out of your way....
Now on the left side of the bike (same side as the side stand) you will have to remove the left side cover where the REVERSE LEVER is again if you follow your manual it is possible to do without much trouble. Now when you have removed that side panel you will see where your REVERSE LEVER was and you will see a little switch attached to that reverse switch. REMOVE that switch and spray it with electrical cleaner solution and work it back and forth till you hear and feal it clicking and once that happens put it back on the bike and try it out.YOU SHOULD HAVE A GREEN LIGHT AND YOUR BIKE SHOULD START. That is how I repaired my switch and don't have the green light problem at all now.IF THAT SOLVES YOUR PROBLEM YOU CAN NOW PUT IT ALL BACK TOGETHER.
If your switch doesn't clean up and doesn't work you can order one from hondaline.
Posted on Oct 19, 2009
Tips for a great answer:
Jun 12, 2014 | 1994 Honda GL 1500 SE Gold Wing
May 16, 2014 | 1996 Honda GL 1500 SE Gold Wing
Apr 06, 2014 | Honda Motorcycles
Nov 02, 2012 | Motorcycles
Apr 07, 2012 | 2003 Honda GL 1800 Gold Wing
Jun 07, 2011 | 1989 Honda GL 1500 Gold Wing
May 08, 2010 | 1999 Honda GL 1500 SE Gold Wing
Oct 08, 2009 | Sport & Outdoor - Others
Jun 08, 2009 | 1994 Honda GL 1500 SE Gold Wing
Apr 11, 2009 | 1999 Honda GL 1500 SE Gold Wing
Jun 19, 2018 | Motorcycles
1,496 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: