Question about 1997 Suzuki GSF 600 S Bandit

1 Answer

How to fit starter clutch suzuki bandit 600n - 1997 Suzuki GSF 600 S Bandit

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 200 Answers

You can download a service manual/drawings at it's FREE...Good luck to you friend...Tim

Posted on May 13, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Will a Suzuki bandit 1200 starter motor fit a 1250 bandit?

check they are similar if so the only difference could be the teeth of the drive therse no reason not to work if the teeth are the same in number

Jan 01, 2012 | 2007 Suzuki GSF 1250 Bandit S

1 Answer

2002 Suzuki Bandit will not start ...

Seen a similar problem to this recently, next time it happens put the bike in gear and rock it back and fourth a couple of times, if the starter then works, i would check the brusshes in the starter motor,

Nov 19, 2011 | 2002 Suzuki GSF 600 N Bandit

2 Answers

GSF1250 Bandit - intermitant start. Starter motor will some times crank over and engine will start immediately. Other times the starter motor will not even click. Battery fully charged. Side stand up...

there is a common fault with the 1250 bandit in that the magnets detatch inside the starter motor and it eventually breaks up and stops working, this can begin with sluggish starter especially when hot, it would appear to be a flat battery but the power required by the failing starter can drop the battery off quickly to confuse you when trying to find your fault

Jun 12, 2011 | 2007 Suzuki GSF 1250 Bandit

1 Answer

Fault with electric start on my Suzuki GSF 250 Bandit

Check that the clutch is in, kick stand up, and neutral light ablaze. Then try your start button. When you had it running and hit the button, the starter engaged at a slower speed then the bike engine was turning, which led to the stall. The stall means your starter works. If the starter works when the engine is running then it is wiring. Check your kick stand wiring along with the clutch wires which plug in on the handlle bar or where the clutch cable enters the engine.

Oct 18, 2009 | 1995 Suzuki GSF 250 Bandit

1 Answer

How to take of fuel tank corectly from suzuki bandit 600n 2001

Remove gas lines put tank on off. Pull seat. Should be bolts to hold tank. Pull tank toward rear and ligt. You might want to drain gas first

Oct 13, 2009 | 2001 Suzuki GSF 600 N Bandit

1 Answer

I need to convert my bandit 1200 fluid clutch to cable can anybody help ?

I don't understand why you would want to do this, but I suggest you see if a sprocket cover from a 600 bandit would fit in place of the existing one. The sprocket cover is the bit behind the alternator housing on the left hand side of the engine. Since the 600 is cable clutch, i think it works on the worm gear principle, that may solve the problem.

Jul 10, 2009 | 1990 Suzuki GSX-R 750 L

2 Answers

Hello I have a 2001 Suzuki bandit 1200. The problem is when I depress the starter switch. I hear the normal spinning of something below near the top of the engine. but the motorcycle wont start. 2...

I had the same thing happen. It's a problem with the starter clutch and how it's attached . A primary bolt is loose. Be sure to have your mechanic use some locktite or really wrench it on there tight--my guy fixed it and then the same thing happened again 10 mos later. But it hasn't happened again in the several years since then. Good luck.

Jul 06, 2009 | 2004 Suzuki GSF 1200 Bandit S

2 Answers

Suzuki 600 bandit won't start

It could be the starter, or it could also be the starter switch or more over have you first checked tht engine 'kill' switch? If its on 'off' (Kill) position the starter won't operate from the button!

Other way is to short circuit the starter throught the solenoid switch and see if it works.If it does work thn the switch (button) is faulty you may hve toreplace it or sometimes a good cleaning can revive it due to carbon deposits at the contact points.
Thirdly, I hope the battery is at its top performance too!
Hope this helps.

May 11, 2009 | 1997 Suzuki GSF 600 S Bandit

2 Answers

Sprocket covers

sorry mate but they arnt interchangable due to the fact the 1200 has a hidrollic clutch...other sprocket covers can be fitted from a number of other suzuki 600 bikes, eg:GSX F...GSX R...(600,750) hope this helps

Nov 10, 2008 | 2006 Suzuki GSF 1200 Bandit S

Not finding what you are looking for?
1997 Suzuki GSF 600 S Bandit Logo

Related Topics:

586 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

76164 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers


Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides