How do i take an ignition off of 2008 yamaha R6s

Question edited for full 'year make model'.
Ticking is normally valve lash

https://www.google.com/search?q=2009+yamaha+yzf+r6s+adjust+valve+lash

..

explain

It might have a governor installed, which will limit how fast your bike will go.

check the spark plug gap and carb air screw adjustment.

Yes, going to Wal-Mart is OK. Take your old battery with you. They can determine your battery group, and size you correctly.
Best regards, --W/D--

Fault Code: 33
Diagnostic Code: 30
Symptom: Open circuit is detected in the primary lead of the ignition coil (# 1, #4).
Probable cause of malfunction:
Open circuit in wiring harness.
Malfunction in ignition coil.
Malfunction in ECU.
Malfunction in a component of ignition cut-off circuit system.

If the bike turns over but doesn't start I would check the kill switch and from there the wiring harness to the coils.

I’m happy to assist further over the phone at https://www.6ya.com/expert/walker_61ab9022a1a05bd2

try looking near the front lower portion of the engine where the exhaust pipes are.

There is no tranmission fluid it uses the same oil as the motor does so when you change the oil you are putting clean oit in the tranmission also.

restart ur system and open again............. through google