Question about 2005 Kymco Grand Dink 250

1 Answer

2005 Kymco 250cc quad 4 stroke, all auto. Won't start

I put a new battery in, changed the solenoid, changed the spark plugs. When you go to start it, it clicks, it turns over, but won't start up. It sounds like it's starving for fuel. Any help would be greatly appreciated...

Posted by on

  • 1 more comment 
  • hnsfaria May 11, 2009

    Tim,
    Thanks for the info, I tried the spray, then tried to start it and still nothing. I cleaned out the air filter and the fuel filter and still nothing. Any other ideas? I'm hoping it's not the carb, but could be possible. Is it cheaper to take it into a shop to get it fixed, or for me to buy a new carb and replace it myself?

    Thanks for your help,
    Helder


  • Anonymous Mar 13, 2014

    my 2011 ktm 250cc quad has no spark, tried new plug, does start relay prongs, are both supposed to light-up with test-light?

  • Anonymous Mar 13, 2014

    my 250cc will not start I put a new battery in it still wont start, just makes a clicking sound

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 200 Answers

Get a can of starter fluid and spray a short burst into the air intake...it should fire up...if it won't stay running or idle your carb is clogged from storage i presume...right? usually storage for more than 3 mos will clog a carb if you did not winterize it...Good luck to you friend...Tim

Posted on May 11, 2009

  • tim winter May 11, 2009

    Oh no, don't buy a carb, just remove the one ya got, turn it upside down, remove the bowl

    (4 screws) and you will see a little brass hollow srew inside carb (maybe 2 of them) carefully remove ,clean out these jets and reinstall, if this scares ya take the carb to a trusted friend/mech....see ya...Tim

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2009 Kymco People s50 4t will not start


Hi, Jennifer and the usual suspects are:
1. Fuel tank empty.
2. The fuel tank has old dead gas.
3. Fuel tank bottom contaminated with ethanol sludge, dirt, water, rust, etc.
4. Fuel supply valve/petcock turned off.
5. Fouled spark plugs.
6. Engine flooded as a result of overuse of the enrichner.
7. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
8. Fuel valve/petcock or filter clogged.
9. Fuel line to carburetor or throttle body pinched, kinked or blocked.
10. Carburetor float stuck.
11. Fuel injectors clogged.
12. Fuel injectors stuck open.
13. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a cursory reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead acid batteries.
14. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
15. Loose or corroded wire connection at the coil or plug between ignition sensor and ECM module.
16. Spark plug cables in bad condition and shorting check for spark leakage in the dark, cable connections loose, or connected to the wrong cylinders.
17. Ignition timing incorrect due to a faulty ignition coil, ignition module or MAP, CMP, CKP, O2, TPS, ETP, IAC sensors.
18. Faulty neutral, clutch lever, or kickstand safety switch.
19. Faulty fuel pump or fuse or relay.
20. A stuck bent or burnt valve.
21. Tilt sensor needs a reset.
22. Security system not disarming alarm needs a reset.
23. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Troubleshooting
Scooter Troubleshooting Scooter won start All about Scooters
KYMCO PEOPLE 125 Service Manual 50cc also
Kymco PEOPLE Parts
KYMCO PEOPLE 50 2005 Owner Manual

May 25, 2017 | 2009 Kymco People S 50

1 Answer

2005 kymco moongoose 250 won't start, replaced battery and starter solinoid i have lights but won't turn over.it will turn over if its jumped> ideas??


Hi, Jenni and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Tip over sensor needs a reset.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand or clutch pull in switch/sensor.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Having issues atv starting staying started
Part 1 TaoTao 250cc ATV not starting Think it may be the CDI
KYMCO Mongoose KXR 250 Service Manual
http://www.motopartsmax.com/index.php/main_page/vehicle/tID/1/bID/25
KYMCO Mongoose 250 Owner Manual

Mar 14, 2017 | Kymco Motorcycles

1 Answer

2005 people 50 2 stroke. Why won't it start?


My scooter has no spark how to fix. gy6 chinese ... - YouTube

? 2:29
https://www.youtube.com/watch?v=UU4S0Ov9q4c
Aug 24, 2012 - Uploaded by Rolling Wrench
Purchase our "NO SPARK KIT" click the link below: ... My scooter has no spark how to fix. gy6 chinese scooter 139qmb qmb13950cc 150cc.

Author Topic: people 50 2 stroke no spark CDI?? - KymcoForum.com

www.kymcoforum.com > Scooters - 50cc > People 50
Aug 5, 2012 - 7 posts - ‎4 authors I have a 2001 people 50 2 stroke that only has 125 original miles. ... I ordered a CDI and coil from monster parts and it still would not start . Author Topic: (Almost) no spark / engine not ...
15 posts
Aug 15, 2011
Kymco People 50 - Not A Morning Scooter ...
15 posts
Sep 28, 2010
Author Topic: 2005 People 50 2T Mods ...
15 posts
Jul 27, 2010
Kymco People 50 - KymcoForum.com
10 posts
Nov 15, 2008
More results from www.kymcoforum.com

Nov 03, 2015 | Kymco Motorcycles

1 Answer

I have an atv that won't start.


Could be your starter, solenoid, or even a fuel pump/clogged lines or filters

Jun 04, 2013 | RTO Quads 125cc Full Size Adult 4 Wheelers...

1 Answer

My quad bike is not starting


2 stroke or 4 stroke? check the battery or the carb, check the gas, the oil, new spark plugs?

Jun 26, 2012 | Cycling

1 Answer

I have a Kymco People 50 brand new in May, 2011. It won't start, initially tried to turn over but now nothing happens. I checked the battery which over read 80% charged, charged it to full anyway. ...


have you checked the spark plug? take it out and lay it on the engine touching a metal part and kick the bike you should see it sparking if not then replace the spark plug
if thats not the problem then give the carb a clean and check the air filter that its not blocked

2 stroke bikes need three things to work air spark and fuel as long as you have these it will work

hope this helps

John

Jul 10, 2011 | Kymco 250 Venox Motorcycles

1 Answer

Kymco Vitality 2t 50 won't turn over. When I try to start the Kymco scooter, it tries to start, but it doesn't fully ignite. I try to kick start the scooter also, but that also fails to start the...


Take your spark plug out of the cylinder, reconnect it to the ht lead and place it on to your frame if you see a spark then your coil is fine, try a new spark plug, if there is no spark get a new coil and plug.

Remember there is a 2t and a 4t version of the kymco vitality and the spark plugs are different.

May 17, 2011 | 2005 Kymco Vitality 2T 50

Not finding what you are looking for?
2005 Kymco Grand Dink 250 Logo

Related Topics:

757 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kymco Experts

yadayada
yadayada

Level 3 Expert

75814 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Are you a Kymco Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...