Question about 1997 Suzuki TL 1000 S

1 Answer

97 tl1000 s replacement ecu part no32920-02f60 i have a 99 will this work on my bike

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 17 Answers

Unsure if it will plug st8 in but it can definitely be made to work. It's actually a very desirable mod because the 97 ecus had more aggressive advance curves.

Posted on May 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My bike while riding continues to stall, backfire and pop and shut off..


Hi Tony what was problem with original ECU? They don't usually cause this problem. An ECU either works or it doesn't check the plug and lead to see if they are breaking down and allowing the spark to jump. Regards Jim...

May 15, 2015 | 2003 Suzuki GSX-R 1000

Tip

Reset Ecu for Blade efi


Ok guys since many people asking how to reset the ecu... this is the way ... one point is this is a my version as i took the original version meant for other bikes ...Before you guys reset, take note
If you wanna reset your ECU juz 'for fun' . the End result would be the same.. The ECU can only adjust to within a limited range. plus your bike will lose the precious riding skill that it learned before this . So please reset the ecu if you cahnge the battery , rectifier , coil magnet and anytin related to electrical component .
  1. remove the -ve and +ve wire from the battery terminal respectively and leave it for 10-15min minutes (some says only -ve would do ) ,,well its your call.
  2. connect back the terminals , and now start your bike and leave it idle for 15mins (do not disturb the throttle)
  3. off the engine and leave it for another 10 mins ,,,
  4. Take your bike out and blast ur way throught the road
  5. i) if u like aggressive style ... use the freeway ,, each time b4 u change ur gear , leave the rpm till redline ,,, and when u reach 150kmh , maintain it for 1-2 mins
  6. ii) if u like eazy ride ,,,, juz take your bike and ride normally
Eventually your bike will accustomed to the way you ride on daily basis hoefully this works ,,, CHERRIOSSS From Arvin 'Dr Rock' Raj

on Apr 03, 2014 | 2012 Hyosung GT 650R

1 Answer

My Triumph Street Triple displayed the ECU malfunction light after a flat battery which has since been satisfactorily charged. How can I reset the ECU so my bike doesn't remain in limp home mo


You could try the 12 minute tune which I think is appl;icable to this model.This resets most issues.
Start the bike from cold...do not touch throttle then wait til fan comes on then time 12 minutes exactly then turn bike off.If this dont work go to a dealer so they can plug into the ECU and find out the cause..

Sep 17, 2014 | 2013 Triumph Street Triple

1 Answer

How do i bypass security system on a 2010 Ducati


The Ducati Immobilizer system works by having the ECU communicate wireless with your key. Once it retrieves the matching code it will allow the bike to start. If this fails there is a method documented in the user manual that permits you to enter the code from your card supplied with the bike. If the bike doesn't start with your other keys then the ECU may be faulty and require replacement.

Apr 04, 2014 | Cars & Trucks

1 Answer

Where is the transmission control module on a geo tracker


no year stated, so , that means. long wind.
89-96, why high in dash above right knee.
some are just above ECU.
97 up its gone. Suzuki moved the TCM (transmission brain)
to inside the ECU. a fact. few know.
here is my photo of this pre 97 locations
http://www.fixkick.com/ECU/92-95-dash-parts.JPG

Feb 20, 2013 | Reliance 1998-2001 Chevy Geo Suzuki 1.0l...

1 Answer

2003 Honda VTX 1300. I was told the ECU is bad and needs to be replaced. Can it be re-flashed to make it work properly again?


ECU's hardly ever just go out. More likely than anything,its a wiring issue.Probably a bad ground for multiple connections, Im assuming that if the bike was on a dyno,then it is running. If so,..what are the symptoms?

Sep 24, 2012 | Honda Motorcycles

2 Answers

Swapped a 1999 420A engine into a 1995 eclipse (also a 420A) and we have no spark. We started by checking the cam sensor and it is working properly it is upside down from the 95 but the ASD relay is...


first the cam sensor shouldn't be upside down from the 95. they both should be with the plug facing down. they 95 CAS has a different plug than the 99 CAS.
the 95 has round pins and the 99 has flat pins.

95-96
9f942a5.jpg
--------------------
97-99
ad9a342.jpg
-----------------------------
also the 95-96 relays are opposite the 97-99

95-96
db7e0e0.jpg
------------------------
97-99
c98327d.jpg
---------------------
besides that it could be the ecu. i also have heard of the locating pin on the intake cam shearing off, allowing the gear to turn with the timing belt without the actual camshaft spinning.

Sep 27, 2010 | 1996 Mitsubishi Eclipse

1 Answer

My AC ,GAS,SPEEDOMETER,TACHOMETER AND TEMP GAGE DOES NOT WORK IS THIS PART OF MY ECU? I ALSO TOOK IT TO ADVANCE AUTO TO PUT ON THE CHECKER AND IT DID NOT WORK.NEED HELP QUICK IT IS A CADILAC CATERA 97


generally when half the cluster fails it points a a failed instrument cluster, Not the ECU. Either way I would have it diagnosed properly before you replace anything.

Apr 07, 2010 | 1997 Cadillac Catera

2 Answers

Need to know what fuel hoses hook up to where on the gas tank. own a 97 Suzuki TL1000 and just bought a good used tank..i didnt take the old tank off and i dont see a hose for the left side of the...


go to capitolcycle.com and go to their online store and look up your fuel tank as if you are buying another one...it will show you the fiche page and you can print it out...you can look up every single fiche page you need to find each hose and follow it to where it needs to go.

Jul 21, 2009 | 1997 Suzuki TL 1000 S

1 Answer

My suzuki tl1000 will not start what do i need to do


Hi
With such little info we have to start from the beginning
First check the obvious
Is the kill switch on run?
Is there petrol in tank? turn petrol tap to reserve
Is it in gear?
Is the side-stand down?
Do the brake lever switches work?
Check the Ign fuse
Is the battery charged?

I need more info really or its all plain guesswork

What happens when U press the starter? Does the engine turn over at all? Is there a whirring noise or just 1 click perhaps? All these cd b down 2 a dead battery !!!!!!!!!!!!!!!!
Give me more info

Ride Safe
Bike-Doc UK

Jun 27, 2009 | 1997 Suzuki TL 1000 S

Not finding what you are looking for?
1997 Suzuki TL 1000 S Logo

Related Topics:

209 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...