Question about Harley Davidson Motorcycles

1 Answer

2000 fatboy red engine light comes on odometer goes off

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Harley Davidson Master
  • 43,120 Answers
Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
co7196
  • 3433 Answers

SOURCE: 2003 Ultra Classic. Above 2000RPM, the volt meter

Dont do that, your voltage regulator is faulty. It is in the alternator. Max charging voltage should be 14.2 and min 13.6v. Chk battery water level. but get an alternator 4 sure

Posted on Jul 08, 2009

czaa
  • 4536 Answers

SOURCE: 01 heritage. Engine light comes on, odometer goes

yes thats a good place to start-always check wiring 1st-sometimes things that appear normal can be corroded but i think your alternator battery or regulator is failing-test it dew u have a manual!!

Posted on Aug 05, 2009

OneRide
  • 379 Answers

SOURCE: when I ride my 2000 fatboy my speedometer doesn't

Try inside the tach on the connector. But also remove your speed sensor on the transmission and clean it. They pick up metal chips from the trans and short out. Also, HD had a bunch of bad speedos around your year. They replaced them for free. Doubtful they will replace yours at this late date. You might end up buying a new speedo.

Posted on Aug 12, 2009

  • 21 Answers

SOURCE: The engine light comes on, the speedo stops

Check the battery contact. Or check if the battery is good.

Posted on Aug 25, 2009

  • 1 Answer

SOURCE: procedure for retrieving diagnostic codes on 2000 softail

Hi Bill. That is exactly what my bike did last weekend. What was the final solution?

Posted on Sep 05, 2013

Testimonial: "It turned out to be the voltage regulator. I priced them and believe it or not, the dealership had the best price, but I had it installed by my bike shop mechanic."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Eninge lite blinks fast and wont start


Pull any error codes.

The engine light lights up when you turn the ignition switch on, then goes off. After four seconds, if it comes on again and stays on, there is a present fault code. When it is an historical fault code, it comes on with ignition and goes off then comes on and goes off again. I believe in like 4 second intervals. A historical code will not be removed until a cycle of 50 ignition on/of intervals has passed. In other words, the engine light will continue to light two times when ignition switch is turned on, after 50 on/off cycles have passed the historical codes will no longer affect the engine light when starting.
If you will hold the odometer button on the side of the console down, and turn the ignition on and off, three times I think, waiting for the fuel pump to stop before turning the ignition switch to the off position, and one second until you turn it on again, the third time holding the odometer button down until the engine light begins to blink it will begin to blink in a fast sequence showing the fault codes will follow.
First indication of fault code display is rapidly blinking engine light. After that count the number of times the engine light lights up. There will be a brief pause between digits. If there are multiple codes stored, the rapid blinking will separate each. Once the fault codes begin to repeat, you have gone through all stored codes.
Tips: Have a pencil and paper ready.
Maybe ask a friend to help out. Sometimes a second pair of eyes can be good.
Go through a couple of cycles, so that you are sure you haven't missed any codes.
One example is if it blinks 3 times, pause, the blinks 2 times, that means 32.
Code 32: Rear Fuel Injector

Feb 16, 2014 | 2000 Harley Davidson FLHTCUI Electra Glide...

1 Answer

Transmission speed sensor


You could have a faulty speedometer/odometer combination meter causing a false Vehicle Speed Sensor error.
My 1998 Sienna had the following symptoms:
- Speedometer and odometer failed intermittently
- The check engine light would come on and I would get a p0500 code in the OBDII.
- The cruise control would stop working at the same time the speedometer failed.
There is a speed sensor in each one of the tires and they feed the speed information to the ABS ECU. From the ABS ECU the speed signal goes to the speedometer/odometer combination meter, and from there it goes to the Engine Control Module and to the Cruise Control ECU. I could see a signal coming into the speedometer/odometer, but no signal going out. Replacing the speedometer/odometer combination meter fixed the problem.

Dec 01, 2013 | 1998 Toyota Sienna

1 Answer

2000 tundra odometer stopped working


The check engine light should come back on at some point.
Chances are the problem is the speed sensor in the transmission.

Jan 24, 2013 | 2000 Toyota Tundra

2 Answers

Procedure for retrieving diagnostic codes on 2000 softail


Check the positive connection at the starter, it's probably loose.

May 17, 2012 | 2000 Harley Davidson FXST Softail Standard

1 Answer

The engine light comes on, the speedo stops


Check the battery contact. Or check if the battery is good.

Aug 25, 2009 | 2000 Harley Davidson FXST Softail Standard

1 Answer

When I ride my 2000 fatboy my speedometer doesn't


Try inside the tach on the connector. But also remove your speed sensor on the transmission and clean it. They pick up metal chips from the trans and short out. Also, HD had a bunch of bad speedos around your year. They replaced them for free. Doubtful they will replace yours at this late date. You might end up buying a new speedo.

Jul 16, 2009 | 2000 Harley Davidson FLSTC Heritage...

1 Answer

CHeck Engine Light / odometer goes haywire


this is most likely due to the Vehicle Speed Sensor malfunctioning, this will set the check engine light and cause the Odometer issue as well, have a system computer test run to see what trouble code is stored in memory, that will pin it down.

Jun 26, 2009 | 1996 Honda Accord

1 Answer

What does do1clr mean on odometer engine light on odometer goes off


It means your bike has recorded an trouble (error) code. depending on the year of the bike you can get them to display on the speedo or you will have to have Harley or shop find out what the code(s) are.

Jun 16, 2009 | 2000 Harley Davidson FXDWG Dyna Wide Glide

1 Answer

Engine light


Thats not a problem, thats exactly what its supposed to do. After you start yer bike, the engine light should come on for about 5 seconds and then go out. Thats how they are designed. If that occurs, u are A - OK!

Feb 03, 2009 | 2000 Harley Davidson FLSTF Fat boy

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

193 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Mike

Level 3 Expert

4340 Answers

yadayada
yadayada

Level 3 Expert

76682 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...