Question about BMW K 1200 LT Motorcycles

1 Answer

Nutral light do`nt work

We`ve checked and tested the fuses and the bulp, but the nutral light wo`nt come on and the bike can not be started. We can i download a wiring diagram?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An user who is expert in 3 categories / brands.

  • BMW Master
  • 1,554 Answers

The neutral light switch (down at the transmission) could have gone bad.

Posted on Nov 26, 2013


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 112 Answers

SOURCE: wiring diagram for bike

You can go to your local dealer and they usally will copy it out of ther service manuel for you.When you say passing lights do you mean highway lights?

Posted on Mar 29, 2009

  • 2 Answers

SOURCE: I washed the bike and it wont start now. the

have you checked for a spark at the plugs. You may well have got water in the coils.The cure for this is natural drying. if this is the case the coils will need to be sealed. and the leads silicone sprayed

Posted on Jun 04, 2009

  • 3433 Answers

SOURCE: where is the nuteral wire on a 1988 yyamaha virago

Check the neutral switch and wiring, Then chk the clutch switch, then the kickstand switch.If the lite isn't on, the problem is the neutral switch because the lamp power is controled by the switch also.

Posted on Nov 05, 2009

  • 1508 Answers

SOURCE: dear sir

check the wire to the neutral switch under the front sprocket cover I think, then use a multi meter on the switch and check the readings. in neutral and in gear.

Posted on Jun 08, 2010

  • 50 Answers

SOURCE: The bike will not start.

Change the relay next to the battery

Posted on Oct 06, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

The 30 amp fuse on my bikes solenoid keeps blowing

Hi you have a grounded wire remove the fuse use a ohm meter or battery powered test light test the outgoing lead and to the frame if it lights up or registers on the meter backtract to see if the wire is grounded insulation worn off or pinched on the frame.

Jan 10, 2013 | Honda Deauville NTV 650 Motorcycles

1 Answer

I have a 2008 buell 1125r motorbike...i've got power to the tailights but that's it. the battery has tested fine, i've swapped relays and replaced fuses but nothing changes, wussup?

Turn the key switch in the opposite direction. The key setting you have it in is so you can leave the bike parked on the side of the road with the tail light on as a warning light so no one hits your bike.

Mar 27, 2012 | Buell Motorcycles

1 Answer

I have a 1999 harley sporty 883 I just started having problems starting it recently I replaced the battery and still nothing I do not even get a click I also have no headlight but the horn works I checked...

Contact me directly at and I'll send you a scanned copy of the wiring diagram of your bike. You need to find your starter relay. There is a red wire that goes to it directly from the ignition switch. You need to check for voltage. Then there is another wire that comes from the start switch and a wire that goes to the backside of the starter. If you have a test light, find the single small green wire that plugs onto the backside of the starter. Put your test light into this wire, turn the ignition switch on, and press the start button. It should light the test light. If not, your problem is back up the line from there. If it does, your problem is in the starter. I've looked at the schematics and I can find no link between the headlight not working and starter not working. Have you checked the instrument lights and the tail light? Make sure you check the fuses using the test light. With the ignition switch on, they should have power on BOTH ends of the fuses.

Good Luck

Aug 22, 2011 | 2000 Harley Davidson XL Sportster 883

2 Answers

Alternator is not charging but the local parts store tested it and it is working fine, all fuses are good

what makes you think its not charging? alternators should always be checked ON THE CAR.

Aug 03, 2011 | 1999 Oldsmobile Alero

1 Answer

Grounded battery while car was running, suspect the engine comtrol module is fried. Sound right? If so, where's the ECM located on an 89 Wrangler?

It's likly you did alot of damage. First with a well charged and correctly installed battery it's best to cheal some other things first. The large fuses near the battery( fuseable links) need to be checked to see that their connected. Use a test light to test all of them. ( a test light is a tool that has a bulb in the handle of a tllt that lloks like a clear ice pick and has a wire coming out the end oif the handle. on the end of the wire is a clip to connect to ground ( the negative post on the battry) and as you touch the piont to the positive post of the battery ( or anythign powered) the light will light in the handle showing you that the power is getting to there) The test light should be as bright as the connection at the batery was or you have detrcted a poor connection if the light is'nt as bright as the battery was. Going though all the wires coming from the battery ( theirs alot) repair any that are dead. Then go to the fuse box and do the same thing. Use the test light as a blown fuse can (look ) good and be bad. on the tops of the fuses theirs a little bare place on the fuse and just touch the test light and if lights up on both sides it's good .. If it lights on one side it's bad it it does'nt light at all it may not be on. ( key on or lights on or key turned to crank may need to happen for somes fuses to light the test light) If one side of the fuse lights the light the other side sould light too. If all the fuses check good and the jeep cranks but does'nt run you still need to check it just like any no start car. If it does'nt crank fix that first. Once cranking see that it's got spark. ( plug a plug wire and connect it to a spare plug laying on the head and chank the engine to see if theirs spark. With spark them cheak to see if it'll run with added fuel. Remove the air inlet hose on the throttle body slose a little gas it their and put the hose back on and crank it and if it starts you know it'll runn if it was getting fuel. Cheaking for fuel pump operation is next and the fuse from the pump can be on the fire wall on the passenger side. get under the jeep and put your ear against the gas tank and listen as someone turns the key one and if you hear the fuel pump come on you can say the pump works if not you need to find the fuel pump fuse and the realy that turns the pump on as this short to powercan back feed and blw relays and fuses. Most of the time theingtion module can blown on a back feed and the computer can too but the fuse often protects the computer. The computer is the box ( small cerial box size on the firewall on the passenger side) This part has to be programmed to work so a used one is no help as an old computer can'nt be reprogrammed ( to pervent thief) so a new computer has to be bought and programmed to match your car ( this is best left to a professional shop) I've even had other professional shops come to me to do this work cause you only get one chance at it and the other things i just told you about are much more likly to happen then computer failure and if the computer did fail some of these other problems have happened too and they'll need to be found.. iF THE FUSEABLE LINKS HAVE BEEN REPAIRED OR REPLACED IN THE PAST THEY CAN CAUSE THE COMPUTER TO FAIL AS THEY MIGHT NOT BLOW AND BLOW THE COMPUTER INSTAED.

Jul 11, 2011 | 1989 Jeep Wrangler

1 Answer

2003 mustage will not start in park it will start in nutral / the break lights are not working

nutral park swich out of adustment or defective
brake light swith/ fuse/bulbs/wires to lights

Apr 02, 2011 | 2003 Ford Mustang

1 Answer

Citroen Picasso battery light stays on and lost some electrical functions of the car, i.e, rear window heater, indicators. Have had the alternator checked twice and came back fine. Could/would this be...

i valeted my 54 plate picasso, and left the windows open for a few hours.
went back to check and rear windows wo nt move, anyone which fuse might have blown as i do not have any manuals

Dec 28, 2010 | 2001 Renault Sportwagon

1 Answer

Wo nt come onmy son pressed the ac power button while i was installing a sky hd box and now it wo nt come on

Hi i haven't had this problem before but i can try to help but i cant guarantee it will work.

First of all i would try turning it off and unplugging it by the switch for 30 minutes making sure you remove the card.

Then i would turn it back on and try from there.

If it still doesnt work i would try changing the fuse and if still no luck you have no choice but to ring sky because your box might have blew something inside it.

Hope this helps :)

Carl Redding

Jul 05, 2010 | Televison & Video

2 Answers

Neutral light stays on when bike is in gear

i dont understand, the bike shouldent start in gear with the lever out it would jump forward when you hit the start button.. there is nothing wrong with the bike by what you say its just a neutral light, witch is a switch find the neutral indicator switch and replace it and your probelms will go away or test the one you have it should test 13ohms in neutral and OL in gear
let me know how you make out

May 16, 2010 | 1997 Honda CBR 900 RR Fireblade

1 Answer

Jeep Liberty Diesel will not turn over. Battery charged. Cannot get diagnostic codes from the computer.

try it in nutral put in park and hold up and or jigle up and down in park, dont come out of park jiggle while u hold to start,check large fuses anything marked starter check cables cable ground to engine ,check nutral safty switch check starter , and starter wire ing wire at starter with test light small wire on starter while someone trys to start jeep ground test light to a good ground and hold point on small wire on starter it should light up if it does your starter is bad ,if it doesnt light up check ignition switch on steering colum ,most likely bad

Jun 27, 2009 | 2006 Jeep Liberty

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Mike Gilbreath

Level 1 Expert

50 Answers


Level 3 Expert

77499 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides