Question about 2007 AMERICAN IronHorse Slammer

1 Answer

Motor surging in 3rd gear motor surges when normal operation under load it does not.

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • AMERICAN Master
  • 39,911 Answers

Hi Anonymous, and the usual suspects are:
1. Spark plugs in bad condition or partially fouled.
2. Spark plug cables in bad condition or leaking.
3. Spark plug gap too close or too wide.
4. Faulty ignition coil, module and or sensor.
5. Battery nearly discharged.
6. Damaged wire or loose connections at battery terminals especially the ground cable at BOTH ends ignition coil or plug between ignition sensor and module.
7. Intermittent short circuit due to damaged wire insulation.
8. Water or dirt in the fuel system, carburetor or filter.
9. Fuel tank vent system plugged or carburetor vent line closed off.
10. Carburetor controls misadjusted.
11. Damaged carburetor or intake seals.
12. Loose or dirty ignition module connector at crankcase.
13. Faulty MAP, CKP, and or CMP sensors.
14. Incorrect valve timing.
15. Weak or broken valve springs.
16. Damage intake or exhaust valve.
For more information about your issue, please visit the websites below. Good luck and have a nice day.
service manuals

Posted on Oct 12, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2006 Impala the engine is surging at idle and when I driving


Check the vacuum hoses for a leak.

2006 Chevy Impala LS 3.5L Surge Under Load - YouTube

? 3:09
www.youtube.com/watch?v=sD-swFhMORM
Jan 22, 2013 - Uploaded by Gary Castle, Jr
Surge while driving. ... 2006 Chevy Impala LS 3.5L Surge Under Load ... How To Fix Or Prevent Stalling, Surging Or Rough Idle, Cleaning ...

Oct 02, 2015 | Cars & Trucks

1 Answer

Why is it surging under load?


Yep - the carb needs to be removed and cleaned out thoroughly to remove the clogging responsible for the surging. Motor needs a smooth supply of gas - look at what your car does when you jerk around with the gas pedal. Also check the governor area of generator since that keeps motor running at a certain fixed speed. If there is something wrong with it, that will also cause the problemo.

Sep 08, 2015 | Generac XG8000E - 8000 Watt Electric Start...

1 Answer

TRANSMISSION


Fuse # 20 or 21 gets power through ignition. This fuse controls PRNDL indicator, speedometer, tach, & will cause transmission to not shift gears correctly. Ours took off in 3rd gear when put in Overdrive & only ran in 3rd gear. If we tried to manually shift thru gears (auto trans), it had 1st, 3rd, reverse. No 2nd or over drive. Replaced ignition. Fixed problem. Root problem was Electric motor that engaged 4 wheel low side was bad. Every time we used 4 Low side it threw power surge through ignition & blew ignition out. Good Luck.

Feb 06, 2014 | 1997 Chevrolet K1500

1 Answer

1998 gmc sonoma 2.2l intermittent engine surge


Make a gasket up from a coca cola can and block off the EGR valve and see what happens

Mar 27, 2013 | 1996 GMC Sonoma

1 Answer

The generator kicked the breaker of and was smoking and smelled like electrical


What type of load (electrical) was hooked up to this generation?? If the surge voltage and current was exceeded above the generator maximum for any length of time. There problems, it could be the regulator, insulation burnt off the windings.


I am taking a guess here. Now, 7100 Watts is it typical surge wattage. This mean that the generator will deliver 7100 Watt (voltage times current) this is know as the power factor. The actual operating load would be 6800 Watts and I would even operator the generator at its peak wattage. Something in the neighborhood of 10--15% less the peak wattage. Therefore a good positive theatrical Wattage would be 5800 to 6350 operating wattage. Then this generator would run all day.



Just remember Ohm's Law. Current plays a big factor in loading of a generator while the operation voltage is at 120 AC Volts. Example: electric motor; Now electric motor when starting will pull three time its operation current. Operating current for a 1/2 HP AC motor is 6 amperes but start this electric motor will require 18 amperes. This is one reason why they starting capacitors on smaller electric motors. Larger three phase electric motor can literal stop a generator cold...in its tracks. It put such a large demand on the generator it stops the engine powering the generator. I have seen crankshaft break because the generator could handle the heavy current load.



Remember, any time you are running a small gas powered generator. All ways figure what the load and surge current load will be before hooking up any generator. Normally this is figured in VA (volt/amps). Wish you lock. GB...stewbison

Sep 05, 2011 | Robin Subaru RGX7100 7100 Watt Gas...

1 Answer

Surges under load


A generator should normally surge under load.It is designed to do as a means of saving fuel while being able This increase energy supply when necessary.

Feb 13, 2011 | Electrical Supplies

2 Answers

S80 engine surge at idle


You could have a bad or contaminated Mass Air Flow (MAF) sensor. You can get a used one online for less then 100. You can also purchase a can of MAF sensor cleaner at a local auto supplies store and clean it. It located right at the air filter housing.

Aug 03, 2009 | 2000 Volvo S80

1 Answer

The rpm's in my 1995 escort wagon surge when shifting from 2nd to


It sounds like your clutch is slipping. Does it do it more when the wagon is loaded or going uphill?
Most likely needs a new clutch.

Jul 23, 2009 | 1995 Ford Escort

2 Answers

1988 ford ranger v6 4wh 5speed


it could be a valve. or it could be a worn camshaft and lifters.

Oct 20, 2008 | 1988 Ford Ranger

1 Answer

My surges as I go up a hill,in cruise. But not if I put it in 3rd gear. Whats wrong?


This sounds like it has a vacuum leak. The reason it doesn't happen in 3rd gear, the motor is turning faster.
Do any other vacuum controlled items stop working at the same time? Like change to the defroster, or from floor vent to dash vent.

Jul 22, 2008 | Buick LeSabre Cars & Trucks

Not finding what you are looking for?
2007 AMERICAN IronHorse Slammer Logo

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top AMERICAN Experts

David Payne
David Payne

Level 3 Expert

14161 Answers

Larry Maranto

Level 2 Expert

198 Answers

Tom Chichester

Level 3 Expert

33250 Answers

Are you an AMERICAN Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...