Question about Motorcycles

1 Answer

If engine number is known can we check the chassis number

After the accident the area where chassis number is written was burnt and had to be repainted now i cant get the chassis number though the engine number is known

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 103 Answers

A part of the engine number should be the pair of the chassis; maybe entire number.
Why don't you use a brush to clean the paint on the frame to be visible? If you don't the guys from tehnical inspection will do it.

Posted on Nov 25, 2013

Testimonial: "so the engine number can be re embossed on the chassis number to avoid the technical jargon"


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I am buying a used car, can I use the chassis number to check online that it hasn't been involved in an accident?

The VIN number will give you a idea if it was in a accident. However it is not full prof. If the vehicle was fixed by the owner it will not be in the system.

Feb 06, 2017 | Cars & Trucks

1 Answer

How to Check Cars for Accident Damage?

Look for consistent gaps on all the shut lines around doors, hood, tail. Good indicator of chassis warping.
Lift hood and look for small crumples or ripples on all chassis components, check the radiator lines up, look for pinched metal wheel arches.
Make sure car has no sheets of paper under engine to catch slow leaks of fluids or oil patches.
Look for new painted areas inside engine bay.
Grab hold of each wheel and shake all directions, there should be no clicking or loose movement.
Check car sits level after you have rocked car gently, bare in mind too much rolling after you stopped could indicate shock/suspension wear.
Try to push car while hand brake on, shouldn't move at all.
Look for messy repairs around lights and corners or vague lumps, this is common area for bumps and crumples.
Dented undersides and badly scraped oil pans.
When driving in straight line, feel for pulling to either side and lack of precise steering.
From cold start (if engine is warm it means it's been pre-warmed) and look for rough start and dark smoke from exhaust, car should stay running smoothly and not stumble.
Stand in front of car and sight it from a distance, looking at it from different angles and ask yourself "does the whole car look twisted ?"
Check for excessive wear on pedal rubbers, shifter knob and steering wheel, look also to see if steering wheel centers correctly.
Because some of these points may not mean an accident, it's just to train you to look at a car with some level of confidence and play detective, don't be afraid to ask if it has any crash damage too.
Point out any faults or suspicions and hear what they say....
Above your instincts..until proven otherwise.
Bon Voyage...

Oct 14, 2016 | Cars & Trucks

1 Answer

Turn signals not working

light bulb died? if not then

either blown fuse, cause by water entering in fuse box, or burnt out because of old age

or, somewhere in your car, a positive electrical wire has melted and is touching the ground (the chassis) of the car and is causing low voltage in your electrical system, which could damage components, check around areas that is hot, mufflers, engine bay

Apr 06, 2014 | Honda Pilot Cars & Trucks

3 Answers

Audi a4 engine number location

It will be on his V5 registration certificate below chassis number.
Its under the inlet manifold on a casting. AEB ***** etc

Also the sticker in front page of handbook and sticker under boot carpet

May 21, 2012 | 2000 Audi A4

2 Answers


dont you have a owners manual. its says the chassis no location. if you have vehicle registration book, it will be having chassis number written. Usually vehicles chassis plate are seen at driver door side or between glass and dashboard or behind the engine below wind shield. chassis number is written in chassis of vehicle too. pull up your vehicle using lift and check the right side of the chase and you will see chassis number marked. thanks

Jan 28, 2011 | 2004 Dodge Dakota

1 Answer

Nissan navara d22 chassi numbers

These numbers Engine and Chassis/VIN number should be written on the identification plate. This plate is located on the inside of the engine bay. It is attached up the rear of the engine bay, right hand side on the firewall. Just in front of the driver in a right hand drive vehicle, in front of the passenger on a l/h drive vehicle.

Jan 23, 2011 | 1997 Nissan Pickup

1 Answer

When car is started the radio brings engine noise and revs through it

Hello! The 1994 and later model Grand Am's are well known for radio interference...Technical Service Bulletins (TSB) have been written by GM without solution...If you have a multimeter...set it on the X1 ohm scale...Place one meter probe on the center of the negative battery cable and the other on bare metal of the chassis (a fender bolt)...Must read zero ohms...Move probe from chassis to engine block...Must read zero ohms...If you do not obtain readings close to zero ohms, run 8 gauge wire from negative battery post to bare metal on the firewall or body bolt...Also run a 8 gauge wire from chassis to bare metal on the engine block...If this does not correct the problem visit any audio shop and purchase a noise filter...Instructions are included...Guru...saailer

Dec 26, 2010 | 1994 Pontiac Grand Am

1 Answer

1988 GMC 2500 5.7 automatic- I replaced starter and accidently hit the positive cable on the exhaust pipe (WoW--Sparkey!!) Where are the fuses for the starter?

their isnt one ,it handles 200 amps ,check the connections on the battery,and yes it does spark well also check the earth strap from engine to chassis in case you burnt it out.LESSON ONE always disconnect the battery before doing and work of this nature on the vehicle ,but we have all done it try it with a truck with 24v and two monster batteries

Aug 27, 2010 | 1988 GMC C1500

1 Answer

Beko 32inch L C D model no 32WLK53OHID I NEED POWER SUPPLY PIN OUTS (wich line to wich part and voltage of each line ) from power supply


I have problems locating the chassis number correspondent to this model number. I will need chassis number to locate service manual.
Please double check the model number and check if there is chassis written on service tag.

Here manuals for different Beko chassis.

See also here.

Jun 02, 2010 | Televison & Video

1 Answer

Burnt out renaut t reg scenic

Are you sure it was your wife's car that was found burnt out at the scene? The thieves could have driven a lookalike car to the scene minus the number plates, broke into and stole yours after setting the other car alight. Check the chassis and engine numbers of the burnt out wreck and compare them with the numbers listed in your Vehicle Registration Document

Jun 11, 2009 | 2000 Renault Sportwagon

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers


Level 3 Expert

76846 Answers


Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides