Question about 2009 Honda CBR600RR

1 Answer

Bike not reving out and Check engine light stays on honda 600rr 2009 no

Engine revs sometimes but the check engine light is always on FI lights does not light up. NothIng to give a code. What is wrong with my bike?

Posted by on

  • Brian Scott
    Brian Scott Nov 22, 2013

    Check the starter to see if it needs new brush if not check main bearings. It solved a problem when bike would not start when engine was hot but would when cool or cold

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 173 Answers

Hello... Here is something that might work for you. First jumper the DLC red connector under the seat. Jumper the green and brown wires so that It can get the check engine light to blink and give you the codes. As you watch the light you will notice a pattern, something like... Three blinks for 3 followed by Two blinks for 2. Making the code 32. Right down all of your codes and then do a search for them over the internet. This should put you in the ballpark of what may be your problem.

Good Luck

Posted on Nov 22, 2013

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: i need 2 know how much engine oil i need for my honda cr125.

If it doesn't have a dipstick or a sight glass window on the kick starter side you will find a srew / bolt on the case usually lower front right near the rear foot brake unsrew that then put your oil in the filler hole when oil comes out of the hole you took the screw/bolt out of you are full I have an 01 and thats the way it is or 650cm of oil

Posted on Apr 21, 2009

  • 139 Answers

SOURCE: 02 cbr 600 f4i, red fi light flashes and bike

you have a fi fault revmove the seat cowl on the left hand sise you will see the cdi unit (black box with wires going to it) you should see a black conector with two wires going to it bridge the wires with a pice of wire or split pin turn the igntion switch on and count the blinks one long one means ten recored the the blinks and phone a dealer and ask them for the fault code.to reset the the light pull out the bridge and the light should stay on or blink repeted turn off the switch make sure the kill switch is set to run hope this helps

Posted on Oct 29, 2009

  • 1 Answer

SOURCE: Honda CBR 600RR 04 electrical problem

Does anyone no what problem i have?
I`v got a honda cbr 6 rr 05,tiptop condition starts everytime, runs really well. but when i turn off the engine. " like for filling up or just for 5min" It wont start or reluctant to start first time, but 2hrs later starts perfectly again!
can any one solve this problem please.
thanks. justin

Posted on Mar 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine idle revs high when in park or nuetrol. When driving ckek engine light is on off intermittinlly, a loss of power.


Always check for trouble codes when the check engine light turns on during engine running. After repairs are made, a scanner can be used to erase the codes.

It sounds like a fuel problem, so you would need to have the fuel pressure tested. This will verify the fuel pump and fuel filter are not the problem if the pressure is correct.

Sep 15, 2015 | Cars & Trucks

1 Answer

Vfr 800 fi


Hi pakie
the Fi light is fuel injection or ignition fault check fuse to ecu or engine stop relay and stop switch. Poss fault on angle sensor although unusual. If the light is flashing its a case of counting flashes to get fault code worse case is ECU fault

May 17, 2014 | 2000 Honda VFR 800

1 Answer

89 Yamaha virago 750 while riding lights go dim and engine cuts out unless bike is revved up then engine runs and light come back (sometimes) what's the problem?


You have a charging fault, it sounds like 1 phase of your alternator is down , so giving a low charge rate check in this order.
alternator winding resistance at the plug/ skt into the regulator and,or reg/ rectifier unit
the plugs clean and connections good.
next the out put voltage which should be about 13-14 volts just above idle, lights off, rev engine up to 2-3 thousand revs voltage should be 14.5volts,turn on the lights voltage should not drop to under 13 volts with the engine above 2k rpm.
low charging rates are normally down to alternator and wiring issues not the regulator which if faulty wil give no out put , so no chage at all

Jan 14, 2014 | Motorcycles

3 Answers

I have a 2003 Mazda protege 5. check engine light no codes


Remove the wire from the negative terminal on the battery and wait a few minutes, then reconnect the wire. This will "reset" the computer and remove the check engine light. If the light comes back on, take it to a Mazda service center and let them read the code. They will be able to tell you what is wrong. Pepboys, Autozone....arent always the smartest cookies and are wrong more than they are right.

Mar 24, 2010 | 2003 Mazda Protege

1 Answer

2005 Sportster 1200 Custom - Engine Light comes on randomly.


dont know if your injected or not geussing you are sounds like an o2 sensor

Aug 16, 2009 | Harley Davidson Harley-Davidson Motorcycle...

2 Answers

Moto Guzzi California Titanium Vibrations at speed.


It could be any number of things, from wheel bearings to clutch to out-of-balance engine.
All Guzzi's shake to some extent, at least until you reach 1500rpm or so... but I would hesitate to give you a specific reason.
Has the bike been checked by a Guzzi shop? It may be that the two cylinders are 'out' and the FI needs a reset.

Jun 29, 2009 | 2002 Harley Davidson FXDL Dyna Low Rider

1 Answer

Bike cutting off and FI light and check engine came on and off


that is the code for when a bike is laid down .... auto shut off sensor ...... as soon as u turn key off and back on it should be good to go again. ....

Jun 24, 2009 | 2007 Suzuki GSX-R 750

2 Answers

F1 error


It sounds like the tilt cut off may be to blame. If you put the bike into self diagnosis mode it will give you a code. This code can be checked and the offending sensor replaced. The tilt sensor in the tail piece is one sensor that turns the fuel pump off and so stops the engine.

Jan 22, 2009 | 2006 Suzuki GSX-R 750

3 Answers

2005 Triumph Daytona 955i Dead Battery and Check engine Light


I have just found my 30 amp fuse blown on my daytona , this prevents the alternator working , it was reading 10.9v before I changed the 30 amp fuse , now it reads 14.5 volts , I think I blew it as I didnt know how to put the alarn into service mode and left the ignition on , anyway I am hoping its just that , 3 heat up/cool down cycles and the engine management light should go out

mike

Dec 24, 2008 | 2005 Triumph Daytona 955i

Not finding what you are looking for?
2009 Honda CBR600RR Logo

156 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75824 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...