Harley Davidson starter replace diagram to remove starter

SOURCE: Wiring diagram for the Harley Davidson 2007 FXDB

If you are gonna work on your own Harley, shell out the $60.00 for an H-D manual. They have a basic wiring diagram inside.

SOURCE: removing harley davidson ultra classic gas tank

Drain the fuel either by siphening or removing the cross over tube at the front of the tank and letting it drain that way or just block off those cross over lines and leave the fule in the tank for removal.

0) remove seat
1) drain fuel
2) undo cross over line (bottom front of gas tank.
3) shut off pet **** and remove fuel line from pet ****.
4)there should only be 2 bolts holding the tank on, one at the top front of the tank and one at the back of the tank.

All in all a pretty easy (but possibloy messy) job.

SOURCE: assy of starter clutch on 2003 Harley Davidson

The starter on a late model Harley is a typical Nippondenso gear reduction type starter. They are all basically the same except for size.
To replace the starter clutch inside the starter assembly requires disassembly of the starter assembly.

I you will contact me directly, I will scan the procedure and drawings out of a service manual for you.

[email protected]

SOURCE: starter removal on 2004 ultra classic harley davidson

Disconnect battery , remove the outer primary case, pull back the lock tab on the starter jackshaft, unbolt the retainer screw, then remove the two starter bolts from the right side, sometimes you need to loosen the oil tank mounts to get at these, slip the starter and coupler out as a unit, replace the coupler and jackshaft the same way they came out when the new starter goes in, install bolts , retighten the jackshaft bolt and bend over the retainer, install and fill primary case, connect battery thats it buddy

SOURCE: how to remove a starter from a 1999 harley

its very straight forward.. Disconnect the battery and drain the chain case and open it ....... Then take the jack shaft bolt off. hold the gear with a pliers. After that - the starter just has 2 mounting bolts, Harley says to remove the rear exhaust but I havent had to. Disconnect the electrical and pull the starter straight out