Question about 1993 Suzuki GSX-R 750 WP

Open Question

1992 gsxr 750 remote start wiring install

I purchased a cheap alarm remote start for my 1992 gsxr 750. Alarm is hooked up & works but there are 3 wires to hookup for remote start please help.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: 90 gsxr 750 wont start, Exhaust seals?

the exhaust gaskets really should have nothing to do with whether your engine will not start. However I assume that by not starting it is turning over smoothly like it should when you try to start, having covered that most motors will not start because no fuel, no spark, or no air not withstanding some major mechanical failure in the valve train or timing or piston, cranks et al..
Trying checking for the obvious first fuel, spark, air flow. then go from there hope this helps

Posted on Feb 12, 2009

Ad
  • 1 Answer

SOURCE: 1996 Suzuki GSX-R 750 T

they will more than likely fit but doubt that it'll run smoothly

Posted on Apr 02, 2009

Nic61
  • 1073 Answers

SOURCE: please help, i need a haynes manual(or something

Hi!

No problem m8!

here is the Suzuki GSX1400 owners manual

and here is the Suzuki GSX1400 parts manual


Good luck!
Nic
DONT forget to RATE me

Posted on Apr 08, 2009

  • 2 Answers

SOURCE: stator wiring overhaeting

My 96 GSXR was doing this too. I found I had oil leaking into the stator case. This had "washed" the insulation off the windings (I think) causing it to short out. It shorts worst when it is hot. Now when I disconnect the generator while running it runs great. Reconnect, and a huge blue spark arcs across the plug. This causes a huge current flow at this plug (back and forth). I haven't gotten all my parts yet to try out my diag. Check under your stator cover, or just continuity test it in the bike (OHMs meter).

Posted on Jun 04, 2009

  • 55 Answers

SOURCE: stator wire melted 98 GSXR 750

I guess its the regulator/rectifier thats pushing too many volts down that wire. Try another unit after fixing the wire

Posted on Sep 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there another way to program a remote start remote, The way its suppose to work doesnt.:door open, ACC on, push valet then again and hold. I think the door is not hooked up to read open.


563T Your Valet Alarm W/Remote Car Starter - Dr.Detail

www.drdetailshop.com > MAIN > YOUR VALET
Featuring: Viper, Hornet, Directed Amps, Viper Audio, Compx Subs, Your Valet ... 563TYour Valet Alarm With Remote ... A Free Wiring diagram, Installation parts

Sep 24, 2015 | Televison & Video

1 Answer

ALARM INSTRALL WITHOUT REMOTE START


You need to install the power wire and the ignition wire on the alarm . Most alarms draw power from the thick power wire some have a small power wire and Small ignition wire input that needs to be hooked up also. Only ignition one needs to be hooked up.

May 04, 2014 | C3RS6652W

1 Answer

Remote start/ 09 Camry installation


what brand is alarm? hood pin IS required,ground hood pin lead try to remote start

Jan 18, 2013 | Brand Remote Start/keyless/car Alarm Very...

1 Answer

I bought a 1992 honda accord with an installed crimestopper alarm, i went to go to work just now and disarmed the car and now it wont start or turn over and i cannot even get the alarm to go on or off, how...


There are a couple things you can do. 1 is leave your key in the ON position (do not start) for EXACTLY 10 Minutes. Then try to start the car.
2. Disconnect the negative battery cable for 15 minutes, put back on and then try.
3. Pull the fuse on the alarm.
Find the alarm "brain" and disconnect it from the rest of the system. You'll probably need to rehook the starter wire to remove the relay that they would have included in the install.

The FIRST thing you should do is see if you have the "install guide" for the alarm. It should tell you what colours do what. MOST people put the "brains" close to the steering column. It may not even be mounted to anything, or may just be twistied to a wiring loom.

Jun 30, 2010 | On-Guard Alarm with Wireless Siren, Remote...

3 Answers

Spy 5000m remote start issues


You need to adjust the tachometer sensing wire, it usually wraps around a spark plug wire so I can sense when the car starts. On my spy alarm, the wire was grey. Hope this helps.

May 05, 2010 | Brand Remote Start/keyless/car Alarm Very...

2 Answers

Car alarm going off after replace positive cable


If you do not have the remote control for the alarm (which can sometimes be purchased on ebay) You will have to uninstall the alarm.
The alarm is wired between the ignition coil wire coming from the ignition switch if the car is turning over and just wont start.
This can be complicated because of the amount of wiring, You have to cut the alarm wires out 1 at a time and match the cars wires back together.
I just did this for someone on a toyota recently and you really have to pay attention or put a peice of tape on each wire writing the color for example(white wire with rd stripe or white wire with red stripe ect.)
I hope this helps you,
Please rate me if this was helpful,
ETRONIC

Mar 14, 2010 | 1994 Saab 9000

1 Answer

MarkX alarm


being you have alot of alarm fetures installed already, try a valet alarm, that alarm should help you out... and it will work with all your systems, if not that one then there is a 3 wire alarm that you can google search that you can install it is only an alarm, all the other features you have already installed would need their own key fobs.. but if you want to use one key fob, try the VALET alarm system cause most you can reprogram the fob to do the remote start, and connect it to the immobillizer no problem... but i would still take it to a shop that specializes in alarms cause if you do not know what you are doing, then you could lock up the starter, or not be able to start the car if you cross the wrong wires... but to answer the other question YES it is possible...

Jun 24, 2009 | Vehicle Parts & Accessories

1 Answer

I have a viper 5900 car alarm installed with remote start.


Look under dash for a small black box with wires coming out of it, about 2 or 3 inches rectangular.. there should be one or two screws on it. Look to see if it says which direction to turn for sensitivity. As far as not receiving, you need a new antenna, this is covered under warranty through DEI either bring back to where you purchased or look online and see where the closest dealer is to you...

Jan 28, 2009 | 5900 SST 2-Way Security System / Remote...

2 Answers

Info on Aftermarket Generations Alarm AGA1201


The first link takes you to a good cheap place to buy this particular Aftermarket Remote System
The second two links offer diagramming and installation information. Hope this helps.


http://cgi.ebay.com/NEW-AGA1201-FM-Car-Alarm-Remote-Start-Keyless-Entry_W0QQitemZ230313882162QQcmdZViewItemQQptZCar_Alarms_Security?_trksid=p3286.m20.l1116



icon_bins.gif www.the12volt.com/ · Cached · Save Free vehicle wiring diagrams and technical information for car stereo, car alarm, electronics installers. Ohm's law, resistors, passive crossovers, subwoofer boxes, ... Free Vehicle Wiring, Relay Diagrams, ... ... icon_bins.gif www.vastbeyond.com/440.htm
Find Free Automotive Wiring Diagrams! ... Your Simple Source for Free Automotive Wiring Diagrams ... Free Automotive Wiring Diagrams.

Jan 07, 2009 | Chevrolet Cavalier Cars & Trucks

1 Answer

Viper remote starter sets off alarm.


Whoever hooked up your system did not hook up the factory alarm disarm and arm wires. Your car thinks it is being stolen as a result of this. You need to get a wire diagram of your car and hook up the proper wires.

Dec 12, 2007 | Viper (VGC421) Remote Control

Not finding what you are looking for?
1993 Suzuki GSX-R 750 WP Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...