Question about 2006 Harley Davidson FXDI Dyna Super Glide
Tank on roadking is leaking want to install tank from 1997 heritage classic
Posted by Anonymous on
Hi Anonymous, your talking two diferent frames two different engines, I'm only getting 2 out of 5 thumbs up from the Harley Gods.
There would have to be some type of fabrication for sure. Good luck
Posted on May 18, 2015
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: oil drain plug
It is located on the right side just under the oil tank ; if you follow the rudder hose that exits the rear right side of your oil tank it leads to the bottom of the frame under this is the oil plug. This hose has a plug clamped to the end of it or stuck into a prug that is welded to the frame.
After this unclamp and pull the plug to make sure that you have the dipstick out before pulling it loose.
Please do rate the solution as "FixYa" if found useful and revert for further assistance.
Posted on Mar 27, 2009
Drain the fuel either by siphening or removing the cross over tube at the front of the tank and letting it drain that way or just block off those cross over lines and leave the fule in the tank for removal.
0) remove seat
1) drain fuel
2) undo cross over line (bottom front of gas tank.
3) shut off pet **** and remove fuel line from pet ****.
4)there should only be 2 bolts holding the tank on, one at the top front of the tank and one at the back of the tank.
All in all a pretty easy (but possibloy messy) job.
Posted on Jun 06, 2009
Back of the seat remove the fender bolt..on both sides of the seat where your *** sits are two large torque bolts...You dont have to remove the tank Heritadge has fatbob tanks..remove the 1/2 inch nut holding down your speedometer raise it up and your wire will run through their. you have two seperate tanks their is space between them on the frame.
Posted on Jul 25, 2009
The oil drain us usually a hose with a plug in it that is held by a clip on the frame. It us usually on the right hand side of the bike just behind and underneath the transmission side cover. Loosen the clamp and pull the plug out. The oil will run out of the tank. Replace plug and add new oil to the tank.
Posted on Sep 24, 2009
The fork oil is a very specific job needing a manual and a special tool, I don't want to insult anyones mechanical knowledge but if you have never done it before, best to take somewhere else. Engine oil on the other hand is easy, the drain tube to any softail is on the right side by where the frame meets the swing arm, has somekind of plug in it. Start and run bike for a little while, long enough to get it warm but not hot. Remove fill plug and then remove plug in drain line. Using a peice of cardboard or something put in between filter and frame , directing the oil to your drain pan instead of where ever it goes. Put 1 qt oil back in (after everything is reinstalled) start the bike and make sure the oil light goes out, when it does shut bike off and fill to the point that when it is standing upright you get a little oil on the tip of your finger, over filling may result in loss of oil cap from pressure (been there)
Posted on Feb 16, 2010
Tips for a great answer:
Apr 04, 2017 | 2000 Harley Davidson FLSTC Heritage...
May 05, 2014 | 2000 Harley Davidson FLSTC Heritage...
Feb 17, 2014 | 2006 Harley Davidson FLSTCI Heritage...
Jan 30, 2014 | 2011 Harley Davidson FLSTC Heritage...
Nov 18, 2013 | 2003 Harley Davidson FLHTCUI Electra Glide...
Feb 02, 2013 | 2000 Harley Davidson FLSTC Heritage...
Jan 21, 2012 | Harley Davidson FLHRCI Road King Classic...
Sep 16, 2009 | 2005 Harley Davidson FLSTC - FLSTCI...
Jun 19, 2018 | Motorcycles
103 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: