Question about Yamaha Motorcycles

1 Answer

With engine running I turn the key to turn on lights & the engine dies

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 23 Answers

Try testing the ignition switch and see if power is at the light term. or a missing/broken wire.

Posted on Nov 19, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What makes a2005 Tucson, engine die and all warning lights come on?


Usually when the engine dies and the key is still in the run position all the lights will come on. Do they stay on when you turn off the key?

Aug 29, 2014 | 2005 Hyundai Tucson

1 Answer

Driving along lights dimmed, instrument panel died, loss of power then engine cut out & wouldn't start. Starts with a jump but when i turn key to heat glow plug, instrument panel goes mad


I assume there's a problem with alternator. Check the grounding to engine, check continuity of a positive wire between alternator and battery. the energizing voltage should be checked as well. Might be the bad connection between battery and vehicle body grounding. Diesel cars are sensitive even in a little loss of connection and rust in the connection points.

Feb 18, 2014 | Cars & Trucks

1 Answer

Starts and dies unless I rev it up then it will Idle


The battery might be low but I doubt it is causing the "no idle" problem.
You should have an idle air control valve that the computer uses to adjust idle speed. That valve could be faulty or dirty.
Is the check engine light on when the engine is running ?

Jul 19, 2012 | 2001 Dodge Durango

1 Answer

97 chrysler town & country dies while driving will only start when in park, runs fine but dies without warning and will restart in park???


Well first it should only restart in park or nuetral, any check engine light on? May be fuel pump if not. Listen for pump running in fuel tank. Should run at key on for a few seconds. If check engine light on, it should be scanned for codes, possible crank sensor

Aug 10, 2010 | 1997 Chrysler Town & Country

2 Answers

My Saturn has been sitting in my driveway for about a year and a half. We just replaced the battery and the fuel filter and when I try to start the car, the engine turns over, starts for a minute, and then...


If the gas in tank is that old you need to drain it. Once you have good new,clean fuel in tank. Turn key to run position,(do not energize starter just want red lights on dash to come on) listen for fuelpump whine. It will shut off. Turn key off.Turn key to run again, listen for fuelpump again. Turn off key again. Repeat this procedure total 5 times. On last time turn key to engage starter. It should build up enough pressure & fuel & start right up.

Jul 01, 2010 | 1999 Saturn SL

1 Answer

Car sputtered & died & now wont even turn over. Battery has 13volts. Gets engine light and red dot light, But no codes when I turn key from Acc. to on 3times!


the 3 key turns dosent work on 2004 chryslers.i think 2000 or 2001 they removed that function from all chrysler/jeep/dodge/plymouth products

Apr 04, 2010 | 2004 Chrysler PT Cruiser

1 Answer

CAR WON'T STAY RUNNING


when key on and engine off, does the security light flash constantly? if so its shutting down the fuel pump, it starts momentarily due to the computer priming the engine with fuel. how to reset, turn key to run position, leave it on touch nothing, takes 10-12 minutes, start watching light around 10 minutes. it will stop flashing... turn key off, then back on and start this will reset the security system. they are sensitive on this platform car it will happen again. good luck!

Sep 05, 2009 | 1999 Pontiac Grand Am GT

1 Answer

I can not find the neutral safety switch on a 2000 buick park ave


Any chance your vehicles have a security/alarm system. Disconnecting battery on some, will arm it sometimes & not allow it to run. Using key to unlock door, on driver & passenger side have been known to work on some vehicles, but if not, a call to dealer should help.

May 31, 2009 | 2000 Buick Park Avenue

1 Answer

Buick Regal dying


You have a problem in the fuel pump relay circuit for sure then. I'm betting the relay, but it could be that dropping resistor.

May 11, 2009 | 2000 Buick Regal

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...