Question about 2003 Harley Davidson FXDL Dyna Low Rider

1 Answer

HOW DO IN REPLACE STATOR - 2003 Harley Davidson FXDL Dyna Low Rider

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 24 Answers

Pull inner and outer primary covers off you engine main shaft is in the center of it. take out retainer bolts install and asssemble revurse of how you took it apart.

Posted on Jan 14, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I test the stator on a 2009 heritage softail


To check the STATOR. Turn ignition key switch OFF, then disconnect the voltage regulator connector from alternator stator wiring. THEN connect an ohmmeter set on the RX1 scale with one lead into either of the stator sockets and the other lead to a good ground. And test for continuity - a good stator will show no continuity (0 ohms) across either stator socket - any other reading indicates a grounded stator which must be replaced. THEN remove the ground lead and insert lead it into the other stator socket - the resistance (with ohmmeter still set on the RX1 scale)should be 0.1-0.2 ohms - if the resistance is lower a stator short is indicated. Which means that the stator is damaged and must be replaced. - if the resistance is higher (OL on meter), an open is indicated and again, the stator is damaged and must be replaced. You should check socket 1 to 2 then 1 to 3 then 2 to 3. (If you only had a two wire stator you would check between wires/sockets 1 and 2).
Before testing short out the ohmmeter leads against each other and if they do not produce a reading of0 ohms subtract the reading you do get from any readings you get doing the stator checks in order to get accurate stator circuit readings, otherwise you may have out of range reading due to the internal and/or lead resistance of the ohmmeter.

Oct 10, 2014 | 2009 Harley Davidson FLSTC Heritage...

1 Answer

How do I replace a stator on a 2002 1500 lc Suzuki intruder


Drain the engine oil. Remove the case on on the left side of the engine. The stator is inside the case. Be careful with the wires to the stator, be sure the routing is as the existing.

Sep 23, 2014 | 2004 Suzuki Intruder LC 1500

1 Answer

How do you check the stator on a motorcycle?


To check the STATOR. Turn ignition key switch OFF, then disconnect the voltage regulator connector from alternator stator wiring. THEN connect an ohmmeter set on the RX1 scale with one lead into either of the stator sockets and the other lead to a good ground. And test for continuity - a good stator will show no continuity (0 ohms) across either stator socket - any other reading indicates a grounded stator which must be replaced. THEN remove the ground lead and insert lead it into the other stator socket - the resistance (with ohmmeter still set on the RX1 scale) should be 0.1-0.2 ohms - if the resistance is lower a stator short is indicated. Which means that the stator is damaged and must be replaced. - if the resistance is higher (OL on meter), an open is indicated and again, the stator is damaged and must be replaced. You should check socket 1 to 2 then 1 to 3 then 2 to 3. ( If you have a two wire stator you would check 1 to 2)


Before testing short out the ohmmeter leads against each other and if they do not produce a reading of 0 ohms subtract the reading you do get from any readings you get doing the stator checks in order to get accurate stator circuit readings, otherwise you may have out of range reading due to the internal and/or lead resistance of the ohmmeter.

Sep 04, 2014 | 2002 Harley Davidson FXDL Dyna Low Rider

1 Answer

How do i check the stator on a 2000 fat boy Harley Davidson


To check the 2000 FLSTF STATOR. Turn ignition key switch OFF, then disconnect the voltage regulator connector from alternator stator wiring. THEN connect an ohmmeter set on the RX1 scale with one lead into either of the stator sockets and the other lead to a good ground. And test for continuity - a good stator will show no continuity (0 ohms) across either stator socket - any other reading indicates a grounded stator which must be replaced. THEN remove the ground lead and insert lead it into the other stator socket - the resistance (with ohmmeter still set on the RX1 scale) should be 0.1-0.2 ohms - if the resistance is lower a stator short is indicated. Which means that the stator is damaged and must be replaced. - if the resistance is higher (OL on meter), an open is indicated and again, the stator is damaged and must be replaced.

Jun 30, 2014 | Harley Davidson FLSTF Fat boy Motorcycles

1 Answer

How to check stator on 2007 fx


To check the STATOR. Turn ignition key switch OFF, then disconnect the voltage regulator connector from alternator stator wiring. THEN connect an ohmmeter set on the RX1 scale with one lead into either of the stator sockets and the other lead to a good ground. And test for continuity - a good stator will show no continuity (0 ohms) across either stator socket - any other reading indicates a grounded stator which must be replaced. THEN remove the ground lead and insert lead it into the other stator socket - the resistance (with ohmmeter still set on the RX1 scale)should be 0.1-0.2 ohms - if the resistance is lower a stator short is indicated. Which means that the stator is damaged and must be replaced. - if the resistance is higher (OL on meter), an open is indicated and again, the stator is damaged and must be replaced. You should check socket 1 to 2 then 1 to 3 then 2 to 3.
Before testing short out the ohmmeter leads against each other and if they do not produce a reading of0 ohms subtract the reading you do get from any readings you get doing the stator checks in order to get accurate stator circuit readings, otherwise you may have out of range reading due to the internal and/or lead resistance of the ohmmeter.

May 20, 2014 | 2005 Harley Davidson XL 883R Sportster

1 Answer

Stator test on harley


To check the STATOR. Turn ignition key switch OFF, then disconnect the voltage regulator connector from alternator stator wiring. THEN connect an ohmmeter set on the RX1 scale with one lead into either of the stator sockets and the other lead to a good ground. And test for continuity - a good stator will show no continuity (0 ohms) across either stator socket - any other reading indicates a grounded stator which must be replaced. THEN remove the ground lead and insert lead it into the other stator socket - the resistance (with ohmmeter still set on the RX1 scale)should be 0.1-0.2 ohms - if the resistance is lower a stator short is indicated. Which means that the stator is damaged and must be replaced. - if the resistance is higher (OL on meter), an open is indicated and again, the stator is damaged and must be replaced. You should check socket 1 to 2 then 1 to 3 then 2 to 3. (If you only had a two wire stator you would check between wires/sockets 1 and 2).
Before testing short out the ohmmeter leads against each other and if they do not produce a reading of0 ohms subtract the reading you do get from any readings you get doing the stator checks in order to get accurate stator circuit readings, otherwise you may have out of range reading due to the internal and/or lead resistance of the ohmmeter.


You can also do an AC output test:
AC Output Check
Disconnect the voltage regulator connector from the alternator stator wiring and then connect an AC voltmeter across both stator sockets of a two wire stator, or if a three wire stator across two of the three for example 1 & 3 and then later you will repeat the test between 2 & 3 and later between 1 & 2. THEN run the engine at as close as possible in the circumstances to 2000 RPM. The AC output should be approximately 32-40 VAC, approximately 16-20VAC per 1000 RPM. If you have done a stator static test and the stator has proven to be in good mechanical condition and the AC output is below specifications, the charging problem is going to be a faulty rotor. If you have not done a static stator check yet and the AC output is less than as set out above it may be that the stator is defective and the static stator check will need to be done. While the regulator has nothing whatsoever to do with the alternator output, if the alternator output is good the regulator might be defective in either rectification or in limiting the output to the battery to under 15 VDC. If AC output is low and the stator has passed the static stator check then it is likely that the permanent magnets in the alternator rotor are weak. A permanent magnet can lose its magnetic strength if it is dropped or shocked such as letting it snap into place when being installed or possibly by use of an impact wrench to remove the compensator fastener etc.

May 04, 2014 | Harley Davidson FLSTC Heritage Softail...

1 Answer

How to check stater on 1992 honda shadow


Locate the wire harness coming out of the stator on the left crank case cover of the motor and follow it to the plug with three yellow wires. This is the stator plug. You should have continuity between any combination of the three yellow wires, but no continuity between any of the yellow wires and ground. If the stator yellow wires are grounding you will have to replace the stator. To replace the stator remove the left crank case cover and unbolt the stator from the inside of the cover. Do not forget to purchase a new left cover gasket with the new stator or you will just delay your riding.

May 06, 2011 | 1992 Honda VT 600 C Shadow

1 Answer

I have a electrical dead short somewhere on the bike. It is a 2001 1200 Sportster. I have replaced the voltage regulator and the ignition switch. I have searched the wire connections around the fuse box,...


Yes it is possible the alternator/stator is shorted. I'm not all that familliar with sportster electrical systems but here is the short circut test for a dyna. it should at the very least tell you if the stator is shorted.

Stator Check

1. Turn ignition key switch OFF.

2. See Figure 1-18. Connect an ohmmeter.

a. Disconnect voltage regulator connector from alternator

stator wiring.

b. Insert one ohmmeter lead into either stator socket.

c. Attach the other lead to a suitable ground.

3. Test for continuity with ohmmeter set on the RX1 scale.

a. A good stator will show no continuity (? ohms)

across either stator socket.

b. Any other reading indicates a grounded stator which

must be replaced.

4. See Figure 1-19. Remove ground lead. Insert lead into

the remaining stator socket.

5. Test for resistance with ohmmeter set on the RX1 scale.

a. Resistance across the stator sockets should be 0.1-

0.2 ohms.

b. If the resistance is lower, a short is indicated. The

stator is damaged and must be replaced.

c. If resistance is higher (OL on meter), an open is
indicated. Stator is damaged and must be replaced

Now I will not swear that the resistance numbers are correct for your sporty but I would think that the same applies, less resistance means a short.

Apr 08, 2011 | 2001 Harley Davidson XL 1200 C Sportster...

2 Answers

What do i need to remove,and how to replace a stator on a 1996 v7


The stator comes off with the right front side cover If I recall correctly. All you need is a set of metric wrenches.

Can I get a “very helpful” rating on this answer?
358db0c.gif

Aug 28, 2009 | 1996 kawasaki VN 750 Vulcan

Not finding what you are looking for?
2003 Harley Davidson FXDL Dyna Low Rider Logo

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gills Lango

Level 2 Expert

195 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...