SOURCE: Truck wont start just clicks.
either a bad body ground,or your tranny is locked up,did it run good before you shut it off?
SOURCE: 1994 FORD RANGER STANDARD TRANS CLUTCH WON'T ENGAGE
The only adjustment you'll probably need is to get the air out of the clutch line. Loosen the bleeder screw, and put a two or three foot vacuum line on it. Submerse the other end of the line in a bottle of brake fluid. Pump the clutch untill no more bubbles are coming out of the hose into the bottle. Be sure to keep the reservoir topped up while you do this. Hold the clutch down, and tighten the bleeder screw. Some hydraulic clutches do have an adjustment on the rod that goes from the slave cyllinder to the pressure plate. I'm not sure about yours. If there is a nut on the rod, you can adjust it somewhat. You want it set so that there is just a little bit of play between the rod and the pressure plate where the rod goes. If none of this helps, you mayneed to replace the slave cyllinder.
SOURCE: My 1994 ford rangers clutch pedal just lost all pedal
There are two types of clutch actuators. (Mechanical & Hydtraulic)
A. For mechanical type,- Check the clutch cable as
this could be cut from wear and tear. This is easy
to replace. You can find this connected to the
pedal and the clutch lever near the transmission.
B.For hydraulic operated - Check the level of the
hydraulic oil at the cylinder of the hydraulic
actuator under the hood. This actuator is
directly connected to the pushrod driven by the
pedal. If the actuator is leaking, you have buy
a repair kit (Hyraulic clutch repair kit for Ford
Ranger 1994 MOdel.) These items must be
repaired to activate your pedal.
92 views
Usually answered in minutes!
×