Kindly help replacing me canon np 6050 copier toner.
Shake your toner jug well, on the the top right side of the copier is where the toner empties into a toner hopper. The cover lifts from the right and pivots open to the left. The cap on the toner jug is square the one side has 2 points on each end that stick out, that side angles in toward the left until it seats flat, then on the right under the toner is a door that slides out to the right, then there is a second door on the toner jug that pulls out to the right also. Just lightly tap on the sides of the jug until it empties. then push the door on the jug back to the left then do the same with the door on the toner hopper you may hsve to press very hard to get the jug to release.
Good luck and let me know.
Bob
I'm sorry, if I'd have known you had light copies, I would have told you that adding toner to a Canon copier wouldn't fix that. Anyway, if the optics are dirty you the copier compensates by making copies lighter. Turn your machine off and open the document feeder like you were going to lay an original on the glass to make a copy , then turn the copier back on. The copier will go thru a warm-up rotation just before it comes ready the lamp under the glass will light and you'll be able to seethe mirrors under the glass. If you see dust all over the bottom of the glass and the mirrors, they need to be cleaned. To be on the safe side unplug the copier, you can get zapped by the lamp circuit. Only clean the glass and the first three mirrors, the one under the lamp and the two that follow it with a soft lint free rag, like an old bed sheet and see how that works. To remove the glass remove the two screws in the plate on the rightthen lift the glass and slide it to the right.
Good luck and let me know if this helped.
Thanks
Bob
×
167 views
Usually answered in minutes!
thanx bob .. it really helped.. i managed to fill the toner powder... but i dont know still i m getting light copies.. can u please help me out this alsoo..
thanx again.
×