Question about kawasaki Motorcycles

Open Question

Rev counter go down kawasaki gpz 600 r - kawasaki Motorcycles

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: kawasaki gpz 1000 rx 1987 model

Running well at high revs would indicate that all the fuel and air it needs are getting to the engine and you also have a good spark. Probably no problem with air and fuel filter ( if fitted) or sparkplugs.

Running hot, and bad idling are signs of a lean air fuel mixture. The engine is probably not getting enough fuel at low revs.

This could be caused by an air leak between the carburettors and the engine. Check that the vacuum line to the fuel tap is properly secured at both ends. It is behind the fuel line at the tap.

Get a a short length of hollow plastic tube and use it like a stethascope - put one end to your ear and move the other end around your carburettor mounts with your engine revs as low as you can get, and listen for any sucking noises that would indicate a leak. Look for cracks in the rubber inlets.

The other possibility is that there is an internal blockage in the idling jets or idling fuel circuit. This is where dirt tends to lodge because the jet dimensions and passageways are very fine - The high speed jets are much bigger and dirt often just passes straight through.

Try a little bit of choke while the engine is warm to see if you get a stronger low speed response. If so that would point to an internal blockage.

Posted on Mar 21, 2009

Ad
  • 3567 Answers

SOURCE: i need igniter of kawasaki gpz 400r type

Google " motorcycle salvage Kawasaki " You can probably fine it there.

Posted on May 08, 2009

  • 18 Answers

SOURCE: looking for a manual for the kawasaki GPZ 600 can

Here's what you've been looking for ;)
http://www.megaupload.com/?d=AP826IOZ

Posted on Jun 16, 2009

  • 18 Answers

SOURCE: my rev counter does not work on my kawasaki er5 1999

The ER5 has got an electronic rev-counter, no cable.

Like the oval rear brake-drums this is another ER5 bugbear, the rec/rec fails, the battery boils and the rev-counter is usually a victim too.
Often on ER5 specific forums there will be someone who repairs the circuit board and sells the repaired units much cheaper than a new one. it's usually a tiny zener-diode that is killed.

Posted on Jun 17, 2009

ckoira57
  • 267 Answers

SOURCE: how do you reset timing chain on kawasaki gpz 750

http://www.pdfqueen.com/pdf/ka/kawasaki-gpz-750-r-service-manual/5/

Plenty of info available on the above.

member.tripod.com/gpz_rider/technical/FAQ2000.htm

This is a members forum's description of resetting timing chain, but I had trouble with pop-ups (I have them blocked)
Cheers.

Posted on May 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need the pin to pin wiring schematics for this model of motorcycle?


    More images for 1990 Kawasaki 650R wiring schematic

    Kawasaki Motorcycle Wiring Diagrams - ClassicCycles.org

    www.classiccycles.org/1852/597943.html
    Kawasaki Motorcycle Electrical Wiring Diagram Schematics. ... Kawasaki GPZ600 GPZ 600 Electrical Wiring Harness Diagram Schematic 1988 to 1990 HERE ...Kawasaki KZ650 Z650 KZ Z 650 B Electrical Wiring Harness Diagram Schematic ...

    Owner Center - Kawasaki

Jan 21, 2016 | Motorcycles

Tip

Gpz 1000rx Engine dies on pull away.


my gpz 1000rx 1986 would start and rev fine but die on pull away, for weeks tried allsorts (carbs cleaned, plugs changed etc) Solution for me was WD40 the sidestand switch and tighten earth lead from battery where it bolts to engine block, now its fine. Hope this helps WAZZA

on Oct 22, 2013 | 1986 kawasaki GPz 1000 RX

1 Answer

Had a problem with one cylinder flooding and


jets sound like they are worn blocked or similar. you might have to clean it all again or try fuch's pro fst to clean them up. have you vacuum balanced them?

Jan 31, 2010 | 1987 kawasaki GPZ 500 S - GPX 500 R

1 Answer

Engine surging/hunting on a 1996 GPZ 500 between 5 and 6 thousand revs. OK up to and beyond that rev range. Help please!


check carbs and throttle, clean float chamber. Jets are factory fixed so try second hand carbs rather than mess with these

Jul 14, 2009 | 2004 kawasaki GPZ 500 S - GPX 500 R

2 Answers

I have a 2000 (W reg) GPZ500S which has not run through the winter. The battery lost all of it's charge and the bike needed bump starting. On it's first ride out i noticed that the rev counter needle was...


i would get your battery tested sounds like low voltage it should test 12.7 volts if it is good. batterys usually dont survive after being dead for any lenght of time.

Apr 01, 2009 | 2000 kawasaki GPZ 500 S - GPX 500 R

1 Answer

Speedo Problem


check the connections for the tach and spedo the mileometer is tied in wit the spedo and the tach should have some connection wit the coil

Nov 12, 2008 | 1994 kawasaki ZZR 600

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...