Question about 2007 Johnny Pag Spyder 300

1 Answer

Will not start, lights come on, signals work, etc.....

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 103 Answers

You hear some click from starter relay or any other sound when trying to start?
Have you checked the battery voltage?
This problem how happened? Next day or after a long time when motorcycle was unused?

Posted on Oct 20, 2013

Testimonial: "The starter button sounds like its trying to start, it's just not cranking. It happened after a long time when motocycle was unused (2 months)."

  • Derick
    Derick Oct 20, 2013

    The starter button sounds like its trying to start, it's just not cranking. It happened after a long time when motocycle was unused (2 months)."

  • Joita Constantin
    Joita Constantin Oct 21, 2013

    So you hear some click from the bike? If the bike was unused a few months then try to give her some power with a proper wires from a car. Connect the positive and negative leads from bike's battery to car's battery with some strong cables and then try to start. If doesn't work try starting the car with the cables on and keep the car one or two minutes at 1500-2000 rpm to allow charging a little the bike's battery. After that it should work if battery was the issue. Even a good battery will drain a little after a while if is unused.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1985 yahamah vmax 700 turn signals, brake light tempt gauge and tact stop working


remove headlight and check all connections and wires coming out of it and pass round the frame etc ! P....

Nov 25, 2013 | Motorcycles

1 Answer

No Signal


check the settings carefully

Aug 22, 2012 | E-Machines eMachines Desktop PC

1 Answer

Rear brake lights and turning signals not working. One tail light has been out for very long time, but brake lights and signals just stopped working few weeks ago.


I'm checking into that same problem for a early 90's buick ( it's a GM also ) , I've checked the obvious ( bulbs, flasher,fuses,etc) all where fine. I assume your front turn signals work if you manually operate the turn signal switch or put on the hazard switch? The Buick's rear lights won't come on even with the hazard switch on. When you say one tail light has been out for some time, do you mean the brake/signal light or park/running lights? The Buick was like that with one side out for a while ( brake/signal light) but both the rear park/running lights work. Now, I've narrowed the problem down to the turn signal switch. I'd bet money on it. I just have to dig out my steering wheel puller, bite the bullet and get 'er done. You should be carefull if you're attempting that repair yourself ( AIRBAG ), use a manual. ( You could do a quick test by trying the turn signal while you pull the bottom of the arm toward you,move some of the wiring in the column near the arm,etc. I did and the signals started working. Could be the switch,dirt or a broken/loose wire. there's a lot of wiring going through the column and a lot of movement ( turn signal,high beam,cruise, then add tilt) Hope this helped.

Sep 20, 2011 | 2001 Chevrolet Cavalier

2 Answers

Left turn signal comes on when I turn the ignition then doesn't work


I am having the same issue on a 2005 FLHRCI Road King Classic. Basically the left turn signal comes on when I start the engine. It will not cancel by pushing the left turn signal button. However, if I push the right turn signal button the left will go off and the right will start blinking. Sometimes, this same action starts all four signals blinking (like the emergency flashers). It is very erratic. I have Kuryakan pancea rear taillights and brake light. The brake light went out so I went a bought a new brake/taillight with a new adapter. Brake lights work now but the blinker problems happens whether the back lights are connected or not. Front turn signals are stock.

Any help would be greatly appreciated.

Jul 11, 2010 | 2004 Harley Davidson FLHRS - FLHRSI Road...

1 Answer

Lights, turn signals, horn don't work


Look for a bad ground connection inside the headlight shell (or possibly elsewhere). The other thing that all of the items you mention that are working intermittently have in common is the ignition switch. With the switch 'on', check for battery voltage at the fuses for the headlight, turn signals, horn, etc. No voltage at the fuses likely means a bad ignition switch.

Nov 05, 2009 | 2000 Harley Davidson FLSTC Heritage...

1 Answer

Yamaha vino 50 cc scooter


hello, check to see if it is a switch (pull hand brake back when starting

Sep 05, 2008 | Sport & Outdoor - Others

1 Answer

Turn signals and flashers


Hello I had the same problem on my 04 monte. After changing bulbs ,checking wires etc. I finally took it to the dealer and they found out it was the hazard switch. After swapping it with a new one all lights, dash etc started working again and have not had another problem

Aug 17, 2008 | 2004 Chevrolet Monte Carlo

2 Answers

Turn signal wont work 1999 cadillac eldorado E.T.C


start with a fuse, then go on to a turn signal relay. turn the level left or right on the steering column with the inginition switch on, if the light in the dash lights up but won't flash, it is the turn signal relay.

Aug 10, 2008 | 1999 Cadillac Eldorado

Not finding what you are looking for?
2007 Johnny Pag Spyder 300 Logo

121 people viewed this question

Ask a Question

Usually answered in minutes!

Top Johnny Experts

Timllfixit

Level 3 Expert

2210 Answers

David Payne
David Payne

Level 3 Expert

14161 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Are you a Johnny Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...